Home About us Contact
|
Home About us Contact | ||
|
|
||
Near Field (near + field)
Selected AbstractsHydrologic responses to earthquakes and a general metricGEOFLUIDS (ELECTRONIC), Issue 1-2 2010CHI-YUEN WANG Geofluids (2010) 10, 206,216 Abstract Hydrologic responses to earthquakes, including liquefaction, changes in stream and spring discharge, changes in the properties of groundwater such as geochemistry, temperature and turbidity, changes in the water level in wells, and the eruption of mud volcanoes, have been documented for thousands of years. Except for some water-level changes in the near field which can be explained by poroelastic responses to static stress changes, most hydrologic responses, both within and beyond the near field, can only be explained by the dynamic responses associated with seismic waves. For these responses, the seismic energy density e may be used as a general metric to relate and compare the various hydrologic responses. We show that liquefaction, eruption of mud volcanoes and increases in streamflow are bounded by e , 10,1 J m,3; temperature changes in hot springs are bounded by e , 10,2 J m,3; most sustained groundwater changes are bounded by e , 10,3 J m,3; geysers and triggered seismicity may respond to seismic energy density as small as 10,3 and 10,4 J m,3, respectively. Comparing the threshold energy densities with published laboratory measurements, we show that undrained consolidation induced by dynamic stresses can explain liquefaction only in the near field, but not beyond the near field. We propose that in the intermediate field and far field, most responses are triggered by changes in permeability that in turn are a response to the cyclic deformation and oscillatory fluid flow. Published laboratory measurements confirm that changes in flow and time-varying stresses can change permeability, inducing both increases and decreases. Field measurements in wells also indicate that permeability can be changed by earthquakes in the intermediate field and far field. Further work, in particular field monitoring and measurements, are needed to assess the generality of permeability changes in explaining far-field hydrologic responses to earthquakes. [source] Cyclic macro-element for soil,structure interaction: material and geometrical non-linearitiesINTERNATIONAL JOURNAL FOR NUMERICAL AND ANALYTICAL METHODS IN GEOMECHANICS, Issue 13 2001Cécile Cremer Abstract This paper presents a non-linear soil,structure interaction (SSI) macro-element for shallow foundation on cohesive soil. The element describes the behaviour in the near field of the foundation under cyclic loading, reproducing the material non-linearities of the soil under the foundation (yielding) as well as the geometrical non-linearities (uplift) at the soil,structure interface. The overall behaviour in the soil and at the interface is reduced to its action on the foundation. The macro-element consists of a non-linear joint element, expressed in generalised variables, i.e. in forces applied to the foundation and in the corresponding displacements. Failure is described by the interaction diagram of the ultimate bearing capacity of the foundation under combined loads. Mechanisms of yielding and uplift are modelled through a global, coupled plasticity,uplift model. The cyclic model is dedicated to modelling the dynamic response of structures subjected to seismic action. Thus, it is especially suited to combined loading developed during this kind of motion. Comparisons of cyclic results obtained from the macro-element and from a FE modelization are shown in order to demonstrate the relevance of the proposed model and its predictive ability. Copyright © 2001 John Wiley & Sons, Ltd. [source] Non-reflecting artificial boundaries for transient scalar wave propagation in a two-dimensional infinite homogeneous layerINTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN ENGINEERING, Issue 10 2003Chongbin Zhao Abstract This paper presents an exact non-reflecting boundary condition for dealing with transient scalar wave propagation problems in a two-dimensional infinite homogeneous layer. In order to model the complicated geometry and material properties in the near field, two vertical artificial boundaries are considered in the infinite layer so as to truncate the infinite domain into a finite domain. This treatment requires the appropriate boundary conditions, which are often referred to as the artificial boundary conditions, to be applied on the truncated boundaries. Since the infinite extension direction is different for these two truncated vertical boundaries, namely one extends toward x ,, and another extends toward x,- ,, the non-reflecting boundary condition needs to be derived on these two boundaries. Applying the variable separation method to the wave equation results in a reduction in spatial variables by one. The reduced wave equation, which is a time-dependent partial differential equation with only one spatial variable, can be further changed into a linear first-order ordinary differential equation by using both the operator splitting method and the modal radiation function concept simultaneously. As a result, the non-reflecting artificial boundary condition can be obtained by solving the ordinary differential equation whose stability is ensured. Some numerical examples have demonstrated that the non-reflecting boundary condition is of high accuracy in dealing with scalar wave propagation problems in infinite and semi-infinite media. Copyright © 2003 John Wiley & Sons, Ltd. [source] A robust methodology for RANS simulations of highly underexpanded jetsINTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN FLUIDS, Issue 12 2008G. Lehnasch Abstract This work aims at developing/combining numerical tools adapted to the simulation of the near field of highly underexpanded jets. An overview of the challenging numerical problems related to the complex shock/expansion structure encountered in these flows is given and an efficient and low-cost numerical strategy is proposed to overcome these, even on short computational domains. Based on common upwinding algorithms used on unstructured meshes in a mixed finite-volume/finite-element approach, it relies on an appropriate utilization of zonal anisotropic remeshing algorithms. This methodology is validated for the whole near field of cold air jets issuing from axisymmetric convergent nozzles and yielding various underexpansion ratios. In addition, the most usual corrections of the k,, model used to take into account the compressibility effects on turbulence are precisely assessed. Copyright © 2007 John Wiley & Sons, Ltd. [source] Potential flow