Home About us Contact
|
Home About us Contact | ||
|
|
||
LC Separation (lc + separation)
Selected AbstractsIdentification and determination of the saikosaponins in Radix bupleuri by accelerated solvent extraction combined with rapid-resolution LC-MSJOURNAL OF SEPARATION SCIENCE, JSS, Issue 13 2010Yun-Yun Yang Abstract A method based on accelerated solvent extraction combined with rapid-resolution LC,MS for efficient extraction, rapid separation, online identification and accurate determination of the saikosaponins (SSs) in Radix bupleuri (RB) was developed. The RB samples were extracted by accelerated solvent extraction using 70% aqueous ethanol v/v as solvent, at a temperature of 120°C and pressure of 100,bar, with 10,min of static extraction time and three extraction cycles. Rapid-resolution LC separation was performed by using a C18 column at gradient elution of water (containing 0.5% formic acid) and acetonitrile, and the major constituents were well separated within 20,min. A TOF-MS and an IT-MS were used for online identification of the major constituents, and 27 SSs were identified or tentatively identified. Five major bioactive SSs (SSa, SSc, SSd, 6,- O -acetyl-SSa and 6,- O -acetyl-SSd) with obvious peak areas and good resolution were chosen as benchmark substances, and a triple quadrupole MS operating in multiple-reaction monitoring mode was used for their quantitative analysis. A total of 16 RB samples from different regions of China were analyzed. The results indicated that the method was rapid, efficient, accurate and suitable for use in the quality control of RB. [source] Liquid chromatography combined with mass spectrometry for 13C isotopic analysis in life science researchMASS SPECTROMETRY REVIEWS, Issue 6 2007Jean-Philippe Godin Abstract Among the different disciplines covered by mass spectrometry, measurement of 13C/12C isotopic ratio crosses a large section of disciplines from a tool revealing the origin of compounds to more recent approaches such as metabolomics and proteomics. Isotope ratio mass spectrometry (IRMS) and molecular mass spectrometry (MS) are the two most mature techniques for 13C isotopic analysis of compounds, respectively, for high and low-isotopic precision. For the sample introduction, the coupling of gas chromatography (GC) to either IRMS or MS is state of the art technique for targeted isotopic analysis of volatile analytes. However, liquid chromatography (LC) also needs to be considered as a tool for the sample introduction into IRMS or MS for 13C isotopic analyses of non-volatile analytes at natural abundance as well as for 13C-labeled compounds. This review presents the past and the current processes used to perform 13C isotopic analysis in combination with LC. It gives particular attention to the combination of LC with IRMS which started in the 1990's with the moving wire transport, then subsequently moved to the chemical reaction interface (CRI) and was made commercially available in 2004 with the wet chemical oxidation interface (LC-IRMS). The LC-IRMS method development is also discussed in this review, including the possible approaches for increasing selectivity and efficiency, for example, using a 100% aqueous mobile phase for the LC separation. In addition, applications for measuring 13C isotopic enrichments using atmospheric pressure LC-MS instruments with a quadrupole, a time-of-flight, and an ion trap analyzer are also discussed as well as a LC-ICPMS using a prototype instrument with two quadrupoles. © 2007 Wiley Periodicals, Inc., Mass Spec Rev 26:751,774, 2007 [source] Segmented post-column analyte addition; a concept for continuous response control of liquid chromatography/mass spectrometry peaks affected by signal suppression/enhancementRAPID COMMUNICATIONS IN MASS SPECTROMETRY, Issue 5 2005Anton Kaufmann A novel technique, "segmented post-column analyte addition", is proposed to visualize and compensate signal suppression/enhancement effects in electrospray ionization tandem mass spectrometry (ESI-MS/MS). Instead of delivering a constant flow of analyte solution between the liquid chromatography (LC) column exit and the ESI interface into the eluent resulting from LC separation of analyte-free matrix in order to determine retention time widows in which suppression/enhancement is unimportant (King et al., J. Am. Soc. Mass Spectrom. 