Home About us Contact
|
Home About us Contact | ||
|
|
||
Lower Polarity (lower + polarity)
Selected AbstractspH-independent hydrolysis of 4-nitrophenyl 2,2-dichloropropionate in aqueous micellar solutions: relative contributions of hydrophobic and electrostatic interactionsJOURNAL OF PHYSICAL ORGANIC CHEMISTRY, Issue 8 2001Omar A. EI Seoud Abstract The pH-independent hydrolysis of 4-nitrophenyl 2,2-dichloropropionate (NPDCP) in the presence of aqueous micelles of sodium dodecyl sulfate, sodium dodecylbenzene sulfonate, alkyltrimethylammonium chlorides, alkyldimethylbenzylammonium chlorides (alkyl,=,cetyl and dodecyl) and polyoxyethylene(9) nonylphenyl ether was studied spectrophotometrically. The observed rate constants, kobs, decrease in the following order: bulk water >cationic micelles >anionic micelles >non-ionic micelles. This order is different from that observed for pH-independent hydrolysis of 4-nitrophenyl chloroformate (NPCF), whose reaction is faster in cationic micelles than in bulk water. A proton NMR study on solubilization of a model ester, 4-nitrophenyl 2-chloropropionate, showed that the methylene groups in the middle of the surfactant hydrophobic chain are most affected by the solubilizate. Lower polarity and high ionic strength of interfacial water decrease the rates of hydrolysis of both NPCF and NPDCP, but the fraction of the former ester that diffuses to the interface is probably higher than that of the latter. Therefore, whereas the (negatively charged) transition state of NPCF is stabilized by cationic interfaces and destabilized by anionic interfaces, that of NPDCP is negligibly affected by ionic interfaces, which explains the observed rate retardation by all ionic micelles. Calculated activation parameters corroborate our explanation. Copyright © 2001 John Wiley & Sons, Ltd. [source] Poly(urethanes) containing silarylene and/or germarylene unitsJOURNAL OF APPLIED POLYMER SCIENCE, Issue 1 2008C. A. Terraza Abstract A series of 10 poly(urethanes) were synthesized by solution polymerization from bis(chloroformates) and aromatic diamines, containing both silicon or germanium as central atom. So, the polymers prepared contain two silicon atoms or two germanium atoms exclusively or combinations of both. Me, Et, and Ph groups were bonded to the central atoms according to the nature of the monomers employed. Poly(urethanes) were characterized by FTIR, 1H, 13C, and 29Si NMR spectroscopy and the results agreed with the proposed structures. Additionally, intrinsic viscosity values were established in DMSO solutions and thermal analyses were developed. In all cases, thermostable oligomers were obtained, which showed a degradation process beginning at ,240,260°C. Polymers showed a thermal dependence with the nature of the heteroatom employed. Thus, in general, when germanium was used as central atom, the thermal stability was higher than the polymers containing silicon which agrees with the lower polarity and higher energy of the CGe bond in comparison with the CSi one. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008. [source] Synthesis and characterization of core,shell-type polymeric micelles from diblock copolymers via reversible addition,fragmentation chain transferJOURNAL OF POLYMER SCIENCE (IN TWO SECTIONS), Issue 10 2006Ping Zhang Abstract A method was developed to enable the formation of nanoparticles by reversible addition,fragmentation chain transfer polymerization. The thermoresponsive behavior of polymeric micelles was modified by means of micellar inner cores and an outer shell. Polymeric micelles comprising AB block copolymers of poly(N -isopropylacrylamide) (PIPAAm) and poly(2-hydroxyethylacrylate) (PHEA) or polystyrene (PSt) were prepared. PIPAAm- b -PHEA and PIPAAm- b -PSt block copolymers formed a core,shell micellar structure after the dialysis of the block copolymer solutions in organic solvents against water at 20 °C. Upon heating above the lower critical solution temperature (LCST), PIPAAm- b -PHEA micelles exhibited an abrupt increase in polarity and an abrupt decrease in rigidity sensed by pyrene. In contrast, PIPAAm- b -PSt micelles maintained constant values with lower polarity and higher rigidity than those of PIPAAm- b -PHEA micelles over the temperature range of 20,40 °C. Structural deformations produced by the change in the outer polymer shell with temperature cycles through the LCST were proposed for the PHEA core, which possessed a lower glass-transition temperature (ca. 20 °C) than the LCST of the PIPAAm outer shell (ca. 32.5 °C), whereas the PSt core with a much higher glass-transition temperature (ca. 100 °C) retained its structure. The nature of the hydrophobic segments composing the micelle inner core offered an important control point for thermoresponsive drug release and the drug activity of the thermoresponsive polymeric micelles. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3312,3320, 2006 [source] Trifluoroethanol and binding to model membranes stabilize a predicted turn in a peptide corresponding to the first extracellular loop of the angiotensin II AT1A receptorBIOPOLYMERS, Issue 1 2002Roberto K. Salinas Abstract Homology modeling of the angiotensin II AT1A receptor based on rhodopsin,s crystal structure has assigned the 92,100 (YRWPFGNHL) sequence of the receptor to its first extracellular loop. Solution and membrane-bound conformational properties of a peptide containing this sequence (EL1) were examined by CD, fluorescence, and 1H-NMR. CD spectra in aqueous solution revealed an equilibrium between less organized and folded conformers. NMR spectra indicated the coexistence of trans and cis isomers of the Trp3,Pro4 bond. A positive band at 226 nm in the CD spectra suggested aromatic ring stacking, modulated by EL1's ionization degree. CD spectra showed that trifluoroethanol (TFE), or binding to detergent micelles and phospholipid bilayers, shifted the equilibrium toward conformers with higher secondary structure content. Different media gave rise to spectra suggestive of different ,-turns. Chemical shift changes in the NMR spectra corroborated the stabilization of different conformations. Thus, environments of lower polarity or binding to interfaces probably favored the formation of hydrogen bonds, stabilizing ,-turns, predicted for this sequence in the whole receptor. Increases in Trp3 fluorescence intensity and anisotropy, blue shifts of the maximum emission wavelength, and pK changes also evinced the interaction between EL1 and model membranes. Binding was seen to depend on both hydrophobic and electrostatic interactions, as well as lipid phase packing. Studies with water-soluble and membrane-bound fluorescence quenchers demonstrated that Trp3 is located close to the water,membrane interface. The results are discussed with regard to possible implications in receptor folding and function. © 2002 Wiley Periodicals, Inc. Biopolymers 65: 21,31, 2002 [source] | |||||||||||||