Home About us Contact
|
Home About us Contact | ||
|
|
||
Smaller Quantities (smaller + quantity)
Selected AbstractsCoordination Modes of 9-Methyladenine in cis -Platinum(II) Complexes with Dimethyl(phenyl)phosphanes as Ancillary Ligands , Synthesis and Characterization of cis -[PtL2(9-MeAd)2](NO3)2, cis -[PtL2{9-MeAd(,H)}]3(NO3)3, and cis -[L2Pt{9-MeAd(,H)}PtL2](NO3)3EUROPEAN JOURNAL OF INORGANIC CHEMISTRY, Issue 1 2003Bruno Longato Abstract Treatment of 9-methyladenine (9-MeAd) with cis -[PtL2(NO3)2] (1) (L = PMe2Ph) in a 2:1 molar ratio generated the bis(adduct) cis -[PtL2(9-MeAd)2](NO3)2 (2), which was isolated and fully characterized by multinuclear (1H, 31P, 13C, 195Pt and 15N) NMR analysis, which showed that the two nucleobases are selectively coordinated through the N1 atom. Small amounts of a mono(adduct) cis -[PtL2(S)(9-MeAd)]2+ (3) (S = solvent) and of a diplatinated species cis -[L2Pt(S){9-MeAd(,H)}PtL2]3+ (4) are formed in DMSO solution when 9-MeAd is present in smaller quantities than 1. Complex 3 is platinated at N1, with a solvent molecule representing the fourth ligand around the metal center. Complex 4 contains an adenine molecule deprotonated and platinated at N1,N6,N7, with two cis -L2Pt units bonded to nitrogen atom N1 and to nitrogen atoms N6 and N7, respectively. With increasing relative concentration of the nucleobase, both complexes 3 and 4 progressively convert into the bis(adduct) 2, the only species detectable in solution when the Ad/Pt molar ratio is 2:1. The trinuclear compound cis -[L2Pt{9-MeAd(,H)}]3(NO3)3 (5) (L = PMe2Ph), containing an NH2 -deprotonated nucleobase bridging the metal centers through the N1 and N6 atoms, is quantitatively formed when the dinuclear hydroxo complex cis -[Pt(,-OH)L2]2(NO3)2 (6) reacts with 9-MeAd in CH3CN solution. The isolated complex was fully characterized by multinuclear NMR spectroscopy and mass spectrometry. It appears to be stable in solution in CH3CN and chlorinated solvents, whereas in DMSO it partially converts into a new species, probably the dinuclear analog cis -[PtL2{9-MeAd(,H)}]2(NO3)2, in which the adenine maintains its coordination mode. At equilibrium the trinuclear/dinuclear species molar ratio is 20:1. Through the addition of a stoichiometric amount of nitrate 1 to a DMSO solution of 5 we were able to generate the diplatinated compound 4 in high yield. Complex 4 displays a new coordination mode for the adeninate ion, with N1 bonded to one platinum atom whereas N6 and N7 are chelated to a second one. (© Wiley-VCH Verlag GmbH & Co. KGaA, 69451 Weinheim, Germany, 2003) [source] Minimizing the release of proinflammatory and toxic bacterial products within the host: A promising approach to improve outcome in life-threatening infectionsFEMS IMMUNOLOGY & MEDICAL MICROBIOLOGY, Issue 1 2005Roland Nau Abstract Various bacterial components (e.g., endotoxin, teichoic and lipoteichoic acids, peptidoglycans, DNA) induce or enhance inflammation by stimulating the innate immune system and/or are directly toxic in eukariotic cells (e.g., hemolysins). When antibiotics which inhibit bacterial protein synthesis kill bacteria, smaller quantities of proinflammatory or toxic compounds are released in vitro and in vivo than during killing of bacteria by ,-lactams and other cell-wall active drugs. In general, high antibiotic concentrations liberate lower quantities of bacterial proinflammatory or toxic compounds than concentrations close to the minimum inhibitory concentration. In animal models of Escherichia coli Pseudomonas aeruginosa and Staphylococcus aureus peritonitis/sepsis and of Streptococcus pneumoniae meningitis, a lower release of proinflammatory bacterial compounds was associated with a reduced mortality or neuronal injury. Pre-treatment with a bacterial protein synthesis inhibitor reduced the strong release of bacterial products usually observed during treatment with a ,-lactam antibiotic. Data available strongly encourage clinical trials comparing antibiotic regimens with different release of proinflammatory/toxic bacterial products. The benefit of the approach to reduce the liberation of bacterial products should be greatest in patients with a high bacterial load. [source] Precipitation of lead,zinc ores in the Mississippi Valley-type deposit at Trèves, Cévennes region of southern FranceGEOFLUIDS (ELECTRONIC), Issue 1 2006D. LEACH Abstract The Trèves zinc,lead deposit is one of several Mississippi Valley-type (MVT) deposits in the Cévennes region of southern France. Fluid inclusion studies show that the ore was deposited at temperatures between approximately 80 and 150°C from a brine that derived its salinity mainly from the evaporation of seawater past halite saturation. Lead isotope studies suggest that the metals were extracted from local basement