Home About us Contact
|
Home About us Contact | ||
|
|
||
Hydrogel Films (hydrogel + film)
Selected AbstractsChitosan Hydrogel-Capped Porous SiO2 as a pH Responsive Nano-Valve for Triggered Release of InsulinADVANCED FUNCTIONAL MATERIALS, Issue 5 2009Jianmin Wu Abstract A pH responsive, chitosan-based hydrogel film is used to cap the pores of a porous SiO2 layer. The porous SiO2 layer is prepared by thermal oxidation of an electrochemically etched Si wafer, and the hydrogel film is prepared by reaction of chitosan with glycidoxypropyltrimethoxysilane (GPTMS). Optical reflectivity spectroscopy and scanning electron microscopy (SEM) confirm that the bio-polymer only partially infiltrates the porous SiO2 film, generating a double layer structure. The optical reflectivity spectrum displays Fabry,Pérot interference fringes characteristic of a double layer, which is characterized using reflective interferometric Fourier transform spectroscopy (RIFTS). Monitoring the position of the RIFTS peak corresponding to the hydrogel layer allows direct, real-time observation of the reversible volume phase transition of the hydrogel upon cycling of pH in the range 6.0,7.4. The swelling ratio and response time are controlled by the relative amount of GPTMS in the hydrogel. The pH-dependent volume phase transition can be used to release insulin trapped in the porous SiO2 layer underneath the hydrogel film. At pH 7.4, the gel in the top layer effectively blocks insulin release, while at pH 6.0 insulin penetrates the swollen hydrogel layer, resulting in a steady release into solution. [source] Synthesis of pH dependent chitosan-EPI hydrogel films and their application for in vitro release of promethazine hydrochlorideJOURNAL OF APPLIED POLYMER SCIENCE, Issue 1 2008Yolda Abstract Chitosan-epichlorohydrin hydrogel films (ChitEPI) were synthesized by using chitosan in the presence of epichlorohydrin (EPI) as a crosslinking agent at various amounts. SEM, FTIR, TGA, and DSC analysis were conducted for the characterization of the hydrogels. The DSC measurements indicate that ChitEPI hydrogels did not exhibit better thermal stability when compared to chitosan. Swelling behavior of Chitosan-EPI hydrogel film is pH dependent and showed a reversible swelling behavior with a fast response. The hydrogels were used for in vitro release of promethazine hydrochloride (PHCl) in pH = 1.2 and pH = 7.4 phosphate buffer solutions (PBS). The release of PHCl synthesized from hydrogels at pH = 7.4 is quite low while at pH = 1.2, the highest value was observed as 49% for ChitEPI600. It has been also found that PHCl release from ChitEPI thin films is mainly controlled by diffusion control mechanism. ChitEPI hydrogels may be used for the delivery of drug in stomach and gastrointestinal tract. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008 [source] Glucose-sensitive holographic sensors,JOURNAL OF MOLECULAR RECOGNITION, Issue 3 2004S. Kabilan Abstract Holographic sensors for monitoring glucose were fabricated from hydrogel films containing chemical ligands based on phenylboronic acid. The films were transformed into reflection holograms using a diffusion method coupled with exposure to laser light. The diffraction wavelength of the holograms was used to monitor the swelling of the hydrogel film in the presence of glucose. Fully reversible changes in diffraction wavelength were demonstrated, highlighting the potential for using these holograms as glucose sensors. Copyright © 2004 John Wiley & Sons, Ltd. [source] Harnessing Surface Wrinkle Patterns in Soft MatterADVANCED FUNCTIONAL MATERIALS, Issue 16 2010Shu Yang Abstract Mechanical instabilities in soft materials, specifically wrinkling, have led to the formation of unique surface patterns for a wide range of applications that are related to surface topography and its dynamic tuning. In this progress report, two distinct approaches for wrinkle formation, including mechanical stretching/releasing of oxide/PDMS bilayers and swelling of hydrogel films confined on a rigid substrate with a depth-wise modulus gradient, are discussed. The wrinkling mechanisms and transitions between different wrinkle patterns are studied. Strategies to control the wrinkle pattern order and characteristic wavelength are suggested, and some efforts in harnessing topographic tunability in elastomeric PDMS bilayer wrinkled films for various applications, including tunable adhesion, wetting, microfluidics, and microlens arrays, are highlighted. The report concludes with perspectives on the future directions in manipulation of pattern formation for complex structures, and potential new technological applications. [source] In-Film Bioprocessing and Immunoanalysis with Electroaddressable Stimuli-Responsive PolysaccharidesADVANCED FUNCTIONAL MATERIALS, Issue 10 2010Xiaohua Yang Abstract Advances in thin-film fabrication are integral to enhancing the power of microelectronics while fabrication methods that allow the integration of biological molecules are enabling advances in bioelectronics. A thin-film-fabrication method that further extends the integration of biology with microelectronics by allowing living biological systems to be assembled, cultured, and analyzed on-chip with the aid of localized electrical signals is