Home About us Contact
|
Home About us Contact | ||
|
|
||
Molar Absorption Coefficient (molar + absorption_coefficient)
Selected AbstractsSeparation of Nile Blue-labelled fatty acids by CE with absorbance detection using a red light-emitting diodeELECTROPHORESIS, Issue 8 2007Michael C. Breadmore Dr. Abstract The separation of fatty acids derivatised with Nile Blue (NB) by CE with detection using a red light-emitting diode (LED) was examined. NB was selected as the derivatisation agent due to its high molar absorption coefficient of 76,000,M,1cm,1 at 633,nm, making it well suited for sensitive absorbance detection using a red 635,nm LED. NB-labelled fatty acids were separated by both MEKC using SDS micelles, i -PrOH and n -BuOH and by NACE in a number of solvents including MeOH, EtOH and ACN. The sensitivity of NACE was superior to MEKC, with detection limits of 5×10,7,7×10,7,M obtained for each acid, approximately 20 times lower than the MEKC method. The NACE detection limits are approximately 100 times lower than previous reports on the separation of fatty acids by CE using indirect absorbance detection, ten times lower than using indirect fluorescence detection and are inferior only to those obtained using precapillary derivatisation and direct fluorescence detection. The efficiency of the NACE method was also superior to MEKC and allowed the separation of unsaturated fatty acids to be examined, although it was not possible to baseline-resolve linoleic (C18:2) and linolenic (C18:3) acids in a reasonable time. The method was used to analyse the fatty acid profile of two edible oils, namely sunflower and sesame oils, after alkali hydrolysis, where it was possible to identify both the saturated and unsaturated fatty acids in each sample. [source] New Ruthenium Complexes Containing Oligoalkylthiophene-Substituted 1,10-Phenanthroline for Nanocrystalline Dye-Sensitized Solar Cells,ADVANCED FUNCTIONAL MATERIALS, Issue 1 2007C.-Y. Chen Abstract Two new ruthenium complexes [Ru(dcbpy)(L)(NCS)2], where dcbpy is 4,4,-dicarboxylic acid-2,2,-bipyridine and L is 3,8-bis(4-octylthiophen-2-yl)-1,10-phenanthroline (CYC-P1) or 3,8-bis(4-octyl-5-(4-octylthiophen-2-yl)thiophen-2-yl)-1,10-phenanthroline (CYC-P2), are synthesized, characterized by physicochemical and semiempirical computational methods, and used as photosensitizers in nanocrystalline dye-sensitized solar cells. It was found that the difference in light-harvesting ability between CYC-P1 and CYC-P2 is associated mainly with the location of the frontier orbitals, in particular the highest occupied molecular orbital (HOMO). Increasing the conjugation length of the ancillary ligand decreases the energy of the metal-to-ligand charge transfer (MLCT) transition, but at the same time reduces the molar absorption coefficient, owing to the HOMO located partially on the ancillary ligand of the ruthenium complex. The incident photon-to-current conversion efficiency curves of the devices are consistent with the MLCT band of the complexes. Therefore, the overall efficiencies of CYC-P1 and CYC-P2 sensitized cells are 6.01 and 3.42,%, respectively, compared to a cis- di(thiocyanato)-bis(2,2,-bipyridyl)-4,4,-dicarboxylate ruthenium(II)-sensitized device, which is 7.70,% using the same device-fabrication process and measuring parameters. [source] Kinetics and mechanism for the formation of o -carboxy(N -methyl)-benzohydroxamic acid in the cleavage of ethyl N -[o -(N -methyl- N -hydroxycarbamoyl)-benzoyl]carbamate in N -methylhydroxylamine, acetate, and phosphate buffersINTERNATIONAL JOURNAL OF CHEMICAL KINETICS, Issue 9 2003M. Niyaz Khan The rate of cleavage of ethyl N -[o -(N -methyl- N -hydroxycarbamoyl)benzoyl]- carbamate (ENMBC) in the buffer solutions containing N -methylhydroxylamine, acetate + N -methylhydroxylamine, and phosphate + N -methylhydroxylamine followed an irreversible consecutive reaction path: ENMBC where A and B represent N -hydroxyl group cyclized product of ENMBC and o -(N -methyl- N -hydroxycarbamoyl)benzoic acid, respectively. Both rate constants k1 obs and k2 obs showed the presence of buffer catalysis, but buffer catalysis turned out to be weak in the presence N -methylhydroxylamine buffer, while it was strong in the presence of acetate and phosphate ones. Buffer-independent