2000; 11: 942), segmented packets of analyte-containing solvent and analyte-free solvent were infused into an LC eluent resulting from separation of an analyte-containing sample. The obtained, superimposed, periodic spikes are much narrower than the analyte peak eluting from the column. The height of the spikes is affected by signal suppression phenomena to the same extent as the analyte signal, and hence variations of the spike height can be used to correct the peak area of analyte peaks affected by signal suppression/enhancement. Copyright © 2005 John Wiley & Sons, Ltd. [source] Closely spaced external standard: a universal method of achieving 5 ppm mass accuracy over the entire MALDI plate in axial matrix-assisted laser desorption/ionization time-of-flight mass spectrometryRAPID COMMUNICATIONS IN MASS SPECTROMETRY, Issue 19 2003Eugene Moskovets Close deposition of the sample and external standard was used in axial matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS) to achieve mass accuracy equivalent to that obtained with an internal standard across the entire MALDI plate. In this work, the sample and external standard were deposited by continuous deposition in separate traces, each approximately 200,,m wide. The dependence of the mass accuracy on the distance between the sample and standard traces was determined across a MALDI target plate with dimensions of 57.5,mm,×,57.0,mm by varying the gap between the traces from 100,,m to 4,mm. During acquisition, two adjacent traces were alternately irradiated with a 200-Hz laser, such that the peaks in the resulting mass spectra combined the sample and external standard. Ion suppression was not observed even when the peptide concentrations in the two traces differed by more than two orders of magnitude. The five peaks from the external standard trace were used in a four-term mass calibration of the masses of the sample trace. The average accuracy across the whole plate with this method was 5,ppm when peaks of the sample trace had signal-to-noise ratios of at least 30 and the gap between the traces was approximately 100,,m. This approach was applied to determining peptide masses of a reversed-phase liquid chromatographic (LC) separation of a tryptic digest of , -galactosidase deposited as a long serpentine trace across the MALDI plate, with accuracy comparable to that obtainable using internal calibration. In addition, the eluent from reversed-phase LC separation of a strong cation-exchange fraction containing tryptic peptides from a yeast lysate along with the closely placed external standard was deposited on the MALDI plate. The data obtained in the MS and MS/MS modes on a MALDI-TOF/TOF mass spectrometer were combined and used in database searching with MASCOT. Since the significant score is a function of mass accuracy in the MS mode, database searching with high mass accuracy reduced the number of false positives and also added peptides which otherwise would have been eliminated at lower mass accuracy (false negatives). Copyright © 2003 John Wiley & Sons, Ltd. [source] Analysis of pyridoquinoline derivatives by liquid chromatography/atmospheric pressure chemical ionization mass spectrometryRAPID COMMUNICATIONS IN MASS SPECTROMETRY, Issue 11 2001Y. Picó A method using liquid chromatography/atmospheric pressure chemical ionization mass spectrometry (LC/APCI-MS) has been developed for the characterization and determination of pyridoquinoline derivatives 4,6-bis(dimethylaminoethylamino)-2,8,10-trimethylpyrido[3,2-g]quinoline, 4,6-bis(dimethylaminoethoxy)-2,8,10-trimethylpyrido[3,2-g]quinoline and 4,6-bis[(dimethylaminoethyl)thio]-2,8,10-trimethylpyrido[3,2-g] quinoline, all with potential antitumor properties. LC separation was performed on a conventional C18 column using a binary mobile phase composed of acetonitrile and 50,mM aqueous ammonium formate at pH 3. The APCI mass spectra obtained showed that proton addition giving [M,+,H]+ was the common mode of ionization to the amino- and thiopyridoquinolines, whereas the alkoxypyridoquinoline was identified by the main formation of the [M,,,(C2H3)N(CH3)2,+,H]+, followed by the [M,+,H]+ ion. The LC separation conditions and MS detection parameters were optimized for the determination. The analytical method was also applied to the determination of these pyridoquinoline derivatives in fetal calf serum using liquid-liquid extraction with dichloromethane. Acceptable recovery values were obtained, ranging between 45 and 98%. Copyright © 2001 John Wiley & Sons, Ltd. [source] Determination of caudatin-2,6-dideoxy-3 -O- methy- , - d -cymaropyranoside in rat plasma using liquid chromatography,tandem mass spectrometryBIOMEDICAL CHROMATOGRAPHY, Issue 6 2008Yunru Peng Abstract A selective, sensitive and rapid liquid chromatography,tandem mass spectrometry method has been developed for the determination of caudatin-2,6-dideoxy-3 -O- methy- , - d -cymaropyranoside (CDMC) in rat plasma. This method involves a plasma clean-up step using liquid,liquid extraction, followed by LC separation and positive electrospray ionization mass spectrometry detection (LC/ESI-MS/MS). Chromatographic separation of the analytes was achieved using a C18 column with a mobile phase of acetonitrile