Home About us Contact
|
Home About us Contact | ||
|
|
||
ATRP Systems (atrp + system)
Selected AbstractsPreparation of polyacrylonitrile with improved isotacticity and low polydispersityJOURNAL OF APPLIED POLYMER SCIENCE, Issue 5 2010Jianguo Jiang Abstract The preparation of a polymer with both low polydispersity and high tacticity is one current challenge we face and warrants thorough investigation from both the theoretical and experimental standpoints. In this study, we synthesized polyacrylonitrile (PAN) with simultaneously controlled molecular weight and tacticity on the basis of the strategy of the atom transfer radical polymerization (ATRP) of acrylonitrile (AN) in the presence of Lewis acids. A new combined initiation system of 3-bromopropionitrile (3-BPN)/Cu2O/N,N,N,,N,-tetramethylethylenediamine (TMEDA) was used for the ATRP of AN for the first time. When the polymerization was performed with the ratio [AN]0/[Initiator]0/[Cu2O]0/[TMEDA]0 = 190/1/0.5/1.5 (where the subscript 0 indicates the initial conditions) in ethylene carbonate at 60°C for 48 h, the polydispersity of the obtained PAN was 1.13, and the molecular weight was up to 13,710. The polymerization kinetics results show that the polymerizations proceeded with a living/controlled nature except that an induction period existed during the polymerization process because of the lower initiating activity of 3-BPN. Also, two kinds of Lewis acid, AlCl3 and yttrium trifluororomethanesulflnate, were used in the ATRP system of AN for the tacticity control. The addition of 0.01 equiv (relative to AN) of the Lewis acid AlCl3 in the polymerization afforded PAN with an improved isotacticity [meso/meso triad (mm) = 0.32] and a very narrow polydispersity (1.06). © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010 [source] Atom transfer radical polymerization of n -butyl acrylate catalyzed by CuBr/N -(n -hexyl)-2-pyridylmethanimineJOURNAL OF POLYMER SCIENCE (IN TWO SECTIONS), Issue 21 2002Huiqi Zhang Abstract The homogeneous atom transfer radical polymerization (ATRP) of n -butyl acrylate with CuBr/N -(n -hexyl)-2-pyridylmethanimine as a catalyst and ethyl 2-bromoisobutyrate as an initiator was investigated. The kinetic plots of ln([M]0/[M]) versus the reaction time for the ATRP systems in different solvents such as toluene, anisole, N,N -dimethylformamide, and 1-butanol were linear throughout the reactions, and the experimental molecular weights increased linearly with increasing monomer conversion and were very close to the theoretical values. These, together with the relatively narrow molecular weight distributions (polydispersity index , 1.40 in most cases with monomer conversion > 50%), indicated that the polymerization was living and controlled. Toluene appeared to be the best solvent for the studied ATRP system in terms of the polymerization rate and molecular weight distribution among the solvents used. The polymerization showed zero order with respect to both the initiator and the catalyst, probably because of the presence of a self-regulation process at the beginning of the reaction. The reaction temperature had a positive effect on the polymerization rate, and the optimum reaction temperature was found to be 100 °C. An apparent enthalpy of activation of 81.2 kJ/mol was determined for the ATRP of n -butyl acrylate, corresponding to an enthalpy of equilibrium of 63.6 kJ/mol. An apparent enthalpy of activation of 52.8 kJ/mol was also obtained for the ATRP of methyl methacrylate under similar reaction conditions. Moreover, the CuBr/N -(n -hexyl)-2-pyridylmethanimine-based system was proven to be applicable to living block copolymerization and living random copolymerization of n -butyl acrylate with methyl methacrylate. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 3549,3561, 2002 [source] Iron halide mediated atom transfer radical polymerization of methyl methacrylate with N -alkyl-2-pyridylmethanimine as the ligandJOURNAL OF POLYMER SCIENCE (IN TWO SECTIONS), Issue 19 2004Huiqi Zhang Abstract The controlled atom transfer radical polymerization (ATRP) of methyl methacrylate (MMA) catalyzed by iron halide/N -(n -hexyl)-2-pyridylmethanimine (NHPMI) is described. The ethyl 2-bromoisobutyrate (EBIB)-initiated ATRP with [MMA]0/[EBIB]0/[iron halide]0/[NHPMI]0 = 150/1/1/2 was better controlled in 2-butanone than in p -xylene at 90 °C. Initially added iron(III) halide improved the controllability of the reactions in terms of molecular weight control. The p -toluenesulfonyl chloride (TsC1)-initiated ATRP were uncontrolled with [MMA]0/[TsC1]0/[iron halide]0/[NHPMI]0 = 150/1/1/2 in 2-butanone at 90 °C. In contrast to the EBIB-initiated system, the initially added iron(III) halide greatly decreased the controllability of the TsC1-initiated ATRP. The ration of iron halide to NHPMI significantly influenced the controllability of both EBIB and TsC1-initiated ATRP systems. The ATRP with [MMA]0/[initiator]0/[iron halide]0/[NHPMI]0 = 150/1//1/2 provided polymers with PDIs , 1.57, whereas those with [iron halide]0/[NHPMI]0 = 1 resulted in polymers with PDIs as low as 1.35. Moreover, polymers with PDIs of approximately 1.25 were obtained after their precipitation from acidified methanol. The high functionality of the halide end group in the obtained polymer was confirmed by both 1H NMR and a chain-extenstion reaction. Cyclic voltammetry was utilized to explain the differing catalytic behaviors of the in situ -formed complexes by iron halide and NHPMI with different molar ratios. