Home About us Contact
|
Home About us Contact | ||
|
|
||
Primary Flow (primary + flow)
Selected AbstractsVariability of the recent climate of eastern AfricaINTERNATIONAL JOURNAL OF CLIMATOLOGY, Issue 6 2004Carl J. Schreck III Abstract The primary objective of this study is to investigate the recent variability of the eastern African climate. The region of interest is also known as the Greater Horn of Africa (GHA), and comprises the countries of Burundi, Djibouti, Eritrea, Ethiopia, Kenya, Rwanda, Somalia, Sudan, Uganda, and Tanzania. The analysis was based primarily on the construction of empirical orthogonal functions (EOFs) of gauge rainfall data and on CPC Merged Analysis of Precipitation (CMAP) data, derived from a combination of rain-gauge observations and satellite estimates. The investigation is based on the period 1961,2001 for the ,short rains' season of eastern Africa of October through to December. The EOF analysis was supplemented by projection of National Centers for Environmental Prediction wind data onto the rainfall eigenmodes to understand the rainfall,circulation relationships. Furthermore, correlation and composite analyses have been performed with the Climatic Research Unit globally averaged surface-temperature time series to explore the potential relationship between the climate of eastern Africa and global warming. The most dominant mode of variability (EOF1) based on CMAP data over eastern Africa corresponds to El Niño,southern oscillation (ENSO) climate variability. It is associated with above-normal rainfall amounts during the short rains throughout the entire region, except for Sudan. The corresponding anomalous low-level circulation is dominated by easterly inflow from the Indian Ocean, and to a lesser extent the Congo tropical rain forest, into the positive rainfall anomaly region that extends across most of eastern Africa. The easterly inflow into eastern Africa is part of diffluent outflow from the maritime continent during the warm ENSO events. The second eastern African EOF (trend mode) is associated with decadal variability. In distinct contrast from the ENSO mode pattern, the trend mode is characterized by positive rainfall anomalies over the northern sector of eastern Africa and opposite conditions over the southern sector. This rainfall trend mode eluded detection in previous studies that did not include recent decades of data, because the signal was still relatively weak. The wind projection onto this mode indicates that the primary flow that feeds the positive anomaly region over the northern part of eastern Africa emanates primarily from the rainfall-deficient southern region of eastern Africa and Sudan. Although we do not assign attribution of the trend mode to global warming (in part because of the relatively short period of analysis), the evidence, based on our results and previous studies, strongly suggests a potential connection. Copyright © 2004 Royal Meteorological Society. [source] Comparative velocity investigations in cerebral arteries and aneurysms: 3D phase-contrast MR angiography, laser Doppler velocimetry and computational fluid dynamicsNMR IN BIOMEDICINE, Issue 8 2009Dorothea I. Hollnagel Abstract In western populations, cerebral aneurysms develop in approximately 4% of humans and they involve the risk of rupture. Blood flow patterns are of interest for understanding the pathogenesis of the lesions and may eventually contribute to deciding on the most efficient treatment procedure for a specific patient. Velocity mapping with phase-contrast magnetic resonance angiography (PC-MRA) is a non-invasive method for performing in vivo measurements on blood velocity. Several hemodynamic properties can either be derived directly from these measurements or a flow field with all its parameters can be simulated on the basis of the measurements. For both approaches, the accuracy of the PC-MRA data and subsequent modeling must be validated. Therefore, a realistic transient flow field in a well-defined patient-specific silicone phantom was investigated. Velocity investigations with PC-MRA in a 3,Tesla MR scanner, laser Doppler velocimetry (LDV) and computational fluid dynamics (CFD) were performed in the same model under equal flow conditions and compared to each other. The results showed that PC-MRA was qualitatively similar to LDV and CFD, but showed notable quantitative differences, while LDV and CFD agreed