rocks. Sulfur isotope data and studies of organic matter indicate that the reduced sulfur in the ores was derived from the reduction of Mesozoic marine sulfate by thermochemical sulfate reduction or bacterially mediated processes at a different time or place from ore deposition. The large range of ,34S values determined for the minerals in the deposit (12.2,19.2, for barite, 3.8,13.8, for sphalerite and galena, and 8.7 to ,21.2, for pyrite), are best explained by the mixing of fluids containing different sources of sulfur. Geochemical reaction path calculations, based on quantitative fluid inclusion data and constrained by field observations, were used to evaluate possible precipitation mechanisms. The most important precipitation mechanism was probably the mixing of fluids containing different metal and reduced sulfur contents. Cooling, dilution, and changes in pH of the ore fluid probably played a minor role in the precipitation of ores. The optimum results that produced the most metal sulfide deposition with the least amount of fluid was the mixing of a fluid containing low amounts of reduced sulfur with a sulfur-rich, metal poor fluid. In this scenario, large amounts of sphalerite and galena are precipitated, together with smaller quantities of pyrite precipitated and dolomite dissolved. The relative amounts of metal precipitated and dolomite dissolved in this scenario agree with field observations that show only minor dolomite dissolution during ore deposition. The modeling results demonstrate the important control of the reduced sulfur concentration on the Zn and Pb transport capacity of the ore fluid and the volumes of fluid required to form the deposit. The studies of the Trèves ores provide insights into the ore-forming processes of a typical MVT deposit in the Cévennes region. However, the extent to which these processes can be extrapolated to other MVT deposits in the Cévennes region is problematic. Nevertheless, the evidence for the extensive migration of fluids in the basement and sedimentary cover rocks in the Cévennes region suggests that the ore forming processes for the Trèves deposit must be considered equally viable possibilities for the numerous fault-controlled and mineralogically similar MVT deposits in the Cévennes region. [source] Characterization of perfluoroalkyl acrylic oligomers by electrospray ionization time-of-flight mass spectrometryRAPID COMMUNICATIONS IN MASS SPECTROMETRY, Issue 7 2008Timothy J. Romack Electrospray ionization time-of-flight mass spectrometry (ESI-ToF-MS) has been successfully employed for the characterization of molecular weight, molecular weight distribution and end groups for bromine-terminated perfluoroalkyl acrylate oligomers prepared using atom transfer radical polymerization. Intact oligomers and smaller quantities of common side products were observed from m/z 1000 to 4000 cationized with a sodium ion, a difluorobenzyl cation or a proton with a minimum of multiply charged species. Number average molecular weight and weight average molecular weight for both the samples that were characterized were in reasonable agreement with independent measurements conducted using GPC-MALS and 1H NMR spectroscopy. Copyright © 2008 John Wiley & Sons, Ltd. [source] Modulatory effect of chiral nonsteroidal anti-inflammatory drugs on apoptosis of human neutrophilsCHIRALITY, Issue 2 2008gorzata Zieli, ska-Przyjemska Abstract Polymorphonuclear neutrophils (PMNs) are short-lived leukocytes that die by apoptosis. Although PMNs are crucial in the defense against infection, they have been implicated in the pathogenesis of tissue injury observed in inflammatory diseases. The induction or prevention of PMN apoptosis is currently discussed as a key event in the control of inflammation. Caspase-3 activation is the first step in the execution phase of apoptosis. In the study, effect of racemic mixtures and enantiomers of 2-arylpropionic acid derivatives: ketoprofen, flurbiprofen (FBP), and (+)- S -naproxen and 2-arylbutyric acid: indobufen on apoptosis activation via caspase-3 and phosphatidylserine (PS) translocation (annexin-V binding) in human neutrophils in vitro has been investigated. Caspase-3 activation was detected by Western blotting, fluorometric assay of DEVD-AMC cleavage, and flow cytometry with carboxyfluorescein (FAM) labeled caspase inhibitor. PMNs were isolated and cultured up to 24 h. The chiral nonsteroidal anti-inflammatory drugs (NSAIDs) were found to modulate human PMN apoptosis in a dose- and time-dependent manner. The greater activation of caspase was found at 75,150 ,g/ml concentration of racemates as well enantiomers, especially for FBP, whereas NSAIDs at smaller quantities (15 ,g/ml) were inactive. At concentration of 75 ,g/ml, NSAIDs increased the rate of PS externalization