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4882,4894, 2004 [source] Atom transfer radical polymerization of n -butyl acrylate catalyzed by CuBr/N -(n -hexyl)-2-pyridylmethanimineJOURNAL OF POLYMER SCIENCE (IN TWO SECTIONS), Issue 21 2002Huiqi Zhang Abstract The homogeneous atom transfer radical polymerization (ATRP) of n -butyl acrylate with CuBr/N -(n -hexyl)-2-pyridylmethanimine as a catalyst and ethyl 2-bromoisobutyrate as an initiator was investigated. The kinetic plots of ln([M]0/[M]) versus the reaction time for the ATRP systems in different solvents such as toluene, anisole, N,N -dimethylformamide, and 1-butanol were linear throughout the reactions, and the experimental molecular weights increased linearly with increasing monomer conversion and were very close to the theoretical values. These, together with the relatively narrow molecular weight distributions (polydispersity index , 1.40 in most cases with monomer conversion > 50%), indicated that the polymerization was living and controlled. Toluene appeared to be the best solvent for the studied ATRP system in terms of the polymerization rate and molecular weight distribution among the solvents used. The polymerization showed zero order with respect to both the initiator and the catalyst, probably because of the presence of a self-regulation process at the beginning of the reaction. The reaction temperature had a positive effect on the polymerization rate, and the optimum reaction temperature was found to be 100 °C. An apparent enthalpy of activation of 81.2 kJ/mol was determined for the ATRP of n -butyl acrylate, corresponding to an enthalpy of equilibrium of 63.6 kJ/mol. An apparent enthalpy of activation of 52.8 kJ/mol was also obtained for the ATRP of methyl methacrylate under similar reaction conditions. Moreover, the CuBr/N -(n -hexyl)-2-pyridylmethanimine-based system was proven to be applicable to living block copolymerization and living random copolymerization of n -butyl acrylate with methyl methacrylate. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 3549,3561, 2002 [source] Concurrent Initiation by Air in the Atom Transfer Radical Polymerization of Methyl MethacrylateMACROMOLECULAR CHEMISTRY AND PHYSICS, Issue 9 2003Ajaya Kumar Nanda Abstract The effect of air in atom transfer radical polymerization (ATRP) of methyl methacrylate (MMA) was studied. Air initiated polymerization was clearly noticed by the appearance of a low molecular weight peak in the synthesis of high molecular weight poly(isobutylene)- graft -poly(methyl methacrylate) (Mn,=,5.0,×,105 g/mol). The concentration of chains initiated by oxygen (air) was ,8,×,10,4 mol/L, determined using the Gladstone-Dale relationship. The tentatively proposed mechanism for air initiated polymerization was supported by kinetic studies. Similar to typical ATRP systems, the rate of air initiated polymerization increased with temperature, [MMA], amount of air, and activity of the catalyst complex. Polymers with lower polydispersities (Mw/Mn,=,1.13) were obtained in the presence of Cu(II) as compared to Cu(I) catalyst complex system. Kinetic plots for the air initiated bulk polymerization of MMA at (,) 20,°C, (,) 50,°C, and (,) 90,°C. [source] Kinetic Modeling of Normal ATRP, Normal ATRP with [CuII]0, Reverse ATRP and SR&NI ATRPMACROMOLECULAR THEORY AND SIMULATIONS, Issue 7-8 2008Wei Tang Abstract The kinetics of various ATRP systems, including normal ATRP, normal ATRP in the presence of initially-added CuII, reverse ATRP and SR&NI ATRP were modeled using Predici software. The instantaneous kinetic chain length was introduced for ATRP and was used for the prediction of control over polymerization. Equations were derived to estimate the radical concentration at the quasi-steady-state. Normal ATRP experiences a continuous decrease of radical concentration leading to a decrease of polymerization rate; in contrast, SR&NI ATRP undergoes a continuous increase in radical concentration, leading to an increase of the polymerization rate. All of these ATRP methods can afford a relatively fast polymerization rate and retain good polymerization control. [source] | ||||||||||