Home About us Contact
|
Home About us Contact | ||
|
|
||
Operating Strategies (operating + strategy)
Selected AbstractsA superstructure-based optimal synthesis of PSA cycles for post-combustion CO2 capture,AICHE JOURNAL, Issue 7 2010Anshul Agarwal Abstract Recent developments have shown pressure/vacuum swing adsorption (PSA/VSA) to be a promising option to effectively capture CO2 from flue gas streams. In most commercial PSA cycles, the weakly adsorbed component in the mixture is the desired product, and enriching the strongly adsorbed CO2 is not a concern. On the other hand, it is necessary to concentrate CO2 to high purity to reduce CO2 sequestration costs and minimize safety and environmental risks. Thus, it is necessary to develop PSA processes specifically targeted to obtain pure strongly adsorbed component. A multitude of PSA/VSA cycles have been developed in the literature for CO2 capture from feedstocks low in CO2 concentration. However, no systematic methodology has been suggested to develop, evaluate, and optimize PSA cycles for high purity CO2 capture. This study presents a systematic optimization-based formulation to synthesize novel PSA cycles for a given application. In particular, a novel PSA superstructure is presented to design optimal PSA cycle configurations and evaluate CO2 capture strategies. The superstructure is rich enough to predict a number of different PSA operating steps. The bed connections in the superstructure are governed by time-dependent control variables, which can be varied to realize most PSA operating steps. An optimal sequence of operating steps is achieved through the formulation of an optimal control problem with the partial differential and algebraic equations of the PSA system and the cyclic steady state condition. Large-scale optimization capabilities have enabled us to adopt a complete discretization methodology to solve the optimal control problem as a large-scale nonlinear program, using the nonlinear optimization solver IPOPT. The superstructure approach is demonstrated for case studies related to post-combustion CO2 capture. In particular, optimal PSA cycles were synthesized, which maximize CO2 recovery for a given purity, and minimize overall power consumption. The results show the potential of the superstructure to predict PSA cycles with up to 98% purity and recovery of CO2. Moreover, for recovery of around 85% and purity of over 90%, these cycles can recover CO2 from atmospheric flue gas with a low power consumption of 465 k Wh tonne,1 CO2. The approach presented is, therefore, very promising and quite useful for evaluating the suitability of different adsorbents, feedstocks, and operating strategies for PSA, and assessing its usefulness for CO2 capture. Published 2009 American Institute of Chemical Engineers AIChE J, 2010 [source] Natural gas storage valuation and optimization: A real options applicationNAVAL RESEARCH LOGISTICS: AN INTERNATIONAL JOURNAL, Issue 3 2009Matt Thompson Abstract In this article, we present an algorithm for the valuation and optimal operation of natural gas storage facilities. Real options theory is used to derive nonlinear partial-integro-differential equations (PIDEs), the solution of which give both valuation and optimal operating strategies for these facilities. The equations are designed to incorporate a wide class of spot price models that can exhibit the same time-dependent, mean-reverting dynamics, and price spikes as those observed in most energy markets. Particular attention is paid to the operational characteristics of real storage units. These characteristics include working gas capacities, variable deliverability and injection rates, and cycling limitations. We illustrate the model with a numerical example of a salt cavern storage facility that clearly shows how a gas storage facility is like a financial straddle with both put and call properties. Depending on the amount of gas in storage the relative influence of the put and call components vary. © 2009 Wiley Periodicals, Inc. Naval Research Logistics 2009 [source] Effect of seeding sludge type and hydrodynamic shear force on the aerobic sludge granulation in sequencing batch airlift reactorsASIA-PACIFIC JOURNAL OF CHEMICAL ENGINEERING, Issue 5 2009K. Y. Koh Abstract Two sequencing batch airlift reactors (SBARs) were operated simultaneously for two separate runs. In the first run, two different types of seeding sludge were cultivated in two separate reactors under the same superficial air velocity (SAV). In the second run, the same seeding sludge was cultivated in both reactors but under different SAV, i.e. 1.2 and 3.6 cm s,1. Both runs were carried out for a period of about 20 days, during which the chemical oxygen demand (COD) removal efficiency and morphology of sludge were examined. Batch tests using sodium acetate as the main carbon source were conducted to investigate the COD removal efficiency, and the morphologies of sludge were examined under light microscopy. Results showed that the COD removal efficiency improved with cultivation time. Morphological study showed that all cultivated sludge lost their filamentous species after a few days of cultivation, leaving behind communities of loosely packed pellet-like groups. Although the SAV recommended by other researchers was applied to the SBAR, granulation did not take place at the end of both experimental runs. It was suspected that the failure for aerobic sludge to granulate under the selected operating strategies and reactor configuration was partly due to the intrinsic traits of the sludge microbial community. Copyright © 2009 Curtin University of Technology and John Wiley & Sons, Ltd. [source] Hairy Root Culture in a Liquid-Dispersed Bioreactor: Characterization of Spatial HeterogeneityBIOTECHNOLOGY PROGRESS, Issue 3 2000Gary R. C. Williams A liquid-dispersed reactor equipped with a vertical mesh cylinder for inoculum support was developed for culture of Atropa belladonna hairy roots. The working volume of the culture vessel was 4.4 L with an aspect ratio of 1.7. Medium was dispersed as a spray onto the top of the root bed, and the roots grew radially outward from the central mesh cylinder to the vessel wall. Significant benefits in terms of liquid drainage and reduced interstitial liquid