Home About us Contact
|
Home About us Contact | ||
|
|
||
Restorative Dentistry (restorative + dentistry)
Selected AbstractsImproving the quality of clinical teaching in a restorative clinic using student feedbackEUROPEAN JOURNAL OF DENTAL EDUCATION, Issue 2 2008Callum Youngson Abstract Introduction:, A large proportion of the undergraduate curriculum is spent within Restorative Dentistry at the University of Liverpool. As well as supportive "phantom head" courses the undergraduates receive significant amounts of teaching within the clinics themselves. In 2004, to help inform the clinical tutors as to their areas of strengths and weaknesses, undergraduates were invited to complete an anonymous questionnaire on the quality of teaching they received from their clinical supervisors. This process has been repeated subsequently in 2005 and 2006. Method:, A 19 parameter questionnaire, employing a 5-point Likert scale and space for open comments, was circulated to every clinical undergraduate student. Questionnaires were returned anonymously and all data collected by one researcher. Descriptive statistical analysis was performed and the staff provided with individual feedback within the context of the overall departmental profile. The pooled data from each of the years was then compared to determine if any changes had occurred. Statistical analysis used Kruskal Wallis tests to determine whether these were statistically significant. Results:, Although the range varied, median scores of 4 (agree) were gained for each question each year. Following statistical analysis 18 of the parameters showed a statistically significant improvement (P < 0.05) between 2004 and 2006 with only one remaining constant throughout. Conclusion:, It would appear that the use of a questionnaire based feedback system can result in a tangible and demonstrable improvement in the delivery of clinical teaching. [source] Implants and Restorative DentistryJOURNAL OF PROSTHODONTICS, Issue 2 2004Thomas J. Salinas DDS No abstract is available for this article. [source] Precision Attachments: A Link to Successful Restorative DentistryJOURNAL OF PROSTHODONTICS, Issue 4 2000Julie A. Holloway DDS [source] Students' perceptions of seminar and lecture-based teaching in restorative dentistryEUROPEAN JOURNAL OF DENTAL EDUCATION, Issue 3 2000Paul A. Brunton In an era of self-directed learning, it is important to seek the views of dental students regarding their learning experience. Using an anonymous questionnaire, clinical dental students' perceptions of seminar and lecture-based teaching in restorative dentistry were sought. 116 of 136 questionnaires circulated were returned for analysis giving a response rate of 85%. Clinical seminars as opposed to lectures were, in the opinion of the students, a more effective way of learning, more relevant to self-development and more interactive. Seminar-based learning was considered to be more amenable to self-direction than formal didactic lectures. It is concluded that the students included in this study were found to prefer seminar-based learning opportunities as opposed to more traditional styles of learning, specifically, didactic lectures. [source] Subcutaneous emphysema during restorative dentistryINTERNATIONAL JOURNAL OF PAEDIATRIC DENTISTRY, Issue 3 2007ROBERT J. STEELMAN Background., Subcutaneous emphysema is a rare occurrence in the dental setting. When it does occur, the entity may be mistaken for an anaphylactic reaction to a local anaesthetic agent or other medications used in dental surgery. Case Report., During restorative treatment of a left second primary molar air was introduced under an operculum. Communication with submandibular and sublingual spaces to the mediastinum was established. Conclusion., Therapy for subcutaneous emphysema involves, correct diagnosis and antibiotic coverage. Subcutaneous air will resolve over time so observation is indicated. [source] CLINICAL CONSIDERATIONS FOR RESTORING MANDIBULAR INCISORS WITH PORCELAIN LAMINATE VENEERSJOURNAL OF ESTHETIC AND RESTORATIVE DENTISTRY, Issue 4 2008Robert D. Walter DDS Authors Porcelain laminate veneers have been proven to be a successful treatment modality for maxillary incisors in clinical practice and in controlled clinical studies. However, the data in clinical studies on the success of veneers for restoring mandibular incisors are limited. Clinically, the successful restoration of mandibular incisors with porcelain laminate veneers is one of the more challenging procedures in all of esthetic restorative dentistry. Limited coronal dimensions, the small amount of enamel available for bonding (particularly in the cervical areas), materials and techniques for the bonding procedures, and the response of the tooth,veneer complex to forces generated during the incisal loading in both functional as well as parafunctional contacts must be considered as potential sources of success or failure. This Critical Appraisal reviews three recent scientific articles to shed some light on these issues and, as in all research endeavors, leads the reader to identify additional areas of concern that might stimulate further scientific inquiry. The first publication studied predictors for enamel thickness for mandibular incisors. The second examined bonding protocols for exposed dentin and suggested immediate dentin sealing. The third paper addressed fracture behavior of mandibular incisors restored with porcelain laminate veneers in vitro. [source] QUARTZ-TUNGSTEN-HALOGEN AND LIGHT-EMITTING DIODE CURING LIGHTSJOURNAL OF ESTHETIC AND RESTORATIVE DENTISTRY, Issue 3 2006Kraig S. Vandewalle DDS Curing lights are an integral part of the daily practice of restorative dentistry. Quartz-tungsten-halogen (QTH), plasma-arc (PAC), argon laser, and light-emitting diode (LED) curing lights are currently commercially available. The QTH curing light has a long, established history as a workhorse for composite resin polymerization in dental practices and remains the most common type of light in use today. Its relatively broad emission spectrum allows the QTH curing light to predictably initiate polymerization of all known photo-activated