Home About us Contact
|
Home About us Contact | ||
|
|
||
Map Construction (map + construction)
Kinds of Map Construction Selected AbstractsProgress in the Study of Molecular Genetic Improvements of Poplar in ChinaJOURNAL OF INTEGRATIVE PLANT BIOLOGY, Issue 9 2006Shan-Zhi Lin Abstract The poplar is one of the most economically important and intensively studied tree species owing to its wide application in the timber industry and as a model material for the study of woody plants. The natural resource of poplars in China is replete. Over the past 10 years, the application of molecular biological techniques to genetic improvements in poplar species has been widely studied in China. Recent advances in molecular genetic improvements of poplar, including cDNA library construction, gene cloning and identification, genetic engineering, gene expression, genetic linkage map construction, mapping of quantitative trait loci (QTL) and molecular-assisted selection, are reviewed in the present paper. In addition, the application of modern biotechnology to molecular improvements in the genetic traits of the poplar and some unsolved problems are discussed. (Managing editor: Li-Hui Zhao) [source] PERMANENT GENETIC RESOURCES: Isolation and characterization of microsatellite DNA loci from the southern flounder, Paralichthys lethostigmaMOLECULAR ECOLOGY RESOURCES, Issue 2 2008C. W. SHAO Abstract Paucity of polymorphic molecular markers in southern flounder (Paralichthys lethostigma) has been a major limitation in genetic improvement of this important economic fish. Hence, we constructed a repeat-enriched genomic library from P. lethostigma. A total of 39 new microsatellites were identified, for which 33 primer pairs were designed. After validating and scoring, 10 of these loci were polymorphic in a test population with the range of alleles from two to nine per locus. The observed and expected heterozygosities ranged from 0.2500 to 0.9000 and from 0.4469 to 0.8514, respectively. These polymorphic microsatellites will be useful for genetic diversity analysis and linkage map construction for P. lethostigma. [source] Genetic linkage map construction and location of QTLs for fruit-related traits in cucumberPLANT BREEDING, Issue 2 2008X. J. Yuan Abstract A 173-point genetic linkage map of cucumber (Cucumis sativus L.), consisting of 116 SRAPs, 33 RAPDs, 11 SSRs, 9 SCARs, 3 ISSRs, and 1 STS, was constructed using 130 F2 progeny derived from a narrow cross between line S94 (Northern China open-field type) and line S06 (greenhouse European type). The seven linkage groups spanned 1016 cM with a mean marker interval of 5.9 cM. Using the F2 population and its F3 derived families, a total of 38 QTLs were detected on five linkage groups with an LOD threshold of 3.0 for nine fruit-related traits: fruit weight, length, and diameter, fruit flesh thickness, seed-cavity diameter, fruit-stalk length, fruit pedicel length, length/diameter and length/stalk ratio. Of the identified QTLs, fsl4.3 for fruit-stalk length explained the largest portion of phenotypic variation (r2 = ,30%). Several QTLs were detected in the same linkage region in different generations and different seasons. Additionally, several QTLs for various fruit traits were mapped to the same or neighbouring marker intervals, suggesting they are possible character associations for controlling cucumber fruit development. [source] Linkage map construction and mapping QTL for cotton fibre quality using SRAP, SSR and RAPDPLANT BREEDING, Issue 2 2005Z. Lin Abstract Tetraploid cotton is one of the most extensively cultivated species. Two tetraploid species, Gossypium hirsutum L. and G. barbadense L., dominate the world's cotton production. To better understand the genetic basis of cotton fibre traits for the improvement of fibre quality, a genetic linkage map of tetraploid cotton was constructed using sequence-related amplified polymorphisms (SRAPs), simple sequence repeats (SSRs) and random amplified polymorphic DNAs (RAPDs). A total of 238 SRAP primer combinations, 368 SSR primer pairs and 600 RAPD primers were used to screen polymorphisms between G. hirsutum cv. Handan208 and G. barbadense cv. Pima90 which revealed 749 polymorphic loci in total (205 SSRs, 107 RAPDs and 437 SRAPs). Sixty-nine F2 progeny from the interspecific cross of ,Handan208'×,Pima90' were genotyped with the 749 polymorphic markers. A total of 566 loci were assembled into 41 linkage groups with at least three loci in each group. Twenty-eight linkage groups were assigned to corresponding chromosomes by SSR markers with known chromosome locations. The map covered 5141.8 cM with a mean interlocus space of 9.08 cM. A × test for significance of deviations from the expected ratio (1: 2: 1 or 3: 1) identified 135 loci (18.0%) with skewed segregation, most of which had an excess of maternal parental alleles. In total, 13 QTL associated with fibre traits were detected, among which two QTL were for fibre strength, four for fibre length and seven for micronaire value. These QTL were on nine linkage groups explaining 16.18-28.92% of the trait variation. Six QTL were located in the A subgenome, six QTL in the D subgenome and one QTL in an unassigned linkage group. There were three QTL for micronaire value clustered on LG1, which would be very useful for improving this trait by molecular marker-assisted selection. [source] A genetic linkage map of the sea cucumber, Apostichopus japonicus (Selenka), based on AFLP and microsatellite markersANIMAL GENETICS, Issue 5 2009Q. Li Summary We present the first genetic maps of the sea cucumber (Apostichopus japonicus), constructed with an F1 pseudo-testcross strategy. The 37 amplified fragment length polymorphism (AFLP) primer combinations chosen identified 484 polymorphic markers. Of the 21 microsatellite primer pairs tested, 16 identified heterozygous loci in one or other parent, and six were fully informative, as they segregated in both parents. The female map comprised 163 loci, spread over 20 linkage groups (which equals the haploid chromosome number), and spanned 1522.0 cM, with a mean marker density of 9.3 cM. The equivalent figures for the male map were 162 loci, 21 linkage groups, 1276.9 and 7.9 cM. About 2.5% of the AFLP markers displayed segregation distortion and were not used for map construction. The estimated coverage of the genome was 84.8% for the female map and 83.4% for the male map. The maps generated will serve as a basis for the construction of a high-resolution genetic map and mapping of the functional genes and quantitative trait loci, which will then open the way for the application of a marker-assisted selection breeding strategy in this species. [source] Identification of quantitative trait loci for growth-related traits in the Pacific abalone Haliotis discus hannai InoAQUACULTURE RESEARCH, Issue 8 2007Xiande Liu Abstract The locations and effects of quantitative trait loci (QTL) were estimated for nine characters for growth-related traits in the Pacific abalone (Haliotis discus hannai Ino) using a randomly amplified polymorphic DNA (RAPD), amplification fragment length polymorphism (AFLP) and SSR genetic linkage map. Twenty-eight putatively significant QTLs (LOD>2.4) were detected for nine traits (shell length, shell width, total weight, shell weight, weight of soft part, muscle weight, gonad and digestive gland weight, mantle weight and gill weight). The percentage of phenotypic variation explained by a single QTL ranged from 8.0% to 35.9%. The significant correlations (P<0.001) were found among all the growth-related traits, and Pearson's correlation coefficients were more than 0.81. For the female map, the QTL for growth were concentrated on groups 1 and 4 linkage maps. On the male map, the QTL that influenced growth-related traits gathered on the groups 1 and 9 linkage maps. Genetic linkage map construction and QTL analysis for growth-related traits are the basis for the marker-assisted selection and will eventually improve production and quality of the Pacific abalone. [source] | ||||||||||