Home About us Contact
|
Home About us Contact | ||
|
|
||
Mandibular Dentures (mandibular + denture)
Selected AbstractsAccelerated rehabilitation of an edentulous patient with an implant retained dental prosthesis: a case reportGERODONTOLOGY, Issue 3 2007Gerald McKenna This case report details the successful rehabilitation of an edentulous patient using a complete upper prosthesis and a lower implant retained overdenture. The provision of care was split between a specialist centre and a primary care setting. This approach reduced inconvenience to the patient. Modern surgical and prosthodontic techniques also reduced the total delivery time. After initial consultation a new set of complete dentures was prescribed with changes in design to the originals. The patient was also planned for placement of two mandibular implants to stabilise and retain the mandibular denture. The first line of treatment involved provision of a new set of dentures constructed by the patient's general dental practitioner. Dental implants were then placed in a specialist centre and the patient returned to the dental practice for attachment of the lower denture to the dental implants. The benefits and success of mandibular implant retained dentures are well documented. With delivery of the overdenture, the patient reported increased satisfaction with his prostheses which allowed him to eat a greater range of foods and enabled him to feel confident when speaking and socialising. [source] Surface EMG of jaw-elevator muscles and chewing pattern in complete denture wearersJOURNAL OF ORAL REHABILITATION, Issue 12 2005M. G. PIANCINO summary, The aim of this study was to investigate the adaptation process of masticatory patterns to a new complete denture in edentulous subjects. For this purpose, muscle activity and kinematic parameters of the chewing pattern were simultaneously assessed in seven patients with complete maxillary and mandibular denture. The patients were analysed (i) with the old denture, (ii) with the new denture at the delivery, (iii) after 1 month and (iv) after 3 months from the delivery of the new denture. Surface electromyographic (EMG) signals were recorded from the masseter and temporalis anterior muscles of both sides and jaw movements were tracked measuring the motion of a tiny magnet attached at the lower inter-incisor point. The subjects were asked to chew a bolus on the right and left side. At the delivery of the new denture, peak EMG amplitude of the masseter of the side of the bolus was lower than with the old denture and the masseters of the two sides showed the same intensity of EMG activity, contrary to the case with the old denture. EMG amplitude and asymmetry of the two masseter activities returned as with the old denture in 3 months. The EMG activity in the temporalis anterior was larger with the old denture than in the other conditions. The chewing cycle width and lateral excursion decreased at the delivery of the new denture and recovered after 3 months. [source] Clinical evaluation of resilient denture liners.JOURNAL OF PROSTHODONTICS, Issue 3 2003Part 2: candida count, speciation Purpose The purpose of this study was to count and to speciate Candida isolated from 2 resilient denture liners, Molloplast-B and MPDS-SL. Materials and Methods A group of 20 patients each had 1 maxillary denture and 2 mandibular dentures fabricated. One mandibular denture was lined with Molloplast-B, and 1 was lined with MPDS-SL. Each denture was used for 3 months. At the end of the 3-month period, the mandibular denture was surrendered, and a 5 × 5-mm circular resilient liner sample was obtained from the tissue surface of the lingual flange. Samples were processed, and Candida was isolated and counted. Speciation of Candida was performed using CHROMagar Candida and API 20C AUX strips. Results Molloplast-B had, on average, 5 times as many CFU/sample as MPDSL-SL, but this difference was not significant (p= 0.26). A sign test gave a similar nonsignificant trend (p= 0.057). CHROMagar identified several Candida species, and confirmation was made using API 20C AUX strips. One patient was lost to follow-up. Of 19 Molloplast-B samples, 7 had no growth, 4 grew C. albicans, 3 grew C. parapsilosis, 2 grew C. glabrata, 1 grew C. tropicalis, 2 grew a Trichosporon spp., and 2 grew a nonidentifiable colony. The analogous counts for 19 MPDS-SL samples were 10, 4, 1, 3, 0, 1, and 1 (p= 0.45 for culture positively, exact McNemar test). ConclusionsCandida growth on Molloplast-B was not significantly different from growth on MPDS-SL. Several yeast species were cultured from each material. The rates of culture-positive testing did not differ between the 2 resilient denture liners. [source] Utilization of the neutral zone technique for a maxillofacial patientJOURNAL OF PROSTHODONTICS, Issue 1 2000Alvin G. Wee BDS The use of a neutral zone technique to fabricate a more stable complete mandibular denture for a maxillofacial patient is presented. The technique incorporates an altered sequence from traditional denture fabrication, resulting in a shortened treatment period. [source] Clinical quality of removable dentures provided by dentists, denturists and laboratory techniciansJOURNAL OF ORAL REHABILITATION, Issue 4 2003R. Tuominen summary, The aim of this study was to evaluate the clinical