around obstacles using the scaled boundary finite-element methodINTERNATIONAL JOURNAL FOR NUMERICAL METHODS IN FLUIDS, Issue 7 2003Andrew J. Deeks Abstract The scaled boundary finite-element method is a novel semi-analytical technique, combining the advantages of the finite element and the boundary element methods with unique properties of its own. The method works by weakening the governing differential equations in one co-ordinate direction through the introduction of shape functions, then solving the weakened equations analytically in the other (radial) co-ordinate direction. These co-ordinate directions are defined by the geometry of the domain and a scaling centre. The method can be employed for both bounded and unbounded domains. This paper applies the method to problems of potential flow around streamlined and bluff obstacles in an infinite domain. The method is derived using a weighted residual approach and extended to include the necessary velocity boundary conditions at infinity. The ability of the method to model unbounded problems is demonstrated, together with its ability to model singular points in the near field in the case of bluff obstacles. Flow fields around circular and square cylinders are computed, graphically illustrating the accuracy of the technique, and two further practical examples are also presented. Comparisons are made with boundary element and finite difference solutions. Copyright © 2003 John Wiley & Sons, Ltd. [source] Virtual Electrode Polarization Leads to Reentry in the Far FieldJOURNAL OF CARDIOVASCULAR ELECTROPHYSIOLOGY, Issue 8 2001ANNETTE E. LINDBLOM M.S. Virtual Electrode Polarization. Introduction: Our previous article examined cardiac vulnerability to reentry in the near field within the framework of the virtual electrode polarization (VEP) concept. The present study extends this examination to the far field and compares its predictions to the critical point hypothesis. Methods and Results: We simulate the electrical behavior of a sheet of myocardium using a two-dimensional bidomain model. The fiber field is extrapolated from a set of rabbit heart fiber directions obtained experimentally. An S1 stimulus is applied along the top or left border. An extracellular line electrode on the top delivers a cathodal or anodal S2 stimulus. A VEP pattern matching that seen experimentally is observed and covers the entire sheet, thus constituting a far-field effect. Reentry arises from break excitation, make excitation, or a combination of both, and subsequent propagation through deexcited and recovered areas. Reentry occurs in cross-field, parallel-field, and uniform refractoriness protocols. For long coupling intervals (CIs) above CImakemin (defined as the shortest CI at which make excitation can take place), rotors move away from the cathodal electrode and the S1 site for increases in S2 strength and CI, respectively. For cathodal S2 stimuli, findings are consistent with the critical point hypothesis. For CIs below CImakemin, reentry is initiated by break excitation only, and the resulting reentrant patterns are no longer consistent with those predicted by the critical point hypothesis. Conclusion: Shock-induced VEP can explain vulnerability in the far field. The VEP theory of vulnerability encompasses the critical point hypothesis for cathodal S2 shocks at long CIs. [source] An accurate evaluation of the nonsymmetrical components of Green's functions for multilayered media in the near-field regionMICROWAVE AND OPTICAL TECHNOLOGY LETTERS, Issue 4 2009Alaa K. AbdelmageedArticle first published online: 9 FEB 200 Abstract The discrete complex image method has proved to be one of the most efficient techniques to evaluate Green's functions for multilayered media, particularly in the near- and intermediate-field regions. Although the extraction of surface waves extends its validity to the far field, it suffers from erroneous results that contaminate the computation of the near field. To handle this problem for the nonsymmetrical components of Greens functions, we follow the same approach adopted by the author and others for the symmetrical components where a number of artificial poles are extracted for each physical surface-wave pole occurrence. This approach has proved its validity and yielded good results in all field regions. © 2009 Wiley Periodicals, Inc. Microwave Opt Technol Lett 51: 881,885, 2009; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.24201 [source] Aperture field reconstruction by calculated cylindrical near fieldMICROWAVE AND OPTICAL TECHNOLOGY LETTERS, Issue 11 2008Alcino Castelo Boso Abstract A method for determining the aperture field distribution of an array antenna from near-field measurement over the surface of a right circular cylinder enclosing the antenna is applied here. The approach relies on the concept of information content of the field. The truncation problem is solved by picking up the information that is lost due to the finite size of scanning area, in points of the space reachable by the measurement system. In this article, we rebuild the field at the aperture from near-field cylindrical calculated on the surface of measure, with dependence on the variable phi, and without dependence on the variable phi. © 2008 Wiley Periodicals, Inc. Microwave Opt Technol Lett 50: 2849,2851, 2008; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.23825 [source] Microsystems for Optical Cell Detection: Near versus Far FieldPARTICLE & PARTICLE SYSTEMS CHARACTERIZATION, Issue 1 2008Stefan Kostner Abstract Optical flow cytometry is a process where physical and (bio-) chemical parameters of single biological cells can be obtained in a flow-through setup by optical measurement techniques. Unlike conventional systems, where measurements are conducted in the optical far field, the proposed system senses the cell's optical projection in the near field by using integrated photodiodes. This allows for the attainment of additional parameters, e.g., size and shape, which are usually hidden in the far field. In addition, parameters such as refractive index and absorption of the cell influence the sensor signal. Additionally, with another setup, a different approach is followed to measure similar parameters with external detection using a DVD laser pickup head and a microchannel equipped with a mirror. This low-cost setup does not measure in the near field, and therefore, is dedicated to different parameters. In this contribution, results from measurements with polystyrene particles and biological cells (yeast and Chinese hamster ovary) are presented and the advantages and limitations of both systems are outlined. [source] | ||||||||||