holdup were obtained using a vertical rather than horizontal support structure for the biomass and by operating the reactor with cocurrent air and liquid flow. With root growth, a pattern of spatial heterogeneity developed in the vessel. Higher local biomass densities, lower volumes of interstitial liquid, lower sugar concentrations, and higher root atropine contents were found in the upper sections of the root bed compared with the lower sections, suggesting a greater level of metabolic activity toward the top of the reactor. Although gas-liquid oxygen transfer to the spray droplets was very rapid, there was evidence of significant oxygen limitations in the reactor. Substantial volumes of non-free-draining interstitial liquid accumulated in the root bed. Roots near the bottom of the vessel trapped up to 3,4 times their own weight in liquid, thus eliminating the advantages of improved contact with the gas phase offered by liquid-dispersed culture systems. Local nutrient and product concentrations in the non-free-draining liquid were significantly different from those in the bulk medium, indicating poor liquid mixing within the root bed. Oxygen enrichment of the gas phase improved neither growth nor atropine production, highlighting the greater importance of liquid-solid compared with gas-liquid oxygen transfer resistance. The absence of mechanical or pneumatic agitation and the tendency of the root bed to accumulate liquid and impede drainage were identified as the major limitations to reactor performance. Improved reactor operating strategies and selection or development of root lines offering minimal resistance to liquid flow and low liquid retention characteristics are possible solutions to these problems. [source] A cost-effective operating strategy to reduce energy consumption in a HVAC systemINTERNATIONAL JOURNAL OF ENERGY RESEARCH, Issue 6 2008Nabil Nassif Abstract The operation of the building heating, ventilating, and air conditioning (HVAC) system is a critical activity in terms of optimizing the building's energy consumption, ensuring the occupants' comfort, and preserving air quality. The performance of HVAC systems can be improved through optimized supervisory control strategies. Set points can be adjusted by the optimized supervisor to improve the operating efficiency. This paper presents a cost-effective building operating strategy to reduce energy costs associated with the operation of the HVAC system. The strategy determines the set points of local-loop controllers used in a multi-zone HVAC system. The controller set points include the supply air temperature, the supply duct static pressure, and the chilled water supply temperature. The variation of zone air temperatures around the set point is also considered. The strategy provides proper set points to controllers for minimum energy use while maintaining the required thermal comfort. The proposed technology is computationally simple and suitable for online implementation; it requires access to some data that are already measured and therefore available in most existing building energy management and control systems. The strategy is evaluated for a case study in an existing variable air volume system. The results show that the proposed strategy may be an excellent means of reducing utility costs associated with maintaining or improving indoor environmental conditions. It may reduce energy consumption by about 11% when compared with the actual strategy applied on the investigated existing system. Copyright © 2007 John Wiley & Sons, Ltd. [source] What Macroeconomic Measures Are Needed for Free Trade to Flourish in the Western Hemisphere?LATIN AMERICAN POLITICS AND SOCIETY, Issue 2 2004Barry Eichengreen ABSTRACT Recent experience has made clear the importance of macroeconomic stability, and exchange rate stability in particular, in generating support for regional integration. The tensions created by exchange-rate and financial volatility are clearly evident in the recent history of Mercosur and may also hinder the development of a Free Trade Area of the Americas. This essay argues that ambitious schemes for a single regional currency are not a practical response to this problem. Nor would a system of currency pegs or bands be sufficiently durable to provide a lasting solution. Instead, countries must solve this problem at home. In practice, this means adopting sound and stable monetary policies backed by a clear and coherent operating strategy, such as inflation targeting. With such policies in place, exchange rate volatility can be reduced to levels compatible with regional integration. [source] Optimized evolution in the cytostat: A Monte Carlo simulationBIOTECHNOLOGY & BIOENGINEERING, Issue 1 2009Alan Gilbert Abstract Rational genetic alterations of a microorganism for a specific purpose are not possible in many situations where our knowledge of the relationship between phenotype and genotype is limited. In such cases evolutionary techniques must be applied. Evolutionary methods are usually time consuming; therefore, more efficient techniques are highly desirable. In this work we present the optimization of strain development in a cytostat. The time required for mutant strain isolation is dependent on the total cells present, the wild-type specific growth rate, the beneficial mutation probability, the mutant specific growth rate, and several bioreactor operating conditions. These parameters are highly related, and a theoretical model, as developed here, is needed to define the conditions that optimize the isolation. The model is based on a discrete, stochastic description of mutant formation and selection in the background of abundant wild-type cells. Using the model, we determined the optimal cytostat operating strategy for mutant isolation that varies according to the probability of beneficial mutations. It is also shown that mutants with as little as a 5% growth advantage can be isolated in less than 15 days which is significantly faster than in a chemostat. The described optimal mutant isolation procedure is expected to be particularly useful for the generation of industrial strains that are robust in challenging growth conditions. Biotechnol. Bioeng. 2009;102: 221,231. © 2008 Wiley Periodicals, Inc. [source] | |||||||||||||