Home About us Contact | |||
Preliminary Experimental Results (preliminary + experimental_result)
Selected AbstractsCharacterization of voltage degradation in dynamic field gradient focusingELECTROPHORESIS, Issue 5 2008Jeffrey M. Burke Abstract Dynamic field gradient focusing (DFGF) is an equilibrium gradient method that utilizes an electric field gradient to simultaneously separate and concentrate charged analytes based on their individual electrophoretic mobilities. This work describes the use of a 2-D nonlinear, numerical simulation to examine the impact of voltage loss from the electrodes to the separation channel, termed voltage degradation, and distortions in the electric field on the performance of DFGF. One of the design parameters that has a large impact on the degree of voltage degradation is the placement of the electrodes in relation to the separation channel. The simulation shows that a distance of about 3,mm from the electrodes to the separation channel gives the electric field profile with least amount of voltage degradation. The simulation was also used to describe the elution of focused protein peaks. The simulation shows that elution under constant electric field gradient gives better performance than elution through shallowing of the electric field. Qualitative agreement between the numerical simulation and experimental results is shown. The simulation also illustrates that the presence of a defocusing region at the cathodic end of the separation channel causes peak dispersion during elution. The numerical model is then used to design a system that does not suffer from a defocusing region. Peaks eluted under this design experienced no band broadening in our simulations. Preliminary experimental results using the redesigned chamber are shown. [source] Numeric Simulation of Ion-Site Association Effects in Ion-Selective Electrode ResponseELECTROANALYSIS, Issue 15-16 2003Konstantin Abstract Effects in ion-selective electrode response and selectivity, caused by ion-site association in membranes are studied by means of numeric simulations based on a generalized model, which does not rely on a certain degree of the dissociation of electrolytes in membranes. The variability of the experimental values of the potentiometric selectivity coefficients is considered in view of the association in membranes. The reasons why the "dissociation approach" often fits experimental data are also discussed. A novel version of segmented sandwich membrane method is proposed for direct potentiometric measurements of ion-site association constants in membranes, and preliminary experimental results are presented. [source] MEASUREMENT OF FIRMNESS OF FRESH-CUT SLICED TOMATO USING PUNCTURE TESTS , STUDIES ON SAMPLE SIZE, PROBE SIZE AND DIRECTION OF PUNCTUREJOURNAL OF TEXTURE STUDIES, Issue 5 2007MILZA M. LANA ABSTRACT In order to investigate the firmness of tomato slices, two experiments were performed. In the first one, Monte Carlo simulation was used to study the variation in firmness within and between slices. Adding more slices and more measurements per slice reduced the SD, but in general, the efficiency of adding more slices was higher. In the second experiment, the firmness of tomato slices was measured by puncture test during storage, using one of three flat-tipped cylindrical probes (3.5-, 2.5- and 1.5-mm diameter) in two directions, along or perpendicular to the main axis of the fruit. Changes in firmness were studied by nonlinear regression analysis. The same model could be applied to all combinations of probe size and direction with the same correction for shear and compression. It suggests that shear and compression forces decay with storage time according to the same mechanism, irrespective of the measurement direction. PRACTICAL APPLICATIONS Methodologies for both firmness evaluation and data analysis were presented. Monte Carlo simulation was used to optimize the number of samples for firmness assays. After calculating the experimental SD from preliminary experimental results, simulations were performed with different numbers of replicates and measurements per replicate, to find an optimal experimental design where the SD is minimized. Using nonlinear regression, the effects on firmness of probe size, puncture direction in relation to the plant tissue and storage time can be analyzed simultaneously. The incorporation of a correction factor to account for differences in firmness due to probe size was proposed. The relative influence of shear (s) and compression force (c) on the observed force is estimated. Results of interest for the industry were presented, confirming previous findings that the firmness of ripened tomato slices measured by puncture analysis does not change significantly during short-term storage at low temperature. [source] ZnO nanowires: chemical growth, electrodeposition, and application to intracellular nano-sensorsPHYSICA STATUS SOLIDI (C) - CURRENT TOPICS IN SOLID STATE PHYSICS, Issue 9 2008M. Willander Abstract In this paper we present our results on growth, characterization, and nano-devices based on ZnO nano-structures. The ZnO nano-structures were grown by mainly two methods, the catalytic Vapor Liquid Solid (VLS) and the low temperature chemical growth. We show that by multiple coating combined with low temperature chemical growth, well aligned with size controlled ZnO nanowires on silicon substrates can be achieved. The dissolution, due to its important on the stability of ZnO nano-structures in aqueous medium, is then discussed and some preliminary experimental results are shown. Basic Optical characteristics of ZnO nano-rods are briefly discussed. Finally, electrochemical intracellular nano-sensors based on ZnO nano-wires are demonstrated as efficient nano-sensors for monitoring the human cell activity with minute pH changes. (© 2008 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim) [source] |