described. Specifically, the blending of two stimuli-responsive film-forming polysaccharides for electroaddressing is reported. The first, alginate, can electrodeposit by undergoing a localized sol,gel transition in response to electrode-imposed anodic signals. The second, agarose, can be co-deposited with alginate and forms a gel upon a temperature reduction. Electrodeposition of this dual polysaccharide network is observed to be a simple, rapid, and spatially selective means for assembly. The bioprocessing capabilities are examined by co-depositing a yeast clone engineered to display a variable lymphocyte receptor protein on the cell surface. Results demonstrate the in-film expansion and induction of this cell population. Analysis of the cells' surface proteins is achieved by the electrophoretic delivery of immunoreagents into the film. These results demonstrate a simple and benign means to electroaddress hydrogel films for in-film bioprocessing and immunoanalysis. [source] Functionalized, Swellable Hydrogel Layers as a Platform for Cell StudiesADVANCED FUNCTIONAL MATERIALS, Issue 8 2009Núria Marí-Buyé Abstract This paper reports the design, synthesis and characterization of thin films as a platform for studying the separate influences of physical and chemical cues of a matrix on the adhesion, growth and final phenotype of cells. Independent control of the physical and chemical properties of functionalized, swellable hydrogel thin films is achieved using initiated chemical vapor deposition (iCVD). The systematic variation in crosslink density is demonstrated to control the swelling ability of the iCVD hydrogel films based on 2-hydroxyethyl methacrylate (HEMA). At the same time, the incorporation of controllable concentrations of the active ester pentafluorophenyl methacrylate (PFM) allows easy immobilization of aminated bioactive motifs, such as bioactive peptides. Initial cell culture results with human umbilical vein endothelial cells (HUVEC) indicate that the strategy of using PFM to immobilize a cell-adhesion peptide motif onto the hydrogel layers promotes proper HUVEC growth and enhances their phenotype. [source] Stimuli-Responsive Porous Hydrogels at Interfaces for Molecular Filtration, Separation, Controlled Release, and Gating in Capsules and MembranesADVANCED MATERIALS, Issue 31 2010Ihor Tokarev Abstract A continuously growing area of controlled and tunable transport and separation of biomolecules and drugs has recently attracted attention to the structures which can be referred to as stimuli-responsive porous hydrogel thin films. Because of spatial constraints, swelling/shrinking of the hydrogel films results in closing/opening (or vice versa) of the film's pores. Such responsive systems can be used in the configuration of plane films or capsules. The combination of a low thickness (translating into a low hydrodynamic flow resistance and rapid response) with well-defined size and shape of pores (translating into better control of transport and separation), which can be closed, opened, or tuned by an external signal (allowing a large amplitude of changes in diffusivity of solutes in the thin film and a precise control of the pore size), makes these materials very attractive for a range of applications, such as molecular filtration, separation, drug delivery, sensors, and actuators. [source] Synthesis of pH dependent chitosan-EPI hydrogel films and their application for in vitro release of promethazine hydrochlorideJOURNAL OF APPLIED POLYMER SCIENCE, Issue 1 2008Yolda Abstract Chitosan-epichlorohydrin hydrogel films (ChitEPI) were synthesized by using chitosan in the presence of epichlorohydrin (EPI) as a crosslinking agent at various amounts. SEM, FTIR, TGA, and DSC analysis were conducted for the characterization of the hydrogels. The DSC measurements indicate that ChitEPI hydrogels did not exhibit better thermal stability when compared to chitosan. Swelling behavior of Chitosan-EPI hydrogel film is pH dependent and showed a reversible swelling behavior with a fast response. The hydrogels were used for in vitro release of promethazine hydrochloride (PHCl) in pH = 1.2 and pH = 7.4 phosphate buffer solutions (PBS). The release of PHCl synthesized from hydrogels at pH = 7.4 is quite low while at pH = 1.2, the highest value was observed as 49% for ChitEPI600. It has been also found that PHCl release from ChitEPI thin films is mainly controlled by diffusion control mechanism. ChitEPI hydrogels may be used for the delivery of drug in stomach and gastrointestinal tract. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008 [source] Glucose-sensitive holographic sensors,JOURNAL OF MOLECULAR RECOGNITION, Issue 3 2004S. Kabilan Abstract Holographic sensors for monitoring glucose were fabricated from hydrogel films containing chemical ligands based on phenylboronic acid. The films were transformed into reflection holograms using a diffusion method coupled with exposure to laser light. The diffraction wavelength of the holograms was used to monitor the swelling of the hydrogel film in the presence of glucose. Fully reversible changes in diffraction wavelength were demonstrated, highlighting the potential for using these holograms as glucose sensors. Copyright © 2004 John Wiley & Sons, Ltd. [source] | ||||||||||