Home  About us  Contact
 

Hi-Nicalon Fibers (hi-nicalon + fiber)

Distribution by Scientific Domains
Polymers and Materials Science100%

Selected Abstracts

Thermal Stability of a Chemically Vapor Deposited Multilayer Coating Containing Amorphous Silica and Rutile Titania on Hi-Nicalon Fiber

JOURNAL OF THE AMERICAN CERAMIC SOCIETY, Issue 10 2003
Jinil Lee
A multilayer coating consisting of consecutive layers of amorphous-silica, rutile-titania, and amorphous-silica was prepared on Hi-Nicalon fiber by chemical vapor deposition at 1050°C. It appeared that the silica and titania layers were strongly bonded to each other with no evidence of detachment and crack deflection at the interface region. The layered structure became morphologically unstable because of the growth of titania grains, the crystallization of the silica layers, and the oxidation of the fiber on exposure to 1200°C in air for 92 h. [source]

Influence of Interface Characteristics on the Mechanical Properties of Hi-Nicalon type-S or Tyranno-SA3 Fiber-Reinforced SiC/SiC Minicomposites

INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY, Issue 3 2010
C. Sauder
The tensile behavior of CVI SiC/SiC composites with Hi-Nicalon type-S (Hi-NicalonS) or Tyranno-SA3 (SA3) fibers was investigated using minicomposite test specimens. Minicomposites contain a single tow. The mechanical behavior was correlated with microstructural features including tow failure strength and interface characteristics. The Hi-NicalonS fiber-reinforced minicomposites exhibited a conventional damage-tolerant response, comparable to that observed on composites reinforced by untreated Nicalon or Hi-Nicalon fibers and possessing weak fiber/matrix interfaces. The SA3 fiber-reinforced minicomposites exhibited larger interfacial shear stresses and erratic behavior depending on the fiber PyC coating thickness. Differences in the mechanical behavior were related to differences in the fiber surface roughness. [source]

Zirconia,Silica,Carbon Coatings on Ceramic Fibers

JOURNAL OF THE AMERICAN CERAMIC SOCIETY, Issue 10 2004
Emmanuel E. Boakye
Precursors for zircon,carbon mixtures were made to coat fibers for ceramic-matrix composites. Precursors were characterized using XRD, TGA, and DTA. Zircon formed from vanadium- or lithium-doped precursors after heat treatments at ,900°C in air, but it did not form at 1200°,1400°C in argon when large amounts of carbon were added. Some precursors were used to coat NextelÔ 720 and Hi-NicalonÔ fibers. The coatings were characterized using SEM and TEM, and coated-fiber tensile strengths were measured. Although zircon formed in powders, only tetragonal-zirconia,silica mixed phases formed in fiber coatings at 1200°C in air. Loss of vanadium oxide flux to the fibers may have caused the lack of conversion to zircon. The strengths of the coated fibers were severely degraded after heat treatment at ,1000°C in air, but not in argon. The coated fibers were compared with zirconia,carbon-coated fibers made using similar methods. Mechanisms for fiber strength degradation are discussed. [source]