resin-based dental materials. However, the principal output from these lamps is infrared energy, with the generation of high heat. Filters are used to reduce the emitted heat energy and provide further restriction of visible light to correlate better with the narrower absorbance spectrum of photo-initiators. The relatively inefficient emission typically requires corded handpieces with noisy fans. PAC lights generate a high voltage pulse that creates hot plasma between two electrodes in a xenon-filled bulb. The irradiance of PAC lights is much higher than the typical QTH curing light, but PAC lights are more expensive and generate very high heat with an inefficient emission spectrum similar to that of QTH bulbs. Light emitted from an argon laser is very different from that emitted from the halogen or PAC lights. The photons produced are coherent and do not diverge; therefore, lasers concentrate more photons of specific frequency into a tiny area. With very little infrared output, unwanted heat is minimized. However, argon lasers are very expensive and inefficient due to a small curing tip. LED curing lights have been introduced to the market with the promise of more efficient polymerization, consistent output over time without degradation, and less heat emission in a quiet, compact, portable device. This review evaluates some of the published research on LED and QTH curing lights. [source] Anterior Esthetic Rehabilitation on Teeth and Dental Implants Optimized with Proceraź Technology: A Case ReportJOURNAL OF ESTHETIC AND RESTORATIVE DENTISTRY, Issue 3 2001PASCAL BONNARD DDS ABSTRACT With the latest developments of the Proceraź system, all-ceramic crowns have become an attractive solution to provide functional and esthetic rehabilitation on teeth and dental implants. The Procera AllCeram crown and Procera Abutment embrace the concept of computer-assisted design and computer-assisted machining (CAD/CAM) and can be used together for optimal esthetic result. The purpose of this case report was to illustrate the advantages of these new components for complex anterior rehabilitation. Three natural teeth and a Procera Abutment were restored using four Procera AllCeram crowns. Treatment planning and esthetic benefits are discussed. CLINICAL SIGNIFICANCE For complex anterior rehabilitations, the Procera system fulfills both functional and esthetic objectives, providing a new way in the field of esthetic and restorative dentistry. Nevertheless, planning and preparation stages are decisive for successful treatment. [source] Influence of occlusal vertical dimension on the masticatory performance during chewing with maxillary splintsJOURNAL OF ORAL REHABILITATION, Issue 8 2007L. W. OLTHOFF summary, Changing the occlusal vertical dimension is a common procedure in restorative dentistry, during treatment of patients with cranio-mandibular disorders, and during orthodontic and orthognathic treatment. The treatment may alter the length of the main jaw elevator muscles and the position of the mandibular head in the fossa temporalis. These changes may influence the bite forces that are generated during chewing and thus may affect the masticatory function. We measured the objective masticatory function, defined as masticatory performance, by determining an individual's capacity to pulverize a test food. The immediate influence of the increase in the occlusal vertical dimension on the masticatory performance was determined using three anatomical maxillary splints in a group of seven dentate subjects. The splints gave an increase in the occlusal vertical dimension of 2, 4 and 6 mm, respectively. Before we started the experiments the subjects practiced chewing with the splints during about 5 min. No significant differences were observed in masticatory performance among the conditions without and with the three splints. Thus, an increase in the occlusal vertical dimension up to 6 mm did not have a significant effect on the masticatory performance. Maxillary splints may be used to study the effect of occlusal factors on the chewing process by manipulating tooth shape and occlusal area of the splint. [source] Effect of CaF2 and CaO Substituted for MgO on the Phase Evolution and Mechanical Properties of K-Fluorrichterite Glass CeramicsJOURNAL OF THE AMERICAN CERAMIC SOCIETY, Issue 2 2006Mehdi Mirsaneh Chain silicate glass ceramics based on K-fluorrichterite (KNaCaMg5Si8O22F2, KFR) have potential for use in restorative dentistry and biomedical applications because they may be cast to shape and, when cerammed, have high biaxial flexural strength and fracture toughness. Excess CaO in canasite-based chain silicate compositions is known to enhance their bioactivity. Therefore, two new glass ceramic compositions have been fabricated with 5 mol% CaF2 (Glass A) and 5 mol% CaO (Glass B) substituted for MgO in the KFR formula unit. The phase evolution of Glasses A and B was studied in detail using X-ray diffraction and transmission electron microscopy. In addition, their mechanical properties were assessed. For Glass A, the fracture toughness (FT=2.66±0.02 MPa·m1/2) and biaxial flexural strength (BFS=227.3±24.5 MPa) were optimized for samples heat treated at 900°C for 4 h. In Glass B, however, the best FT (2.08±0.02 MPa·m1/2) and BFS (217.4±4.4 MPa) were obtained at 950°C. In view of their excellent mechanical properties and castability, Glasses A and B are considered potential candidates for fabrication of custom medical devices in restorative dentistry and moderate load-bearing reconstructive bone surgery. [source] Ridge preservation: what is it and when should it be consideredAUSTRALIAN DENTAL JOURNAL, Issue 1 2008I Darby Abstract The resorption of bone following extraction may present a significant problem in implant and restorative dentistry. Ridge preservation is a technique whereby the amount of bone loss is limited. This paper discusses the scientific literature examining the healing post-extraction and ridge preserving techniques, primarily from the perspective of implant dentistry. Some indications for ridge preservation and methods considered appropriate are discussed. [source] | ||||||||||