quality of removable dentures of elderly Finnish men, which had been prepared either by dentists, denturists or dental laboratory technicians. The participants comprised 242 denture-wearing subjects, with 231 maxillary and 177 mandibular removable dentures which had been prepared either by dentists, denturists or dental laboratory technicians. Clinical examinations were carried out without the examining dentist knowing who had provided the dentures. Complete dentures which had been illegally provided by laboratory technicians had significantly poorer retention and fitted less well in tuber and alveolar areas than those provided by either dentists or denturists. Complete maxillary dentures which had been provided illegally by laboratory technicians had significantly (P < 0·01) higher occurrence (90%) of some unacceptable characteristics than those (43%) provided by dentists or denturists. The difference between complete mandibular dentures was also obvious, 86% versus 59%, although statistically non-significant. Of those partial maxillary dentures provided by dentists 53% had some unacceptable characteristics, compared with 80% of those illegally provided by denturists or laboratory technicians (NS). In the case of partial mandibular dentures, 36% of those provided by dentists and 32% of those by denturists or laboratory technicians had some unacceptable characteristic (NS). Illegal provision of removable dentures seemed to be related to decreased clinical quality. [source] Biofilms in the Edentulous Oral CavityJOURNAL OF PROSTHODONTICS, Issue 5 2008Amit Sachdeo BDS, DMSc Abstract Purpose: The oral cavity presents numerous surfaces for microbial colonization. These surfaces produce biofilms of differing complexities unique to each individual. Several studies have looked at biofilms in dentate patients. There has been limited research regarding biofilms on dentures or soft tissues of edentulous patients. The purpose of the present investigation was to provide meaningful data describing microbial ecological relationships in the oral cavity of edentulous patients and to evaluate the microbiota on hard and soft tissue surfaces and saliva in edentulous patients wearing complete dentures. Materials and Methods: Sixty-one edentulous subjects with complete maxillary and mandibular dentures were recruited. "Supragingival" biofilm samples were taken from 28 denture teeth for each subject. Biofilm samples were also taken from the dorsal, lateral, and ventral surfaces of the tongue, floor of mouth, buccal mucosa, hard palate, vestibule/lip, "attached gingiva," and saliva. Samples were individually analyzed for their content of 41 bacterial species using checkerboard DNA,DNA hybridization. Levels and proportions of each species were determined for every sample location. Results: Periodontal pathogens such as Aggregatibacter actinomycetemcomitans and Porphyromonas gingivalis were clearly present in the samples from the edentulous subjects. Microbial profiles in samples from the soft tissue surfaces differed among site locations. Samples from the dorsum of the tongue exhibited the highest bacterial counts followed by the "attached gingiva" and the lateral surfaces of the tongue, while the lowest mean counts were found in samples from the buccal mucosa and labial vestibules. Using cluster analysis of the proportions of the test species, three clusters were formed. The first cluster comprised saliva, supragingival plaque, and the lateral and dorsal surfaces of the tongue. The second cluster comprised the other six soft tissue surfaces. Species on the denture palate formed a third cluster. Conclusions: One of the major findings in this study was the detection of periodontal pathogens, A. actinomycetemcomitans and P. gingivalis, in the edentulous subjects, as these species were thought to disappear after removal of all natural teeth. This finding has implications regarding future dental treatment and the general health of individuals. Distinct patterns of microbial colonization were seen on the different soft tissue surfaces. Thus, this investigation provided the first step in defining the organisms that are associated with edentulous patients on both soft (mucosa) and hard surfaces (denture). The study also provided meaningful data that described microbial ecological relationships in the oral cavity of edentulous subjects. The authors believe that this study is the first comprehensive assessment of the microbiota in the complete denture-wearing subject. [source] Clinical evaluation of resilient denture liners.JOURNAL OF PROSTHODONTICS, Issue 3 2003Part 2: candida count, speciation Purpose The purpose of this study was to count and to speciate Candida isolated from 2 resilient denture liners, Molloplast-B and MPDS-SL. Materials and Methods A group of 20 patients each had 1 maxillary denture and 2 mandibular dentures fabricated. One mandibular denture was lined with Molloplast-B, and 1 was lined with MPDS-SL. Each denture was used for 3 months. At the end of the 3-month period, the mandibular denture was surrendered, and a 5 × 5-mm circular resilient liner sample was obtained from the tissue surface of the lingual flange. Samples were processed, and Candida was isolated and counted. Speciation of Candida was performed using CHROMagar Candida and API 20C AUX strips. Results