well. The accuracy of velocity quantification by PC-MRA was best in straight artery regions with the measurement plane being perpendicular to the primary flow direction. The accuracy decreased in regions with disturbed flow and in cases where the measurement plane was not perpendicular to the primary flow. Due to these findings, it is appropriate to use PC-MRA as the inlet and outlet conditions for numerical simulations to calculate velocities and shear stresses in disturbed regions like aneurysms, rather than derive these values directly from the full PC-MRA measured velocity field. Copyright © 2009 John Wiley & Sons, Ltd. [source] Computational Fluid Dynamics Analysis of Blade Tip Clearances on Hemodynamic Performance and Blood Damage in a Centrifugal Ventricular Assist DeviceARTIFICIAL ORGANS, Issue 5 2010Jingchun Wu Abstract An important challenge facing the design of turbodynamic ventricular assist devices (VADs) intended for long-term support is the optimization of the flow path geometry to maximize hydraulic performance while minimizing shear-stress-induced hemolysis and thrombosis. For unshrouded centrifugal, mixed-flow and axial-flow blood pumps, the complex flow patterns within the blade tip clearance between the lengthwise upper surface of the rotating impeller blades and the stationary pump housing have a dramatic effect on both the hydrodynamic performance and the blood damage production. Detailed computational fluid dynamics (CFD) analyses were performed in this study to investigate such flow behavior in blade tip clearance region for a centrifugal blood pump representing a scaled-up version of a prototype pediatric VAD. Nominal flow conditions were analyzed at a flow rate of 2.5 L/min and rotor speed of 3000 rpm with three blade tip clearances of 50, 100, and 200 µm. CFD simulations predicted a decrease in the averaged tip leakage flow rate and an increase in pump head and axial thrust with decreasing blade tip clearances from 200 to 50 µm. The predicted hemolysis, however, exhibited a unimodal relationship, having a minimum at 100 µm compared to 50 µm and 200 µm. Experimental data corroborate these predictions. Detailed flow patterns observed in this study revealed interesting fluid dynamic features associated with the blade tip clearances, such as the generation and dissipation of tip leakage vortex and its interaction with the primary flow in the blade-blade passages. Quantitative calculations suggested the existence of an optimal blade tip clearance by which hydraulic efficiency can be maximized and hemolysis minimized. [source] Flow Visualization Study of a Novel Respiratory Assist CatheterARTIFICIAL ORGANS, Issue 6 2009Stephanus G. Budilarto Abstract Respiratory assist using intravenous catheters may be a potential therapy for patients with acute and acute-on-chronic lung failure. An important design constraint is respiratory catheter size, and new strategies are needed that enable size reduction while maintaining adequate gas exchange. Our group is currently developing a percutaneous respiratory assist catheter (PRAC) that uses a rotating bundle of hollow fiber membranes to enhance CO2 removal and O2 supply with increasing bundle rotation rate. In this study, particle image velocimetry (PIV) was used to analyze the fluid flow patterns and velocity fields surrounding the rotating fiber bundle of the PRAC. The goal of the study was to assess the rotational flow patterns within the context of the gas exchange enhancement that occurs with increasing fiber bundle rotation. A PRAC prototype was placed in a 1-in. internal diameter test section of an in vitro flow loop designed specifically for PIV studies. The rotation rate of the PRAC was varied between 500 and 7000 rpm, and PIV was used to determine the velocity fields in the primary (r -,) and secondary (r - z) flow planes. The secondary flow exhibited time-varying and incoherent vortices that were consistent with the classical Taylor vortices expected for Taylor numbers (Ta) corresponding to the rotation speeds studied (2200 < Ta < 31 000). In the primary flow, the tangential velocity exhibited boundary layers of less than ½ mm adjacent to the fiber bundle and vessel wall. The estimated shear stress associated with the Taylor vortices was approximately 11 dyne/cm2 at 7000 rpm and was over 10 times smaller than the shear stress in the primary flow boundary layers. [source] | ||||||||||