rate constants k10 and k20 increased linearly with the increase in aOH with definite intercepts. The values of molar absorption coefficient of A, obtained under varying total buffer concentrations at a constant pH, showed the presence of a fast equilibrium: A + CH3NHOH , C, where C represents N -[o -(N -methyl- N -hydroxycarbamoyl)methyl]benzohydroxamic acid. © 2003 Wiley Periodicals, Inc. Int J Chem Kinet 35: 427,437, 2003 [source] Synthesis and characterization of cyclopentadithiophene-based low bandgap copolymers containing electron-deficient benzoselenadiazole derivatives for photovoltaic devicesJOURNAL OF POLYMER SCIENCE (IN TWO SECTIONS), Issue 6 2010In Hwan Jung Abstract We have synthesized two cyclopentadithiophene (CDT)-based low bandgap copolymers, poly[(4,4-bis(2-ethyl-hexyl)-4H -cyclopenta[2,1- b:3,4- b,]dithiophene-2,6-diyl)- alt -(benzo[c][1,2,5]selenadiazole-4,7-diyl)] (PCBSe) and poly[(4,4-bis(2-ethyl-hexyl)-4H -cyclopenta[2,1- b:3,4- b,]dithiophene-2,6-diyl)- alt -(4,7-dithiophen-2-yl-benzo[c][1,2,5]selenadiazole-5,5,-diyl)] (PCT2BSe), for use in photovoltaic applications. Through the internal charge transfer interaction between the electron-donating CDT unit and the electron-accepting benzoselenadiazole, we realized exceedingly low bandgap polymers with bandgaps of 1.37,1.46 eV. The UV,vis absorption maxima of PCT2BSe were subjected to larger hypsochromic shifts than those of PCBSe, because of the distorted electron donor,acceptor (D,A) structures of the PCT2BSe backbone. These results were supported by the calculations of the D,A complex using the ab initio Hartree-Fock method with a split-valence 6-31G* basis set. However, PCT2BSe exhibited a better molar absorption coefficient in the visible region, which can lead to more efficient absorption of sunlight. As a result, PCT2BSe blended with [6,6]-phenyl-C61 -butyric acid methyl ester (PC61BM) exhibited a better photovoltaic performance than PCBSe because of the larger spectral overlap integral with respect to the solar spectrum. Furthermore, when the polymers were blended with PC71BM, PCT2BSe showed the best performance, with an open circuit voltage of 0.55 V, a short-circuit current of 6.63 mA/cm2, and a power conversion efficiency of 1.34% under air mass 1.5 global illumination conditions. © 2010 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 48: 1423,1432, 2010 [source] Extraction of pure lycopene from industrial tomato by-products in water using a new high-pressure processJOURNAL OF THE SCIENCE OF FOOD AND AGRICULTURE, Issue 14 2008Daniele Naviglio Abstract BACKGROUND: Lycopene, a precursor of ,-carotene with a well-known antioxidant activity, contained in many natural products such as tomato (Lycopersicon esculentum Mill.), watermelon, red pepper and papaya, is usually recovered from natural vegetal sources using organic solvents and a purification step. In this paper an innovative process for the extraction of pure lycopene from tomato waste in water that uses the Naviglio® extractor and water as extracting phase is presented. RESULTS: Lycopene was obtained in the all- trans form at a very high grade of purity, not less than 98% (w/w), with an average recovery of 14% (w/w). The availability of high-purity trans -lycopene allowed measurement of the molar absorption coefficient. An alternative procedure for high-performance liquid chromatographic analysis using a phenyl-hexyl silicone phase as inverse phase and a linear gradient in water and acetonitrile is also described. CONCLUSIONS: The use of water as extracting phase considerably reduces the cost of the entire process when compared with the commonly used solvent-based procedure or with the newer supercritical extraction process of lycopene from tomato waste. Lycopene, not soluble in water, was recovered in a quasi-crystalline solid form and purified by solid-phase extraction using a small amount of organic solvent. Copyright © 2008 Society of Chemical Industry This article was published online on September 15, 2008. Errors in Figures 2 - 4 were subsequently identified. The publishers wish to apologise for these errors. This notice is included in the online and print versions to indicate that both have been corrected [September 19, 2008] [source] Primary Photoprocesses in a