Home About us Contact
|
Home About us Contact | ||
|
|
||
New Parameter Set (new + parameter_set)
Selected AbstractsA new GROMOS force field for hexopyranose-based carbohydratesJOURNAL OF COMPUTATIONAL CHEMISTRY, Issue 13 2005Roberto D. Lins Abstract A new parameter set (referred to as 45A4) is developed for the explicit-solvent simulation of hexopyranose-based carbohydrates. This set is compatible with the most recent version of the GROMOS force field for proteins, nucleic acids, and lipids, and the SPC water model. The parametrization procedure relies on: (1) reassigning the atomic partial charges based on a fit to the quantum-mechanical electrostatic potential around a trisaccharide; (2) refining the torsional potential parameters associated with the rotations of the hydroxymethyl, hydroxyl, and anomeric alkoxy groups by fitting to corresponding quantum-mechanical profiles for hexopyranosides; (3) adapting the torsional potential parameters determining the ring conformation so as to stabilize the (experimentally predominant) 4C1 chair conformation. The other (van der Waals and nontorsional covalent) parameters and the rules for third and excluded neighbors are taken directly from the most recent version of the GROMOS force field (except for one additional exclusion). The new set is general enough to define parameters for any (unbranched) hexopyranose-based mono-, di-, oligo- or polysaccharide. In the present article, this force field is validated for a limited set of monosaccharides (,- and ,-D-glucose, ,- and ,-D-galactose) and disaccharides (trehalose, maltose, and cellobiose) in solution, by comparing the results of simulations to available experimental data. More extensive validation will be the scope of a forthcoming article. © 2005 Wiley Periodicals, Inc. J Comput Chem 26: 1400,1412, 2005 [source] PM3-compatible zinc parameters optimized for metalloenzyme active sitesJOURNAL OF COMPUTATIONAL CHEMISTRY, Issue 14 2004Edward N. Brothers Abstract Recent studies have shown that semiempirical methods (e.g., PM3 and AM1) for zinc-containing compounds are unreliable for modeling structures containing zinc ions with ligand environments similar to those observed in zinc metalloenzymes. To correct these deficiencies a reparameterization of zinc at the PM3 level was undertaken. In this effort we included frequency corrected B3LYP/6-311G* zinc metalloenzyme ligand environments along with previously utilized experimental data. Average errors for the heats of formation have been reduced from 46.9 kcal/mol (PM3) to 14.2 kcal/mol for this new parameter set, termed ZnB for "Zinc, Biological." In addition, the new parameter sets predict geometries for the Bacillus fragilis active site model and other zinc metalloenzyme mimics that are qualitatively in agreement with high-level ab initio results, something existing parameter sets failed to do. © 2004 Wiley Periodicals, Inc. J Comput Chem 25: 1677,1692, 2004 [source] Force Field Evaluation for Biomolecular Simulation: Free Enthalpies of Solvation of Polar and Apolar Compounds in Various SolventsCHEMPHYSCHEM, Issue 3 2006Daan P. Geerke Abstract Recently, the GROMOS biomolecular force field parameter set 53A6,which has been parametrized to reproduce experimentally determined free enthalpies of hydration and solvation in cyclohexane of amino acid side-chain analogs,was presented. To investigate the transferability of the new parameter set, we calculated free enthalpies of solvation of a range of polar and apolar compounds in different solvents (methanol, dimethyl sulfoxide (DMSO), acetonitrile, and acetone) from molecular dynamics simulations using the GROMOS 53A6 force field. For methanol and DMSO, parameters were used that are available in the 53A6 parameter set. For acetonitrile, a recently developed model was taken and for acetone, two models available in literature were used. We found that trends in and values for the solvation free enthalpies are in satisfactory agreement with experiment, except for the solvation in acetone for which deviations from experiment can be explained in terms of the properties of the models used. [source] PM3-compatible zinc parameters optimized for metalloenzyme active sitesJOURNAL OF COMPUTATIONAL CHEMISTRY, Issue 14 2004Edward N. Brothers Abstract Recent studies have shown that semiempirical methods (e.g., PM3 and AM1) for zinc-containing compounds are unreliable for modeling structures containing zinc ions with ligand environments similar to those observed in zinc metalloenzymes. To correct these deficiencies a reparameterization of zinc at the PM3 level was undertaken. In this effort we included frequency corrected B3LYP/6-311G* zinc metalloenzyme ligand environments along with previously utilized experimental data. Average errors for the heats of formation have been reduced from 46.9 kcal/mol (PM3) to 14.2 kcal/mol for this new parameter set, termed ZnB for "Zinc, Biological." In addition, the new parameter sets predict geometries for the Bacillus fragilis active site model and other zinc metalloenzyme mimics that are qualitatively in agreement with high-level ab initio results, something existing parameter sets failed to do. © 2004 Wiley Periodicals, Inc. J Comput Chem 25: 1677,1692, 2004 [source] | ||||||||||