Home About us Contact
|
Home About us Contact | ||
|
|
||
Sealing Ability (sealing + ability)
Selected AbstractsSealing ability of occlusal resin composite restoration using four restorative proceduresEUROPEAN JOURNAL OF ORAL SCIENCES, Issue 6 2008Danuchit Banomyong The purpose of this work was to investigate fluid flow after restoration using four restorative procedures. Micro-gap, internal dye leakage, and micropermeability of bonded interfaces were also investigated. Each tooth was mounted, connected to a fluid flow-measuring device, and an occlusal cavity was prepared. Fluid flow after cavity preparation was recorded as the baseline measurement, and the cavity was restored using one of four restorative procedures: bonding with total-etch (Single Bond 2) or self-etch (Clearfil SE Bond) adhesives without lining; or lining with resin-modified glass-ionomer cement (GIC) (Fuji Lining LC) or conventional GIC (Fuji IX) and then bonding with the total-etch adhesive. Fluid flow was recorded after restoration and at specific time-points up to 6 months thereafter and recorded as a percentage. Micro-gap formation was analyzed using resin replicas and scanning electron microscopy. Internal leakage of 2% methylene blue dye was observed under a light microscope. In micro-permeability testing, fluorescent-dye penetration was investigated using confocal laser microscopy. None of the restorative procedures provided a perfectly sealed restoration. Glass-ionomer lining did not reduce fluid flow after restoration, and micro-gaps were frequently detected. The self-etch adhesive failed to provide a better seal than the total-etch adhesive, and even initial gap formation was rarely observed for the former. Penetration of methylene blue and fluorescent dyes was detected in most restorations. [source] Comparative in vitro study of the sealing efficiency of white vs grey ProRoot mineral trioxide aggregate formulas as apical barriersDENTAL TRAUMATOLOGY, Issue 2 2008Spyridon Stefopoulos Recently conventional grey MTA has been replaced by a new white MTA formula. The aim of this study was to compare the root canal adaptation of white MTA to that of grey MTA when used as an apical barrier in teeth with open apices. We also examined whether a previous calcium hydroxide intracanal medication affects MTA's sealing ability and investigated the ability to remove calcium hydroxide from the root canal walls. Forty-nine teeth were prepared in a manner to simulate a divergent open apex of immature teeth. Four teeth were used in a preliminary experiment to demonstrate the inefficacy of calcium hydroxide removal from the canal walls in teeth with open apices. Four groups of 10 teeth each were created: groups A and B were treated with calcium hydroxide intracanal medication and then received an apical plug of grey and white MTA respectively. Groups C and D received an apical plug of grey and white MTA respectively without previous intracanal medication. Four teeth served as negative and one as a positive control. The marginal adaptation and sealing ability of the apical barrier were tested by means of a dye tracer (basic fuchsine) after longitudinal sectioning. It was found that MTA apical barrier resisted displacement during gutta-percha condensation. Calcium hydroxide pretreatment, adversely affected white MTA sealing ability (P < 0.05). [source] Effect of placement of calcium sulphate when used for the repair of furcation perforations on the seal produced by a resin-based materialINTERNATIONAL ENDODONTIC JOURNAL, Issue 2 2007L. Zou Abstract Aim, To evaluate the sealing ability of calcium sulphate when used under composite resin for the repair of furcation perforations having different diameters. Methodology, Perforations of different diameter were created in the floors of pulp chambers in 60 extracted human molar teeth with either a number 3 (1 mm diameter) or 5 (1.5 mm diameter) round bur. The specimens of each group were divided into four sub-groups which were repaired with composite resin either alone or in combination with calcium sulphate that created an artificial floor (15 teeth group -1). Eight teeth without furcation perforations served as negative controls. In the leakage detection device, 1 mol L,1 glucose solution was forced under a pressure of 1.5 KPa from the crown towards the pulp chamber floor. The concentration of leaked glucose was measured at 1, 2, 4, 7, 10, 15 and 20 days using a glucose oxidase method and the data evaluated using the rank sum test. Results, The specimens with larger perforations repaired with composite resin alone had significantly more leakage (P < 0.05). Using calcium sulphate