and water (70:30, v/v) at a flow rate of 1.0 mL/min. Low energy collision tandem mass spectrometric analysis (CID-MS/MS) using the multiple reaction monitoring (MRM) mode was used for analyte quantification. For the MRM analysis of CDMC, the following transition at m/z 658.4 , 529.6 derived from the protonated molecule [M + Na]+. A calibration curve was linear in the 5,500 ng/mL range for CDMC, and the limit of detection was 5 ng/mL. The inter- and intra-day precisions (RSD) were ,8.5 and ,9.1%, respectively. The accuracy (RE) was ± 10.9%. The novel developed LC/ESI-MS/MS method was successfully applied to pharmacokinetic studies of CDMC after oral administration to rats. The total chromatographic run time of this method was 5.0 min per sample, allowing for analysis of a large number of samples per batch. Copyright © 2008 John Wiley & Sons, Ltd. [source] Liquid chromatography-tandem mass spectrometry for the determination of a new oxazolidinone antibiotic DA-7867 in human plasmaBIOMEDICAL CHROMATOGRAPHY, Issue 2 2004Hye Young Ji Abstract A liquid chromatography-tandem mass spectrometric (LC/MS/MS) method for the determination of a new ox-azolidinone antibiotic DA-7867, (S)-[N -3-(4-(2-(1-methyl-5-tetrazolyl)-pyridine-5-yl)-3-,uorophenyl)-2-oxo-5-oxazolidinyl]methyl acetamide, in human plasma was developed. DA-7867 and internal standard, linezolid, were extracted from human plasma with ethyl acetate at acidic pH. A reverse-phase LC separation was performed on Luna C8 column with the mixture of acetonitrile,ammonium formate (10 mm, pH 4.5; 35:65, v/v) as mobile phase. The analytes were determined using an electrospray ionization tandem mass spectrometry in the multiple-reaction-monitoring mode. The lower limits of quanti,cation for DA-7867 was 2.5 ng/mL. The single liquid,liquid extraction quantitatively recovered DA-7867 and internal standard from plasma samples at the ranges of 82.2,86.7%. DA-7867 was stable in blank human plasma at room temperature for 24 h and following three freeze,thaw cycles. Copyright © 2003 John Wiley & Sons, Ltd. [source] Peak shape improvement of basic analytes in capillary liquid chromatographyJOURNAL OF SEPARATION SCIENCE, JSS, Issue 3 2005Anja Prüß Abstract The analysis of bases is of special interest in pharmaceutical research because numerous active substances contain basic functional groups. Capillary and conventional size LC separations of drug substances spiked with potential impurities were compared. In the case of the nonpolar drug levonorgestrel equal separation efficiency was readily attained by both techniques. The peaks of basic substances, however, showed extensive tailing when separated by capillary LC. The peak deformation was attributable to interactions of the basic substances with the polar inner surface of the fused silica capillaries employed in capillary LC and does not appear with the steel tubing generally used in conventional size LC. This drawback of capillary LC was overcome by use of deactivated fused silica capillaries for column hardware and transfer lines. [source] Identification of N -linked oligosaccharide labeled with 1-pyrenesulfonyl chloride by quadrupole time-of-flight tandem mass spectrometry after separation by micro- and nanoflow liquid chromatographyBIOMEDICAL CHROMATOGRAPHY, Issue 9 2009Jun Zhe Min Abstract The development of a qualitative determination method for the N -linked oligosaccharides in glycoproteins was attempted by the combination of micro- or nanoflow LC with Q-TOF-MS/MS. The asparaginyl-oligosaccharides in glycoproteins, liberated from the treatment of Pronase E, were separated, purified and labeled with 1-pyrenesulfonyl chloride (PSC). The resulting derivatives were separated by the microflow LC system utilizing a 0.5 mm diameter microcolumn or nanoflow LC system utilizing a 75 µm diameter chip column. The eluted N -linked oligosaccharide derivatives were then introduced into the Q-TOF-MS instrument and sensitively detected in the ESI+ mode. Several factors (i.e. fragmentor, skimmer, Vcap voltages and collision energy) affecting the sensitivity of Q-TOF-MS/MS detection were optimized in both the micro- and nanoflow LC systems. Various fragment ions based on the carbohydrate units appeared on the MS/MS spectra. Among the peaks, m/z 600.16 corresponding to PSC-labeled Asp-HexNAc is the most important one to identify the asparaginyl-oligosaccharide. The N -linked oligosaccharides in the ovalbumin were easily identified by the selected-ion chromatogram at m/z 600.16 by the MS/MS detection. Therefore, the identification of N -linked oligosaccharides in glycoproteins seems to be possible by the proposed micro- and nanoflow LC separations followed by the Q-TOF-MS/MS detection. Copyright © 2009 John Wiley & Sons, Ltd. [source] | ||||||||||