Home  About us  Contact
 

Topography Mission (topography + mission)

Distribution by Scientific Domains
Earth and Environmental Science80%

Kinds of Topography Mission

  • radar topography mission
    		•
  • shuttle radar topography mission
    		•

    Selected Abstracts

    The implications of data selection for regional erosion and sediment yield modelling

    EARTH SURFACE PROCESSES AND LANDFORMS, Issue 15 2009
    Joris de Vente
    Abstract Regional environmental models often require detailed data on topography, land cover, soil, and climate. Remote sensing derived data form an increasingly important source of information for these models. Yet, it is often not easy to decide what the most feasible source of information is and how different input data affect model outcomes. This paper compares the quality and performance of remote sensing derived data for regional soil erosion and sediment yield modelling with the WATEM-SEDEM model in south-east Spain. An ASTER-derived digital elevation model (DEM) was compared with the DEM obtained from the Shuttle Radar Topography Mission (SRTM), and land cover information from the CORINE database (CLC2000) was compared with classified ASTER satellite images. The SRTM DEM provided more accurate estimates of slope gradient and upslope drainage area than the ASTER DEM. The classified ASTER images provided a high accuracy (90%) land cover map, and due to its higher resolution, it showed a more fragmented landscape than the CORINE land cover data. Notwithstanding the differences in quality and level of detail, CORINE and ASTER land cover data in combination with the SRTM DEM or ASTER DEM allowed accurate predictions of sediment yield at the catchment scale. Although the absolute values of erosion and sediment deposition were different, the qualitative spatial pattern of the major sources and sinks of sediments was comparable, irrespective of the DEM and land cover data used. However, due to its lower accuracy, the quantitative spatial pattern of predictions with the ASTER DEM will be worse than with the SRTM DEM. Therefore, the SRTM DEM in combination with ASTER-derived land cover data presumably provide most accurate spatially distributed estimates of soil erosion and sediment yield. Nevertheless, model calibration is required for each data set and resolution and validation of the spatial pattern of predictions is urgently needed. Copyright © 2009 John Wiley & Sons, Ltd. [source]

    Quantitative analysis of InSAR digital elevation models for identification of areas with different tectonic activities in southern Italy

    EARTH SURFACE PROCESSES AND LANDFORMS, Issue 1 2009
    Claudio Martino
    Abstract This work presents the results of a quantitative analysis of an interferometric SAR (InSAR) digital elevation model (DEM), obtained by the Shuttle Radar Topography Mission (SRTM). The analysis aims to identify additional parameters to recognize areas in southern Italy with different tectonic activities and behaviours. The axial zone of the Campania-Lucania Apennine and the Sila Massif in Calabria, Italy, characterized by quite different evolutionary histories, have been chosen as test areas sufficiently wide to validate observations on a sub-regional scale at least. Geomorphological information on the shape of palaeosurfaces has been used to estimate uplift and/or erosion amounts and rates. Palaeosurfaces are identified on the DEM as regions with an altitude higher than 1000 m a.s.l. and sub-planar land surfaces dipping less than 6°. Information about the shape of palaeosurfaces during the first stage of uplift and before the tectonic-induced block fragmentation has been extracted. A fragmentation index has been computed for these erosional surfaces. The first stage of this landscape evolution has been studied in terms of the geometric characteristics of fragmented blocks. The last erosional stage has been recognized in terms of both geometric characteristics and fragmentation index of the sub-horizontal land surfaces. Altitude and age of the palaeosurfaces, referred to ancient base-levels of the erosion, have been used to estimate the erosional rate. Copyright © 2008 John Wiley and Sons, Ltd. [source]

