Home About us Contact | |||
Water Act (water + act)
Kinds of Water Act Selected AbstractsEvaluation of water quality using acceptance sampling by variablesENVIRONMETRICS, Issue 4 2003Eric P. Smith Abstract Under section 303(d) of the Clean Water Act, states must identify water segments where loads of pollutants are violating numeric water quality standards. Consequences of misidentification are quite important. A decision that water quality is impaired initiates the total maximum daily load or TMDL planning requirement. Falsely concluding that a water segment is impaired results in unnecessary TMDL planning and pollution control implementation costs. On the other hand, falsely concluding that a segment is not impaired may pose a risk to human health or to the services of the aquatic environment. Because of the consequences, a method is desired that minimizes or controls the error rates. The most commonly applied approach is to use the Environmental Protection Agency (EPA)'s raw score approach in which a stream segment is listed as impaired when greater than 10 per cent of the measurements of water quality conditions exceed a numeric criteria. An alternative to the EPA approach is the binomial test that the proportion exceeding the standard is 0.10 or less. This approach uses the number of samples exceeding the criteria as a test statistic along with the binomial distribution for evaluation and estimation of error rates. Both approaches treat measurements as binary; the values either exceed or do not exceed the standard. An alternative approach is to use the actual numerical values to evaluate standard. This method is referred to as variables acceptance sampling in quality control literature. The methods are compared on the basis of error rates. If certain assumptions are met then the variables acceptance method is superior in the sense that the variables acceptance method requires smaller sample sizes to achieve the same error rates as the raw score method or the binomial method. Issues associated with potential problems with environmental measurements and adjustments for their effects are discussed. Copyright © 2003 John Wiley & Sons, Ltd. [source] Regulation of Injected Ground Water TracersGROUND WATER, Issue 4 2000Skelly A. Holmbeck-Pelham Ground water tracer tests are routinely performed to estimate aquifer flow and transport properties, including the determination of well capture zones, hydrogeologic parameters, and contaminant travel times. Investigators may be unaware of tracer test reporting requirements and may fail to notify their regulatory agency prior to conducting tracer tests. The injection of tracers falls under the jurisdiction of the federal Underground Injection Control (UIC) program, which regulates the introduction of substances into underground sources of drinking water as part of the Safe Drinking Water Act. The UIC program is administered by the U.S. Environmental Protection Agency (EPA) and by states with EPA-approved programs. The federal UIC program requires that tracer tests must not endanger underground sources of drinking water, and all tracer tests must be reported prior to injection. We contacted the UIC program administrator for every state in early 1997. Some states report having more stringent requirements, while some states do not meet minimum federal requirements. Although the primary responsibility for ground water tracer selection and use rests on the investigator, national guidance is required to assure compliance with the UIC program. To assist investigators, we present acceptable tracers that have been identified by two states, Nevada and South Carolina, that require no further regulatory review. [source] Technical issues affecting the implementation of US Environmental Protection Agency's proposed fish tissue-based aquatic criterion for selenium,INTEGRATED ENVIRONMENTAL ASSESSMENT AND MANAGEMENT, Issue 4 2007A Dennis Lemly Abstract The US Environmental Protection Agency is developing a national water quality criterion for selenium that is based on concentrations of the element in fish tissue. Although this approach offers advantages over the current water-based regulations, it also presents new challenges with respect to implementation. A comprehensive protocol that answers the "what, where, and when" is essential with the new tissue-based approach in order to ensure proper acquisition of data that apply to the criterion. Dischargers will need to understand selenium transport, cycling, and bioaccumulation in order to effectively monitor for the criterion and, if necessary, develop site-specific standards. This paper discusses 11 key issues that affect the implementation of a tissue-based criterion, ranging from the selection of fish species to the importance of hydrological units in the sampling design. It also outlines a strategy that incorporates both water column and tissue-based approaches. A national generic safety-net water criterion could be combined with a fish tissue,based criterion for site-specific implementation. For the majority of waters nationwide, National Pollution Discharge Elimination System permitting and other activities associated with the Clean Water Act could continue without the increased expense of sampling and interpreting biological materials. Dischargers would do biotic sampling intermittently (not a routine monitoring burden) on fish tissue relative to the fish tissue criterion. Only when the fish tissue criterion is exceeded would a full site-specific analysis including development of intermedia translation factors be necessary. [source] GROUPWISE MODELING STUDY OF BACTERIALLY IMPAIRED WATERSHEDS IN TEXAS: CLUSTERING ANALYSIS,JOURNAL OF THE AMERICAN WATER RESOURCES ASSOCIATION, Issue 4 2006Sabu Paul ABSTRACT: Under the Clean Water Act (CWA) program, the Texas Commission on Environmental Quality (TCEQ) listed 110 stream segments in the year 2000 with pathogenic bacteria impairment. A study was conducted to evaluate the probable sources of pollution and characterize the watersheds associated with these impaired water bodies. The primary aim of the study was to group the water bodies into clusters having similar watershed characteristics and to examine the possibility of studying them as a group by choosing models for total maximum daily load (TMDL) development based on their characteristics. This approach will help to identify possible sources and determine appropriate models and hence reduce the number of required TMDL studies. This in turn will help in reducing the effort required to restore the health of the impaired water bodies in Texas. The main characteristics considered for the classification of water bodies were land use distribution within the watershed, density of stream network, average distance of land of a particular use to the closest stream, household population, density of on-site sewage facilities (OSSFs), bacterial loading from different types of farm animals and wildlife, and average climatic conditions. The climatic data and observed instream fecal coliform bacteria concentrations were analyzed to evaluate seasonal variability of instream water quality. The grouping of water bodies was carried out using the multivariate statistical techniques of factor analysis/principal component analysis, cluster analysis, and discriminant analysis. The multivariate statistical analysis resulted in six clusters of water bodies. The main factors that differentiated the clusters were found to be bacterial contribution from farm animals and wildlife, density of OSSFs, density of households connected to public sewers, and land use distribution. [source] STATEWIDE EMPIRICAL MODELING OF BACTERIAL CONTAMINATION OF SURFACE WATERS,JOURNAL OF THE AMERICAN WATER RESOURCES ASSOCIATION, Issue 3 2006James D. Wickham ABSTRACT: Bacterial contamination of surface waters is attributed to both urban and agricultural land use practices and is one of the most frequently cited reasons for failure to meet standards established under the Clean Water Act (CWA) (P.L. 92,500). Statewide modeling can be used to determine if bacterial contamination occurs predominantly in urban or agricultural settings. Such information is useful for directing future monitoring and allocating resources for protection and restoration activities. Logistic regression was used to model the likelihood of bacterial contamination using watershed factors for the state of Maryland. Watershed factors included land cover, soils, topography, hydrography, locations of septic systems, and animal feeding operations. Results indicated that bacterial contamination occurred predominantly in urban settings. Likelihood of bacterial contamination was highest for small watersheds with well drained and erodible soils and a high proportion of urban land adjacent to streams. The number of septic systems and animal feeding operations and the amount of agricultural land were not significant explanatory factors. The urban infrastructure tends to "connect" more of the watershed to the stream network through the creation of roads, storm sewers, and wastewater treatment plants. This may partly explain the relationship between urbanization and bacterial contamination found in this study. [source] ASSESSING LAND USE IMPACTS ON WATER QUALITY USING MICROBIAL SOURCE TRACKING,JOURNAL OF THE AMERICAN WATER RESOURCES ASSOCIATION, Issue 6 2004Sharon C. Long ABSTRACT: A renewed emphasis on source water protection and watershed management has resulted from recent amendments and initiatives under the Safe Drinking Water Act and the Clean Water Act. Knowledge of the impact of land use choices on source water quality is critical for efforts to properly manage activities within a watershed. This study evaluated qualitative relationships between land use and source water quality and the quantitative impact of season and rainfall events on water quality parameters. High levels of specific conductance tended to be associated with dense residential development, while organic carbon was elevated at several forested sites. Turbidity was generally higher in more urbanized areas. Source tracking indicators were detected in samples where land use types would predict their presence. Coliform levels were statistically different at the 95 percent confidence levels for winter versus summer conditions and dry versus wet weather conditions. Other water quality parameters that varied with season were organic carbon, turbidity, dissolved oxygen, and specific conductance. These results indicate that land use management can be effective for mitigating impacts to a water body; however, year- round, comprehensive data are necessary to thoroughly evaluate the water quality at a particular site. [source] SEDIMENT OXYGEN DEMAND IN THE ARROYO COLORADO RIVER,JOURNAL OF THE AMERICAN WATER RESOURCES ASSOCIATION, Issue 2 2003Marty D. Matlock ABSTRACT: The lower reaches of the Arroyo Colorado have historically failed to meet their use under subsection 303(b) of the U.S. Clean Water Act due to fecal coliform bacteria and low dissolved oxygen (DO). Fish kills, especially at the tidal confluence at the Port of Harlingen, Texas, have been reported. Oxygen demand from sediment (SOD) for a river typically has two states-diffusion limited SOD (SOD) and potential SOD (pSOD), expressed when sediment is resuspended through increased flow or other disturbances. The objective of this research was to measure SOD in the Arroyo Colorado River in situ, estimate pSOD ex situ, and evaluate the relationship between SOD and the depositional environment. We measured SOD and pSOD in the