Fluoroquinolone Antibiotic Sarafloxacin,PHOTOCHEMISTRY & PHOTOBIOLOGY, Issue 4 2009Fernando Lorenzo The photophysical properties of the fluoroquinolone antibiotic sarafloxacin (SFX) were investigated in aqueous media. SFX in water, at pH 7.4, shows intense absorption with peaks at 272, 322 and 335 nm, (, = 36800 and 17000 dm3 mol,1 cm,1, respectively). Both the absorption and emission properties of SFX are pH-dependent; pKa values for the protonation equilibria of both the ground (5.8 and 9.1) and excited singlet states (5.7 and 9.0) of SFX were determined spectroscopically. SFX fluoresces weakly, the quantum yield for fluorescence emission being maximum (0.07) at pH 8. Laser flash photolysis and pulse radiolysis studies have been carried out in order to characterize the transient species of SFX in aqueous solution. Triplet,triplet absorption has a maximum at 610 nm with a molar absorption coefficient of 17,000 ± 1000 dm3 mol,1 cm,1. The quantum yield of triplet formation has been determined to be 0.35 ± 0.05. In the presence of oxygen, the triplet reacts to form excited singlet oxygen with quantum yield of 0.10. The initial triplet (3A*) was found to react with phosphate buffer to form triplet 3B* with lower energy and longer lifetime and having an absorption band centered at 700 nm. SFX triplet was also found to oxidize tryptophan to its radical with concomitant formation of the anion radical of SFX. Hence the photosensitivity of SFX could be initiated by the oxygen radicals and/or by SFX radicals acting as haptens. [source] Deposition of Cytokinesis-Related Callose in Riella helicophylla and Arabidopsis thaliana.PLANT BIOLOGY, Issue 4 2001Effects of Photolytically Altered Nifedipine Abstract: The cytokinesis-related callose deposition in cell plates and juvenile cross walls of meristematic cells was investigated in the liverwort Riella helicophylla and seedlings of Arabidopsis thaliana. The ,-1,3-glucan callose was detected by its specific staining properties with sirofluor and aniline blue by fluorescence microscopy. The photo-labile calcium antagonist nifedipine (NIF) exerted a specific promotive effect when the substance was exposed to light. The nitroso derivative of photolysed NIF was found to be the active compound which was responsible for the enhancement in callose deposition. The nitroso derivative was isolated after photolysis of NIF by UV light (365 nm) and its structure was verified with 1H-nuclear magnetic resonance and infrared spectroscopy. The characteristic absorption maximum at 770 nm in dimethyl sulfoxide was employed to determine the concentration of the nitrosopyridine in solutions by use of the molar absorption coefficient of the isolated substance. In addition, the nitro derivative of nifedipine was prepared. This nitropyridine was ineffective with respect to the stimulation of callose deposition in dividing cells. The possible mechanism of this cytotoxic effect and its implications for symplastic growth in meristems is discussed. [source] 2-Ethylhexyl-2,4,5-trimethoxycinnamate and di-(2-ethylhexyl)-2,4,5-trimethoxybenzalmalonate as novel UVA filtersJOURNAL OF PHARMACY AND PHARMACOLOGY: AN INTERNATI ONAL JOURNAL OF PHARMACEUTICAL SCIENCE, Issue 2 2007Thitinun Monhaphol A series of 2-ethylhexylmethoxy substituted cinnamates and benzalmalonates have been synthesized and characterized. 2-Ethylhexyl-2,4,5-trimethoxycinnamate (E8) and di-(2-ethylhexyl)-2,4,5-trimethoxybenzalmalonate (B8) show UVA absorption with high molar absorption coefficients (12000-14000 cm,1 M,1 at 350 nm). E8 undergoes trans to cis photoisomerization under UVA exposure causing the decrease in UV absorption efficiency. E8 is more photostable than butyl methoxydibenzoylmethane (BMDBM). For example, 41.64 J cm,2 UVA irradiation produces 20 ± 2% and 25 ± 2% loss in UV absorption for E8 and BMDBM, respectively. Similar irradiation produces no change in the UV absorption of B8. Both the oily liquid E8 and the yellow solid B8 can be dissolved in various organic solvents, ranging from methanol to hexane, various silicone fluids and 2-ethylhexyl-4-trimethoxycinnamate (EHMC, a widely used UVB filter). A liquid broadband filter comprising B8 and EHMC shows excellent photostability in both UVB and UVA regions. [source] | ||||||||||||||||