Home About us Contact
|
Home About us Contact | ||
|
|
||
Phase Data (phase + data)
Selected AbstractsRegional tomographic inversion of the amplitude and phase of Rayleigh waves with 2-D sensitivity kernelsGEOPHYSICAL JOURNAL INTERNATIONAL, Issue 3 2006Yingjie Yang SUMMARY In this study, we test the adequacy of 2-D sensitivity kernels for fundamental-mode Rayleigh waves based on the single-scattering (Born) approximation to account for the effects of heterogeneous structure on the wavefield in a regional surface wave study. The calculated phase and amplitude data using the 2-D sensitivity kernels are compared to phase and amplitude data obtained from seismic waveforms synthesized by the pseudo-spectral method for plane Rayleigh waves propagating through heterogeneous structure. We find that the kernels can accurately predict the perturbation of the wavefield even when the size of anomaly is larger than one wavelength. The only exception is a systematic bias in the amplitude within the anomaly itself due to a site response. An inversion method of surface wave tomography based on the sensitivity kernels is developed and applied to synthesized data obtained from a numerical simulation modelling Rayleigh wave propagation over checkerboard structure. By comparing recovered images to input structure, we illustrate that the method can almost completely recover anomalies within an array of stations when the size of the anomalies is larger than or close to one wavelength of the surface waves. Surface wave amplitude contains important information about Earth structure and should be inverted together with phase data in surface wave tomography. [source] A radiomagnetotelluric survey on an oil-contaminated area near the Brazi Refinery, RomaniaGEOPHYSICAL PROSPECTING, Issue 3 2005B. Tezkan ABSTRACT Scalar radiomagnetotelluric measurements were carried out on a contaminated test area close to the Brazi Refinery in Romania in order to detect and to monitor a 1 m thick oil layer expected at 5 m depth. Radio transmitters broadcasting in a frequency range from 10 kHz to 300 kHz were selected to observe the apparent resistivity and the phase data associated with the E- and B-polarizations. They were located parallel and perpendicular to the assumed strike direction of the contamination plume. The data were interpreted by a 2D inversion technique from which the conductivity structure of the area was derived. The 2D inversion models of all profiles on the contaminated area show a poor-conductivity zone above the groundwater table which could be associated with the oil contamination. A first attempt was also made to monitor the contaminated layer: the radiomagnetotelluric measurements were repeated on the same profiles a year later, but this time in a dry period, not in a rainy one. The 2D inversion results of the measurements in the dry period indicate that the high-resistivity layer moved closer to the surface. Additional reference measurements were then carried out on a non-contaminated area situated at a distance from the refinery, in the opposite direction to the flow of the groundwater. These reference measurements were used for the derivation of the unperturbed geology and they were also compared with the measurements of the contaminated test area. There is a significant difference in the frequency dependences of the apparent resistivities of the reference and contaminated areas, which could indicate a contamination at shallow depth. The 2D inversion results show the increase of resistivity at a depth of about 5 m beneath the contaminated area where the oil contamination is expected according to the information from the boreholes. [source] Solvent-mediated solid phase transformations of carbamazepine: Effects of simulated intestinal fluid and fasted state simulated intestinal fluidJOURNAL OF PHARMACEUTICAL SCIENCES, Issue 3 2009Paula Lehto Abstract Solvent-mediated transformations of carbamazepine (CBZ) anhydrate form III were investigated in Simulated Intestinal Fluid, a simple USP buffer medium, and in FaSSIF, which contains sodium taurocholate (STC) and lecithin, important surfactants that solubilize lipophilic drugs and lipids in the gastrointestinal tract. Raman spectroscopy (in situ) was utilized to reveal the connection between the changes in solid phase composition and dissolution rate while simultaneously detecting the solid state and the dissolved amount of CBZ. Initial dissolution rate was clearly higher in FaSSIF, while the solid phase data revealed that the crystallization of CBZ dihydrate was inhibited in both the dissolution media, albeit by different mechanisms. In SIF this inhibition was related to extensive needle growth, which impeded medium contact with the solid surface by forming a sterical barrier leading to retarded crystallization rates. Morphological changes from the needle-like dihydrate crystals to plate-like counterparts in FaSSIF, combined with the information that the transformation process was leveled off, evidenced strong hydrogen bonding behavior between the CBZ and STC molecules. These results underline the importance of biologically representative dissolution media in linking the in vitro dissolution results of solids that are capable of hydrate formation to their in vivo dissolution behavior. © 2008 Wiley-Liss, Inc. and the American Pharmacists Association J Pharm Sci 98:985,996, 2009 [source] Numerical simulation of a permittivity probe for measuring the electric properties of planetary regolith and application to the near-surface region of asteroids and cometsMETEORITICS & PLANETARY SCIENCE, Issue 6 2008Klaus SPITZER Our simulation techniques aim at accompanying hardware development and conducting virtual experiments, e.g., to assess the response of arbitrary heterogeneous conductivity and permittivity distributions or to scrutinize possibilities for spatial reconstruction methods using inverse schemes. In a first step, we have developed a finite element simulation code on the basis of unstructured, adaptive triangular grids for arbitrary two-dimensional axisymmetric distributions of conductivity and permittivity. The code is able to take into account the spatial geometry of the probe and allows for possible inductive effects. In previous studies, the non-inductive approach has been used to convert potential and phase data into apparent material properties. By our simulations, we have shown that this approach is valid for the frequency range from 102 Hz to 107 Hz and electric conductivities of 10,8 S/m that are typical for the near-surface region of asteroids and comets composed of chondritic materials and/or frozen volatiles such as H2O and CO2 ice. We prove the accuracy of our code to be better than 10%, using mixed types of boundary conditions and present a simulated vertical log through a horizontally stratified subsurface layer as a representative example of a heterogeneous distribution of the electrical properties. Resolution studies for the given electrode separation reveal that the material parameters of layers having thicknesses of less than about half the electrode spread are not reconstructible if only apparent quantities are considered. Therefore, spatial distributions of the complex sensitivity are presented having in mind a future data inversion concept that will permit the multi-dimensional reconstruction of material parameters in heterogeneous environments. [source] | ||||||||||