Arroyo Colorado River at up to eight sites over three sampling events. We identified the sample sites based on a modified Rosgen geomorphic index for streambed stabilization. Sites with high sediment deposition potential had high SOD. The average values of SOD between sites were 0.62 g/m2/day (standard deviation 0.38 g/m2/day) and ranged from 0.13 to 1.2 g/m2/day. Potential SOD values ranged from as low as 19.2 to as high as 2,779 g/m3 sediment/ day. Potential SOD can serve as an indicator of the possible impact of SOD from resuspended sediment in stream systems. [source] LANDSCAPE-SCALE ANALYSIS AND MANAGEMENT OF CUMULATIVE IMPACTS TO RIPARIAN ECOSYSTEMS: PAST, PRESENT, AND FUTURE,JOURNAL OF THE AMERICAN WATER RESOURCES ASSOCIATION, Issue 6 2001Eric D. Stein ABSTRACT: Analyses of cumulative impacts to riparian systems is an important yet elusive goal. Previous analyses have focused on comparing the number of hectares impacted to the number of hectares restored, without addressing the loss of riparian function or the effect of the spatial distribution of impacts. This paper presents an analysis of the spatial distribution of development-related impacts to riparian ecosystems, that were authorized under Section 404 of the Clean Water Act. Impacts on habitat structure, contiguity, and landscape context were evaluated using functional indices scaled to regional reference sites. Impact sites were mapped using GIS and analyzed for spatial associations. Positive spatial autocorrelation (i.e. clustering of impact sites) resulted from the piecemeal approach to impact assessment, which failed to prevent cumulative impacts. Numerous small projects in close proximity have resulted in adverse impacts to entire stream reaches or have fragmented the aquatic resources to a point where overall functional capacity is impaired. Additionally, the ecological functions of unaffected areas have been diminished due to their proximity to degraded areas. A proactive approach to managing cumulative impacts is currently being used in Orange County, California as part of a Corps of Engineers sponsored Special Area Management Plan (SAMP). The SAMP process is evaluating the ecological conditions and physical processes of the study watersheds and attempting to plan future development in a manner that will guard against cumulative impacts. [source] The hyporheic zone: Linking groundwater and surface water,understanding the paradigmREMEDIATION, Issue 1 2001Thomas M. Biksey The hyporheic zone, the transition region between groundwater and surface water, represents an important interface between terrestrial and aquatic ecosystems. When groundwater combines with surface water in this zone, the characteristics of each are blended and new gradients are established, especially for contaminants. Therefore, the hyporheic zone is important in considering the "big ecological picture" as the hydrologic continuum connecting groundwater and surface water. The importance is reflected by the current focus of this zone in ecological risk assessments conducted under the Resource Conservation and Recovery Act (RCRA), Comprehensive Environmental Response, Compensation and Liability Act (CERCLA), and Clean Water Act (CWA) programs. A variety of tools can be used to measure, analyze, and predict the physical, chemical, and biological processes that occur within the hyporheic zone. Directly measuring the flux of water across the interface between groundwater and surface water determines whether surface water enters the streambed at downwelling zones or groundwater discharges from the streambed in upwelling zones. In addition to direct measurements of the flux of water, several states have developed models to characterize the interaction of groundwater and surface water. The variability in physical and chemical characteristics between upwelling and downwelling zones influences the local ecology within the zone. The study of the species within the hyporheic zone includes ecological surveys and ecotoxicological investigations. The evolving study of the hyporheic zone will necessitate an increase in basic research into hydraulic considerations, an identification of regional representative sites with contaminated hyporheic zones, and a better understanding of the ecology of the species within the zone. © 2001 John Wiley & Sons, Inc. [source] Factors influencing the challenges of modelling and treating fecal indicator bacteria in surface watersECOHYDROLOGY, Issue 4 2009Cristiane Q. Surbeck Abstract In the United States, thousands of creeks, rivers, and coastal zones are listed as impaired in the Clean Water Act's 303(d) list. The number one general cause of impairments is denoted as ,pathogens', which can include known pathogenic organisms or, more commonly, fecal indicator bacteria (FIB), such as fecal coliform bacteria, Escherichia coli, and enterococci bacteria. Despite efforts by water quality managers to reduce FIB in surface waters via treatment, successful and significant reduction of FIB has been difficult to achieve to meet water quality standards. In addition, current efforts to numerically model FIB concentrations in surface waters do not consider many complexities associated with FIB as a pollutant. Reasons for the challenge of treating and modelling FIB are their varied sources and mechanisms of survival and decay in the environment. This technical note addresses this challenge by discussing the nature of FIB, their sources, and their fate and transport mechanisms. Sources of FIB to surface waters include wastewater, stormwater and dry-weather runoff, and animals. Mechanisms of pathogen indicator occurrence in surface waters are transport in stormwater, ecological proliferation, and interaction with sediments. Copyright © 2009 John Wiley & Sons, Ltd. [source] |