in PMA-stimulated and non-stimulated neutrophils. Additionally, no cytotoxic effect of the NSAIDs was observed at concentration up to 75 ,g/ml that induce apoptosis. Regulation of caspase activity by NSAIDs may represent a potent target to trigger apoptosis and resolve inflammatory disorders. Chirality, 2008. © 2007 Wiley-Liss, Inc. [source] A chip-based miniaturized format for protein-expression profiling: The exploitation of comprehensively produced antibodiesELECTROPHORESIS, Issue 18 2006Hisashi Koga Dr. Abstract Numerous antibodies have been developed and validated in recent years, and show promise for use in novel functional protein assays. Such assays would be an alternative to pre-existing comprehensive assays, such as DNA microarrays. Antibody microarrays are thought to represent those functional protein assays. While a variety of attempts have been made to apply DNA microarray technology to antibody microarrays, a fully optimized protocol has not been established. We have been conducting a project to comprehensively produce antibodies against mouse KIAA ("KI" stands for "Kazusa DNA Research Institute" and "AA" are reference characters) proteins. Using our library of antibodies, we established a novel antibody microarray format that utilizes surface plasmon resonance (SPR) technology. A label-free real-time measurement of protein expression in crude cell lysates was achieved by direct readout of the bindings using SPR. Further refinement of the antibody microarray format enabled us to detect a smaller quantity of target proteins in the lysate without the bulk effect. In this review, we first summarize available antibody array formats and then describe the above-mentioned format utilizing updated SPR technology. [source] Simulation of heat transfer in the cool storage unit of a liquid,air energy storage systemHEAT TRANSFER - ASIAN RESEARCH (FORMERLY HEAT TRANSFER-JAPANESE RESEARCH), Issue 4 2002Hidefumi Araki Abstract An energy storage system that stores energy in the form of liquid air was studied. In this system, the cool storage unit was the most important unit. From the viewpoint of safety and economy, it was most promising to store the cold energy as the sensitive heat of a solid such as pebbles or concrete. A simulator was developed to predict temperature variations of the solid cool storage unit. The simulator calculated unsteady heat transfer between a supercritical gas flow and the solid material. Comparison of calculated and experimental results showed that the temperature variation of the metal cool storage medium was accurate within 11%. The calculated results showed for the concrete cool storage unit that a smaller quantity of medium was required with a smaller pitch of the tube. The minimum quantity of concrete calculated at the smallest pitch was three times that of concrete, which was simply estimated from the heat capacity of concrete and air. The volume required for concrete cool storage was less than 1/100 that of reservoirs for a pumped-hydro power station having a vertical drop of 500 m. © 2002 Wiley Periodicals, Inc. Heat Trans Asian Res, 31(4): 284,296, 2002; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/htj.10035 [source] Studies on dimerisation of tocopherols under the influence of methyl linoleate peroxidesMOLECULAR NUTRITION & FOOD RESEARCH (FORMERLY NAHRUNG/FOOD), Issue 2 2003Marek Gogolewski Abstract The stability of plant oils is related to the level of polyunsaturated fatty acids and the presence of native antioxidants , especially tocopherols. During storage, lipids or the fat products undergo oxidation and tocopherol dimers and trimers are formed. These compounds possess reducing and antioxidant properties and participate in oxidation clearly inhibiting this process. In the present study, the correlation between levels of peroxides formed during autoxidation of methyl linoleate and simultaneous decomposition of tocopherols was examined. The peroxide value was investigated. Quantities of decomposed tocopherols and formation of their dimers were determined by high-performance liquid chromatography (HPLC). Mass spectrum analysis confirmed that the analysed compounds were dimers. Dimerisation of ,-T begins at the smaller quantity of the methyl linoleate peroxides than dimerisation of ,-T. At the beginning of methyl linoleate autoxidation dimerization of ,-T in relation to its loss was smaller. The quantity of ,-T dimers with ether bonds in total dimers pointed to faster binding of phenoxy radicals than transformation into the phenyl ones. ,-T dimers with phenyl bonds constitute about 65% of the total. The quantity of peroxides in methyl linoleate, necessary for quantitative and qualitative changes of homologous tocopherols, decreased from ,-T to ,-T. [source] | |||||||||||||