Home About us Contact
|
Home About us Contact | ||
|
|
||
Hydrogen Bubbles (hydrogen + bubble)
Selected AbstractsNanoporous Structures Prepared by an Electrochemical Deposition Process,ADVANCED MATERIALS, Issue 19 2003H.-C. Shin Free-standing metal foam structures with nano-dendritic walls of copper and tin are fabricated by an electrochemical deposition process. This unique structure is attributed to the concurrent generation of hydrogen bubbles with extremely fast metal deposition at high cathodic current densities. The Figure shows a typical example of the foam-like structure of tin deposits with walls composed of nano-dendritic branches. [source] Study of the production of hydrogen bubbles at low current densities for electroflotation processesJOURNAL OF CHEMICAL TECHNOLOGY & BIOTECHNOLOGY, Issue 10 2010Carlos Jiménez Abstract BACKGROUND: Flotation processes are widely used in waste-water treatment and it is quite important to have a tool to determine and optimize the size distribution of the bubbles produced. In this work, the electrochemical production of bubbles to enhance the performance of electrocoagulation processes by flotation is studied. To do this, a current density range characteristic of electrocoagulation processes is used to produce microbubbles (<5 mA cm,2), instead of the higher values used in other studies to characterize electroflotation in non-combined processes. RESULTS: Current density and pH were found to influence the process significantly. In the range used, higher current densities allow a larger number of small size bubbles to be obtained, appropriate for use in electroflotation processes. However, at the boundaries of the range, the size of the bubbles was increased advising against use. Neutral pH values also favour the formation of small bubbles, and the presence of possible competing reactions have to be considered because they diminish the gas flow and affect the number of bubbles and their size. The roughness of the surface of the electrode material also has an important influence. CONCLUSIONS: The image acquisition and analysis system developed allows measurement of the size distribution of hydrogen bubbles in the range of current densities studied. Current density and pH seem to be the main parameters affecting the mean diameter of bubbles and the amount of gas produced, and the electrode material may also influence hydrogen production significantly. Copyright © 2010 Society of Chemical Industry [source] Chlorophenol dehalogenation in a magnetically stabilized fluidized bed reactorAICHE JOURNAL, Issue 3 2006Lisa J. Graham Abstract Aromatic halocarbons are often present in contaminated aquifers, surface waters, wastewater streams, soils, and hazardous wastes. The dehalogenation of p-chlorophenol as a model compound in both the aqueous phase and in slurries of contaminated solids using a magnetically stabilized fluidized bed (MSFB) reactor is discussed. Composite palladium-iron (Pd/Fe) media are employed as both catalyst and sacrificial reactant for the reductive dechlorination of p-chlorophenol. Calcium alginate beads impregnated with Pd/Fe granules are fluidized in a recirculating aqueous stream containing either dissolved p-chlorophenol or a slurry of soil contaminated with this chlorocarbon. Magnetic stabilization of the fluidized bed allows substantially higher rates of mass transfer than would otherwise be achievable, and allows circulation of contaminated solids while fluidization media are retained. Anoxic conditions are sustained under a nitrogen purge and the solution pH of 5.8 is maintained by active control to minimize surface fouling by hydroxides, and to minimize mass-transfer resistances resulting from the surface accumulation of hydrogen bubbles. A model of this process is described and the resulting predictions are compared to the experimentally derived data. © 2005 American Institute of Chemical Engineers AIChE J, 2006 [source] | ||||||||||