    The high-resolution gravimetric geoid of Iberia: IGG2005

    GEOPHYSICAL JOURNAL INTERNATIONAL, Issue 3 2005
    V. Corchete
    SUMMARY It is well known that orthometric heights can be obtained without levelling by using ellipsoidal and geoidal heights. For engineering purposes, these orthometric heights must be determined with high accuracy. For this reason, the determination of a high-resolution geoid is necessary. In Iberia, since the publication of the most recent geoid (IBERGEO95), a new geopotential model has become available (EIGEN-CG01C, released on 2004 October 29) and a new high-resolution digital terrain model (SRTM 90M obtained from the Shuttle Radar Topography Mission) has been developed for the Earth. Logically, these new data represent improvements that must be included in a new geoid of Iberia. With this goal in mind, we have carried out a new gravimetric geoid determination in which these new data are included. The computation of the geoid uses the Stokes integral in convolution form, which has been shown as an efficient method to reach the proposed objective. The terrain correction has been applied to the gridded gravity anomalies to obtain the corresponding reduced anomalies. The indirect effect has also been taken into account. Thus, a new geoid is provided as grid data distributed for Iberia from 35° to 44° latitude and ,10° to 4° longitude (extending to 9°× 14°) in a 361 × 561 regular grid with a mesh size of 1.5,× 1.5, and 202 521 points in the GRS80 reference system. This calculated geoid and previous geoids that exist for this study area (IBERGEO95, EGM96, EGG97 and EIGEN-CG01C) are compared to the geoid undulations corresponding to 16 points of the European Vertical Reference Network (EUVN) on Iberia. The new geoid shows an improvement in precision and reliability, fitting the geoidal heights of these EUVN points with more accuracy than the other previous geoids. [source]

    Predicting and quantifying the structure of tropical dry forests in South Florida and the Neotropics using spaceborne imagery

    GLOBAL ECOLOGY, Issue 3 2006
    Thomas W. Gillespie
    ABSTRACT Aim, This research examines environmental theories and remote sensing methods that have been hypothesized to be associated with tropical dry forest structure. Location, Tropical dry forests of South Florida and the Neotropics. Methods, Field measurements of stand density, basal area and tree height were collected from 22 stands in South Florida and 30 stands in the Neotropics. In South Florida, field measurements were compared to climatic (temperature, precipitation, hurricane disturbance) and edaphic (rockiness, soil depth) variables, spectral indices (NDVI, IRI, MIRI) from Landsat 7 ETM+, and estimates of tree height from the Shuttle Radar Topography Mission (SRTM) and the National Elevation Dataset (NED). Environmental variables associated with tropical dry forest structure in South Florida were compared to tropical dry forest in other Neotropical sites. Results, There were significant correlations among temperature and precipitation, and stand density and tree height in South Florida. There were significant correlations between (i) stand density and mean NDVI and standard deviation of NDVI, (ii) MIRI and stand density, basal area and mean tree height, and (iii) estimates of tree height from SRTM with maximum tree height. In the Neotropics, there were no relationships between temperature or precipitation and tropical dry forest structure, however, Neotropical sites that experience hurricane disturbance had significantly shorter tree heights and higher stand densities. Main conclusions, It is possible to predict and quantify the forest structure characteristics of tropical dry forests using climatic data, Landsat 7 ETM+ imagery and SRTM data in South Florida. However, results based on climatic data are region-specific and not necessarily transferable between tropical dry forests at a continental spatial scale. Spectral indices from Landsat 7 ETM+ can be used to quantify forest structure characteristics, but SRTM data are currently not transferable to other regions. Hurricane disturbance has a significant impact on forest structure in the Neotropics. [source]

    Geomorphic characteristics of the Minjiang drainage basin (eastern Tibetan Plateau) and its tectonic implications: New insights from a digital elevation model study

    ISLAND ARC, Issue 2 2006
    Hui-Ping Zhang
    Abstract The Minshan Mountain and adjacent region are the major continental escarpments along the eastern Tibetan Plateau. The Minjiang drainage basin is located within the plateau margin adjacent to the Sichuan Basin. Based on the analysis of the digital elevation model (DEM) acquired by the Shuttle Radar Topography Mission (SRTM), we know that the Minjiang drainage basin has distinct geomorphic characteristics. The regular increasing of local topographic relief from north to south is a result of the Quaternary sediment deposition within the plateau and the holistic uplift of the eastern margin of the Tibetan Plateau versus the Sichuan Basin. Results from DEM-determined Minjiang drainage sub-basins and channel profiles show that the tributaries on the opposite sides are asymmetric. Lower perimeter and area of drainage sub-basins, total channel length and bifurcation ratio within eastern flank along the Minjiang mainstream are the result of the Quaternary differential uplift of the Minshan Mountain region. Shorter stream lengths and lower bifurcation ratio might be the indications of the undergrowth and newborn features of these eastern streams, which are also representative for the eastern uplift of the Minshan Mountain. [source]