as an artificial floor significantly decreased leakage of smaller perforations (P < 0.05). In groups repaired with calcium sulphate under composite resin, leakage in smaller perforations was markedly lower than that in larger ones (P < 0.05). No significant difference was found between the specimens with 1 or 1.5 mm perforations repaired with resin alone (P > 0.05). Conclusions, Calcium sulphate significantly improved the sealing ability of 1 mm perforations repaired with composite resin but not for 1.5 mm perforations. [source] The influence of root canal shape on the sealing ability of two root canal sealersINTERNATIONAL ENDODONTIC JOURNAL, Issue 4 2006A. Juhász Abstract Aim, To evaluate the influence of root canal form on the sealing ability of two root canal sealers. Methodology, Twenty radiographically confirmed straight and 20 curved root canals were prepared with a stepback hand filing technique. Root canal aberrations created during preparation were determined by the use of double exposure radiographic technique. The prepared canals were filled with lateral condensation of gutta-percha and one or other of two root canal sealers (Pulp Canal Sealer and Sealapex). Leakage along the apical 10 mm of roots was measured with a fluid transport model at 1, 3, 6, 9 and 12-month intervals. Results, There were no statistically significant differences between straight and curved root canals (P > 0.05) for prevalence of root canal transportation. The prevalence of apical transportation was 80% in the straight and 85% in the curved root canals. A complete seal was more frequently observed in straight canals compared with curved canals. Utilizing the ,* index, analysis showed the filling with Sealapex allowed more leakage than Pulp Canal Sealer at 1 year. Conclusion, Under the conditions of the study, root canal form influenced short-term sealing ability. In the long-term the seal was affected by the sealer rather than root canal form. [source] Apical microleakage evaluation of system B compared with cold lateral technique: In vitro studyAUSTRALIAN ENDODONTIC JOURNAL, Issue 2 2010Manal Farea bds Abstract The aim of this study was to evaluate in vitro the apical sealing ability of cold lateral and system B root filling techniques using dye penetration. Eighty-six extracted single-rooted human teeth were prepared and randomly divided into two experimental groups to be obturated by cold lateral condensation (n = 33) and system B (n = 33). The remaining 20 teeth served as positive and negative controls. The roots were embedded for 72 h in methylene blue dye solution and sectioned transversely for dye penetration evaluation using stereomicroscope. The results of this study showed that cold lateral condensation leaked significantly more (P < 0.001) than system B technique. [source] Coronal sealing ability of three sectional obturation techniques , SimpliFill, Thermafil and warm vertical compaction , compared with cold lateral condensation and post space preparationAUSTRALIAN ENDODONTIC JOURNAL, Issue 3 2006Velayutham Gopikrishna mds Abstract The purpose of this study was to evaluate the effect post space preparation has on the coronal seal of root canals obturated with cold lateral condensation of gutta-percha compared with the corsonal sealing ability of three sectional obturation techniques not requiring post space preparation. Sixty-eight human maxillary central incisors were divided equally into four groups: cold lateral condensation (Group I), SimpliFill (Group II), Thermafil (Group III) and warm vertical compaction (Group IV). After coronal flaring, all four groups were cleaned and shaped with Lightspeed rotary instruments to a size 60 master apical rotary. After obturation Peeso Reamers were used to create a post space for Group I, while Groups 2, 3 and 4 incorporated the post space in the obturation (sectional technique) and did not require making a post space after obturation. The teeth were then stored in 100% humidity for 1 week and then kept in rhodamine B fluorescent dye for 3 weeks. The teeth were then split open, and the linear dye penetration from a coronal to apical direction (coronal seal) was evaluated with a fluorescent light microscope. Statistical analysis showed that Group I (cold lateral condensation followed by post space made with Peeso Reamers) leaked significantly more (P < 0.05) than the remaining three sectional obturation groups. It was concluded that stresses generated during post space preparation might be detrimental to the seal obtained by the obturation. Sectional obturations with their superior sealing ability offer a viable alternative. [source] | ||||||||||