Home About us Contact
|
Home About us Contact | ||
|
|
||
Attractive Electrostatic Interactions (attractive + electrostatic_interaction)
Selected AbstractsThe experimental and theoretical QTAIMC study of the atomic and molecular interactions in dinitrogen tetroxideACTA CRYSTALLOGRAPHICA SECTION B, Issue 5 2009Vladimir G. Tsirelson The atomic and molecular interactions in a crystal of dinitrogen tetraoxide, ,-N2O4, have been studied in terms of the quantum topological theory of molecular structure using high-resolution, low-temperature X-ray diffraction data. The experimental electron density and electrostatic potential have been reconstructed with the Hansen,Coppens multipole model. In addition, the three-dimensional periodic electron density of crystalline ,-N2O4 has been calculated at the B3LYP/cc-pVDZ level of theory with and without the geometry optimization. The application of the quantum theory of atoms in molecules and crystals (QTAIMC) recovered the two types of intermolecular bond paths between O atoms in crystalline ,-N2O4, one measuring 3.094, the other 3.116,Å. The three-dimensional distribution of the Laplacian of the electron density around the O atoms showed that the lumps in the negative Laplacian fit the holes on the O atoms in the adjacent molecules, both atoms being linked by the intermolecular bond paths. This shows that the Lewis-type molecular complementarity contributes significantly to intermolecular bonding in crystalline N2O4. Partial overlap of atomic-like basins created by zero-flux surfaces in both the electron density and the electrostatic potential show that attractive electrostatic interaction exists between O atoms even though they carry the same net formal charge. The exchange and correlation contributions to the potential energy density were also computed by means of the model functionals, which use the experimental electron density and its derivatives. It was found that the intermolecular interactions in ,-N2O4 are accompanied by the correlation energy-density `bridges' lowering the local potential energy along the intermolecular O...O bond paths in the electron density, while the exchange energy density governs the shape of bounded molecules. [source] The influence of relative humidity on the cohesion properties of micronized drugs used in inhalation therapyJOURNAL OF PHARMACEUTICAL SCIENCES, Issue 3 2004Paul M. Young Abstract The influence of relative humidity (RH) on the cohesion properties of three drugs: salbutamol sulphate (SS), triamcinolone acetonide (TAA), and disodium cromoglycate (DSCG) was investigated using the atomic force microscope (AFM) colloidal probe technique. Micronized drug particles were mounted in heat-sensitive epoxy resin for immobilization. Multiple AFM force,distance curves were conducted between each drug probe and the immobilized drug particulates at 15, 45, and 75% RH using Force,Volume imaging. Clear variations in the cohesion profile with respect to RH were observed for all three micronized drugs. The calculated force and energy of cohesion to separate either micronized SS or DSCG increased as humidity was raised from 15 to 75% RH, suggesting capillary forces become a dominating factor at elevated RH. In comparison, the separation force and energy for micronized TAA particles decreased with increased RH. This behavior may be attributed to long-range attractive electrostatic interactions, which were observed in the approach cycle of the AFM force,distance curves. These observations correlated well with previous aerosolization studies of the three micronized drugs. © 2004 Wiley-Liss, Inc. and the American Pharmacists Association J Pharm Sci 93: 753,761, 2004 [source] Morphology and the strength of intermolecular contacts in protein crystalsACTA CRYSTALLOGRAPHICA SECTION D, Issue 8 2003Yoshiki Matsuura The strengths of intermolecular contacts (macrobonds) and the areas occupied by each contact on the molecular surface were estimated in four polymorphic modifications of lysozyme crystals based on the bond strengths between individual atomic pairs belonging to the molecules in contact. It has been shown that the periodic bond chains of these macrobonds account for the morphology of protein crystals. The Coulombic contribution to the macrobond strength has also been estimated. Making use of the contact strengths and taking into account bond hydration, crystal,water interfacial energies were also estimated for different crystal faces. The areas of all contacts are mapped on the molecular surface, making use of a polar-coordinate representation of the contact. Comparing the locations of the intermolecular contacts in the different polymorphic crystal modifications, it is shown that these contacts can form a wide variety of patches on the molecular surface. The patches are located practically everywhere on the surface except for the inside of a concave active site. It is also shown that the contacts, which frequently involve water molecules, are formed by specific intermolecular hydrogen bonds on a background of non-specific attractive electrostatic interactions. Typical values of the macrobond strength are compared with the strength of association in other protein-complex systems. [source] Invertase-Lipid Biocomposite Films: Preparation, Characterization, and Enzymatic ActivityBIOTECHNOLOGY PROGRESS, Issue 1 2004Sumant Phadtare The formation of biocomposite films of the industrially important enzyme invertase and fatty lipids under enzyme-friendly conditions is described. The approach involves a simple beaker-based diffusion protocol wherein invertase diffuses into the cationic lipid octadecylamine during immersion of the lipid film in the enzyme solution. Entrapment of invertase in the octadecylamine film is highly pH-dependent, underlining the role of attractive electrostatic interactions between the enzyme and the lipid in the biocomposite film formation. The kinetics of formation of the enzyme-lipid biocomposites has been studied by quartz crystal microgravimetry (QCM) measurements. The stability of the enzyme in the lipid matrix was confirmed by fluorescence spectroscopy and biocatalytic activity measurements. The biocatalytic activity of the invertase-lipid biocomposite films was comparable to that of the free enzyme in solution and showed marginally higher temperature stability. Particularly exciting was the excellent reuse characteristics of the biocomposite films, indicating potential industrial application of these films. [source] Progress in the Understanding of Drug,Receptor Interactions, Part,2: Experimental and Theoretical Electrostatic Moments and Interaction Energies of an Angiotensin II Receptor Antagonist (C30H30N6O3S)CHEMISTRY - A EUROPEAN JOURNAL, Issue 24 2007Raffaella Soave Dr. Abstract A combined experimental and theoretical charge density study of an angiotensin II receptor antagonist (1) is presented focusing on electrostatic properties such as atomic charges, molecular electric moments up to the fourth rank and energies of the intermolecular interactions, to gain an insight into the physical nature of the drug,receptor interaction. Electrostatic properties were derived from both the experimental electron density (multipole refinement of X-ray data collected at T=17,K) and the ab initio wavefunction (single molecule and fully periodic calculations at the DFT level). The relevance of S,,,O and S,,,N intramolecular interactions on the activity of 1 is highlighted by using both the crystal and gas-phase geometries and their electrostatic nature is documented by means of QTAIM atomic charges. The derived electrostatic properties are consistent with a nearly spherical electron density distribution, characterised by an intermingling of electropositive and -negative zones rather than by a unique electrophilic region opposed to a nucleophilic area. This makes the first molecular moment scarcely significant and ill-determined, whereas the second moment is large, significant and highly reliable. A comparison between experimental and theoretical components of the third electric moment shows a few discrepancies, whereas the agreement for the fourth electric moment is excellent. The most favourable intermolecular bond is show to be an NH,,,N hydrogen bond with an energy of about 50,kJ,mol,1. Key pharmacophoric features responsible for attractive electrostatic interactions include CH,,,X hydrogen bonds. It is shown that methyl and methylene groups, known to be essential for the biological activity of the drug, provide a significant energetic contribution to the total binding energy. Dispersive interactions are important at the thiophene and at both the phenyl fragments. The experimental estimates of the electrostatic contribution to the intermolecular interaction energies of six molecular pairs, obtained by a new model proposed by Spackman, predict the correct relative electrostatic energies with no exceptions. [source] | ||||||||||