Molloplast-B had, on average, 5 times as many CFU/sample as MPDSL-SL, but this difference was not significant (p= 0.26). A sign test gave a similar nonsignificant trend (p= 0.057). CHROMagar identified several Candida species, and confirmation was made using API 20C AUX strips. One patient was lost to follow-up. Of 19 Molloplast-B samples, 7 had no growth, 4 grew C. albicans, 3 grew C. parapsilosis, 2 grew C. glabrata, 1 grew C. tropicalis, 2 grew a Trichosporon spp., and 2 grew a nonidentifiable colony. The analogous counts for 19 MPDS-SL samples were 10, 4, 1, 3, 0, 1, and 1 (p= 0.45 for culture positively, exact McNemar test). ConclusionsCandida growth on Molloplast-B was not significantly different from growth on MPDS-SL. Several yeast species were cultured from each material. The rates of culture-positive testing did not differ between the 2 resilient denture liners. [source] Early Functional Loading of Unsplinted Roughened Surface Implants with Mandibular Overdentures 2 Weeks after SurgeryCLINICAL IMPLANT DENTISTRY AND RELATED RESEARCH, Issue 3 2003Alan G.T. Payne BDS, FCD (SA), MDent ABSTRACT Background: Before early functional loading of unsplinted implants with mandibular overdentures can become widespread, more clinical studies are needed to investigate the success of the approach. Purpose: To evaluate the success rates of two types of roughened titanium surface implants with early 2-week functional loading of paired mandibular interforaminal implants with overdentures. Materials and Methods: Random allocation divided 24 strictly selected edentulous participants into two groups, with each group to receive a different implant system (ITI Dental Implant System, Straumann AG, Waldenburg, Switzerland; or Southern Implant System, Southern Implants, Irene, South Africa). Two implants were placed in the anterior mandible of all participants using one-stage standardized surgical procedures. Previously constructed conventional mandibular dentures (opposing maxillary complete dentures) were temporarily relined and worn by the participants for the first 2 weeks; participants used a soft diet. Two weeks after implant surgery and following some mucosal healing, the mandibular dentures had the tissue conditioner removed and the appropriate matrices included for an unsplinted prosthodontic design. Results: No implant from either group was lost. Resonance frequency analysis (RFA) indicated higher primary stability at surgery for the Southern group than for the ITI group, with a statistically significant difference between the groups throughout the study period. The drop in RF values between surgery and 6 weeks was significant and was greater for the Southern group. RFA also indicated stabilized osseointegration between 6 to 12 and 12 to 52 weeks, with no participant showing any decrease in those values over time. Participants with type 3 bone showed a significant improvement in RF values between 12 and 52 weeks, eventually matching those of participants with type 2 bone. There were no significant differences in marginal bone loss, periimplant parameters, or prosthodontic maintenance between the groups over the study period. Conclusions: Using only strict patient selection criteria, 1-year follow-up data indicate that early functional loading of ITI and Southern implants with mandibular two-implant overdentures is possible as early as 2 weeks after implant surgery. [source] One-Year Prospective Evaluation of the Early Loading of Unsplinted Conical Brånemark Fixtures with Mandibular Overdentures Immediately following SurgeryCLINICAL IMPLANT DENTISTRY AND RELATED RESEARCH, Issue 1 2001Alan G.T. Payne BDS, FCD(SA), MDent ABSTRACT Background: Prospective evaluation of the early loading of unsplinted Branemark implants with mandibular over-dentures opposing conventional dentures is not evident in the implant-related literature. Purpose: To clinically evaluate progressive and early loading of 20 unsplinted conical Brånemark implants in edentulous mandibles with overdentures. Materials and Methods: Ten edentulous patients all had two conical Brånemark implants placed in the anterior mandible with mandatory primary stability with bicortical anchorage. Ball abutment connection was performed simultaneously. Previously constructed conventional mandibular dentures were temporarily relined with tissue conditioner postoperatively and worn with moderation for the first 2 weeks to allow progressive loading. Early loading of the implants followed after 2 weeks, with inclusion of the respective matrices in the mandibular dentures, using a definitive reline procedure. Results: All patients successfully functioned with their mandibular implant overdentures from 2 to 52 weeks postoperatively. Mean marginal bone loss was within established criteria for success:0.22 mm (SD = 0.48 mm) mesially and 0.30 mm (SD = 0.39 mm) distally on the conical implants. Mobility tests using the Periotest instrument became more negative, although not at statistically significant levels. Difficulties in the management of the peri-implant mucosa between surgery and loading at 2 weeks were observed in 40% of the patients. Conclusions: These preliminary 1-year results show that successful early loading of unsplinted conical Brånemark implants with mandibular overdentures is possible. [source] | ||||||||||