Home About us Contact | |||
Micellar Properties (micellar + property)
Selected AbstractsEnantioselectivity of alcohol-modified polymeric surfactants in micellar electrokinetic chromatographyELECTROPHORESIS, Issue 15 2003Jepkoech Tarus Abstract A novel method of modifying sodium undecanoyl- L -leucinate (SUL) micelles employed in chiral separation of analytes in micellar electrokinetic chromatography (MEKC) to enhance selectivity toward specific analytes is discussed. The current study aimed at modifying the SUL micelles by introducing different alcohols into the mono-SUL micelles. The micellar solutions were then polymerized in the presence of alcohols followed by postpolymerization extraction of the alcohols to yield alcohol-free polymeric surfactants (poly- L -SUL). The effects of hexanol (C6OH) and undecylenyl alcohol (C11OH) on micellar properties of this surfactant were investigated by use of surface tensiometry, fluorescence spectroscopy, pulsed field gradient-nuclear magnetic resonance (PFG-NMR), and MEKC. The surface tension and PFG-NMR studies indicated an increase in the critical micelle concentration (cmc) and micellar size upon increasing the alcohol concentration. Fluorescence measurements suggested that alcohols induce closely packed micellar structures. Coumarinic and benzoin derivatives, as well as (±)-1, 1'-binaphthyl-2,2'-dihydrogen phosphate (BNP) were used as test analytes for MEKC experiments. Examination of MEKC data showed remarkable resolutions and capacity factors of coumarinic derivatives obtained with modified poly- L -SUL as compared to the unmodified poly- L -SUL. Evaluation of fluorescence, PFG-NMR, and MEKC data suggest a strong correlation between the polarity and hydrodynamic radii of alcohol-modified micelles and the resolution of the test analytes. [source] Thermodynamics and micellar properties of some surface active cobalt(III) metallosurfactants in nonaqueous mediumINTERNATIONAL JOURNAL OF CHEMICAL KINETICS, Issue 1 2007K. Santhakumar The critical micelle concentration (CMC) of four kinds of metallosurfactants of the type halogeno(dodecyl/cetylamine)-bis(ethylenediamine)cobalt(III) has been studied in n -alcohol and in formamide at different temperatures by electrical conductivity method. Specific conductivity data (at 293,313 K) served for the evaluation of temperature-dependent CMC and the thermodynamic parameters such as standard Gibbs free energy changes (,G), enthalpies (,H), and entropies (,S) of micelle formation. CMCs have also been measured as a function of percentage concentration of alcohol added. It is suggested that alcohol addition leads to increase in formamide penetration into micellar interface that depends on the alcohol chain length. The results have been discussed in terms of increased hydrophobic effect (solvophobic interaction), dielectric constant of the medium, and the chain length of the alcohols, the surfactant in the solvent mixture. © 2006 Wiley Periodicals, Inc. Int J Chem Kinet 39: 22,31, 2007 [source] Behaviour of polynuclear aryl sulphonatesLUBRICATION SCIENCE, Issue 3 2005A. K. Singh A series of hexadecyl polynuclear aromatic, decalin, and tetralin sulphonates have been synthesised. The critical micelle concentration (CMC) and surface and interfacial tension values at various concentrations above and below the CMC in both aqueous and non-aqueous media have been determined. The micellar size and shape, the average number of monomers constituting these micelles, and the thermodynamic properties have also been estimated. These studies show that the CMC value in both aqueous and heptane media decreases with an increase in the number of aromatic rings in the sulphonates. The size and shape of the micelles do not change appreciably in heptane, although the number of monomers constituting the micelles changes with a change of structure of the aromatic moiety. The thermodynamic parameters do not seem to affect the surface activity and solubilising properties even though the free energy, enthalpy, and entropy decrease with an increase in the size of the aromatic moiety. The surface and interfacial tension values are the lowest with aqueous and non-aqueous solutions of hexadecyl naphthalene sulphonate, but these values increase with an increase in the number of aromatic rings in the sulphonates. The sizes of the micelles of hexadecyl naphthalene sulphonate in aqueous solutions and the number of monomer molecules constituting the micelles are greater than for the other aromatic sulphonates. Although the sizes of micelles of hexadecyl benzanthracene sulphonate and hexadecyl pentacene sulphonate are comparable, the numbers of molecules constituting these micelles are the smallest. The solubilisation of alkanes in aqueous solutions of sodium naphthalene sulphonate containing electrolyte and isobutanol is the highest, but it falls off rapidly for all the other sulphonates. This shows the extreme sensitivity of solubilisation to the structure of the sulphonates. The detergency increases with an increase in the size of the aromatic moiety. The structure thus has a profound influence on the surface and micellar properties of these sulphonates. These studies are important from the point of view of the use of synthetic sulphonates as additives / surfactants in place of petroleum sulphonates. [source] A Novel Micellar PEGylated Hyperbranched Polyester as a Prospective Drug Delivery System for PaclitaxelMACROMOLECULAR BIOSCIENCE, Issue 9 2008Christina Kontoyianni Abstract A hyperbranched aliphatic polyester has been functionalized with PEG chains to afford a novel water-soluble BH40-PEG polymer which exhibits unimolecular micellar properties, and is therefore appropriate for application as a drug-delivery system. The solubility of the anticancer drug paclitaxel was enhanced by a factor of 35, 110, 230, and 355 in aqueous solutions of BH40-PEG of 10, 30, 60, and 90 mg,·,mL,1, respectively. More than 50% of the drug is released at a steady rate and release is almost complete within 10 h. The toxicity of BH40-PEG was assessed in vitro with A549 human lung carcinoma cells and found to be nontoxic for 3 h incubation up to a 1.75 mg,·,mL,1 concentration while LD50 was 3.5 mg,·,mL,1. Finally, it was efficiently internalized in cells, primarily in the absence of foetal bovine serum, while confocal microscopy revealed the preferential localization of the compound in cell nuclei. [source] Bending Energetics of Tablet-Shaped Micelles: A Novel Approach to Rationalize Micellar SystemsCHEMPHYSCHEM, Issue 3 2007L. Magnus Bergström Prof. Abstract A novel approach to rationalize micellar systems is expounded in which the structural behavior of tablet-shaped micelles is theoretically investigated as a function of the three bending elasticity constants: spontaneous curvature (H0), bending rigidity (kc), and saddle-splay constant (k,c). As a result, experimentally accessible micellar properties, such as aggregation number, length-to-width ratio, and polydispersity, may be related to the different bending elasticity constants. It is demonstrated that discrete micelles or connected cylinders form when H0>1/4,, where , is the thickness of a surfactant monolayer, whereas various bilayer structures are expected to predominate when H0<1/4,. Our theory predicts, in agreement with experiments, a transition from discrete globular (tablet-shaped) micelles to a phase of ordered, or disordered, connected cylinders above a critical surfactant concentration. Moreover, a novel explanation for the mechanism of growth, from small globular to long rodlike or wormlike micelles, follows as a consequence from the theory. In accordance, polydisperse elongated micelles (large length-to-width ratio) form as the bending rigidity is lowered, approaching the critical point at kc=0, whereas monodisperse globular micelles (small length-to-width ratio) are expected to be present at large kc values. The spontaneous curvature mainly determines the width of tablet-shaped or ribbonlike micelles, or the radius of disklike micelles, whereas the saddle-splay constant primarily influences the size but not the shape of the micelles. [source] |