Home About us Contact
|
Home About us Contact | ||
|
|
||
Focal Plane (focal + plane)
Selected AbstractsPosition-dependent defocus processing for acoustic holography imagesINTERNATIONAL JOURNAL OF IMAGING SYSTEMS AND TECHNOLOGY, Issue 3 2002Ruming Yin Acoustic holography is a transmission-based ultrasound imaging method that uses optical image reconstruction and provides a larger field of view than pulse-echo ultrasound imaging. A focus parameter controls the position of the focal plane along the optical axis, and the images obtained contain defocused content from objects not near the focal plane. Moreover, it is not always possible to bring all objects of interest into simultaneous focus. In this article, digital image processing techniques are presented to (1) identify a "best focused" image from a sequence of images taken with different focus settings and (2) simultaneously focus every pixel in the image through fusion of pixels from different frames in the sequence. Experiments show that the three-dimensional image information provided by acoustic holography requires position-dependent filtering for the enhancement step. It is found that filtering in the spatial domain is more computationally efficient than in the frequency domain. In addition, spatial domain processing gives the best performance. © 2002 Wiley Periodicals, Inc. Int J Imaging Syst Technol 12, 101,111, 2002; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/ima.10017 [source] Infrared Microscopic Imaging of Bone: Spatial Distribution of CO32,JOURNAL OF BONE AND MINERAL RESEARCH, Issue 5 2001H. Ou-Yang Abstract This article describes a novel technology for quantitative determination of the spatial distribution of CO32, substitution in bone mineral using infrared (IR) imaging at ,6 ,m spatial resolution. This novel technology consists of an IR array detector of 64 × 64 elements mapped to a 400 ,m × 400 ,m spot at the focal plane of an IR microscope. During each scan, a complete IR spectrum is acquired from each element in the array. The variation of any IR parameter across the array may be mapped. In the current study, a linear relationship was observed between the band area or the peak height ratio of the CO32, v3 contour at 1415 cm,1 to the PO43, v1,v3 contour in a series of synthetic carbonated apatites. The correlation coefficient between the spectroscopically and analytically determined ratios (R2 = 0.989) attests to the practical utility of this IR area ratio for determination of bone CO32, levels. The relationship forms the basis for the determination of CO32, in tissue sections using IR imaging. In four images of trabecular bone the average CO32, levels were 5.95 wt% (2298 data points), 6.67% (2040 data points), 6.66% (1176 data points), and 6.73% (2256 data points) with an overall average of 6.38 ± 0.14% (7770 data points). The highest levels of CO32, were found at the edge of the trabeculae and immediately adjacent to the Haversian canal. Examination of parameters derived from the phosphate v1,v3 contour of the synthetic apatites revealed that the crystallinity/perfection of the hydroxyapatite (HA) crystals was diminished as CO32, levels increased. The methodology described will permit evaluation of the spatial distribution of CO32, levels in diseased and normal mineralized tissues. [source] Design and development of a prototype endocavitary probe for high-intensity focused ultrasound delivery with integrated magnetic resonance imagingJOURNAL OF MAGNETIC RESONANCE IMAGING, Issue 3 2007Iain P. Wharton MRCS Abstract Purpose To integrate a high intensity focused ultrasound (HIFU) transducer with an MR receiver coil for endocavitary MR-guided thermal ablation of localized pelvic lesions. Materials and Methods A hollow semicylindrical probe (diameter 3.2 cm) with a rectangular upper surface (7.2 cm × 3.2 cm) was designed to house a HIFU transducer and enable acoustic contact with an intraluminal wall. The probe was distally rounded to ease endocavitary insertion and was proximally tapered to a 1.5-cm diameter cylindrical handle through which the irrigation tubes (for transducer cooling) and electrical connections were passed. MR compatibility of piezoceramic and piezocomposite transducers was assessed using gradient-echo (GRE) sequences. The radiofrequency (RF) tuning of identical 6.5 cm × 2.5 cm rectangular receiver coils on the upper surface of the probe was adjusted to compensate for the presence of the conductive components of the HIFU transducers. A T1-weighted (T1-W) sliding window dual-echo GRE sequence monitored phase changes in the focal zone of each transducer. High-intensity (2400 W/cm,2), short duration (<1.5 seconds) exposures produced subtherapeutic temperature rises. Results For T1-W images, signal-to-noise ratio (SNR) improved by 40% as a result of quartering the conductive surface of the piezoceramic transducer. A piezocomposite transducer showed a further 28% improvement. SNRs for an endocavitary coil in the focal plane of the HIFU trans-ducer (4 cm from its face) were three times greater than from a phased body array coil. Local shimming improved uniformity of phase images. Phase changes were detected at subtherapeutic exposures. Conclusion We combined a HIFU transducer with an MR receiver coil in an endocavitary probe. SNRs were improved by quartering the conductive surface of the piezoceramic. Further improvement was achieved with a piezocomposite transducer. A phase change was seen on MR images during both subtherapeutic and therapeutic HIFU exposures. J. Magn. Reson. Imaging 2007. © 2007 Wiley-Liss, Inc. [source] Impairment of cytoskeleton-dependent vesicle and organelle translocation in green algae: combined use of a microfocused infrared laser as microbeam and optical tweezersJOURNAL OF MICROSCOPY, Issue 2 2002A. Holzinger Summary A Nd-YAG laser at 1064 nm is used as optical tweezers to move intracellular objects and a laser microbeam to cause impairment of cytoskeleton tracks and influence intracellular motions in desmidiaceaen green algae. Naturally occurring migrations of large nuclei are inhibited in Micrasterias denticulata and Pleurenterium tumidum when the responsible microtubules are targeted with a laser microbeam generating 180 mW power in the focal plane. Impairment of the microtubule tracks appears to be irreversible, as the nucleus cannot pass the former irradiated area in Pleurenterium or remains abnormally dislocated in Micrasterias. The actin filament-dependent movement of secretory vesicles and smaller particles can be manipulated by the same IR-laser at 90 mW when functioning as optical tweezers. In Closterium lunula particles are displaced from their cytoplasmic tracks for up to 10 µm but return to their tracks immediately after removing the light pressure gained by the optical tweezers. The cytoplasmic tracks consist of actin filament cables running parallel to the longitudinal axis of Closterium cells as depicted by Alexa phalloidin staining and confocal laser scanning microscopy. Dynamics and extensibility of the cytoplasmic strands connecting particles to the tracks are also demonstrated in the area of large vacuoles which are surrounded by actin filament bundles. In Micrasterias trapping of secretory vesicles by the optical tweezers causes irreversible malformations of the cell shape. The vesicle accumulation itself dissipates within 30 s after removing the optical tweezers, also indicating reversibility of the effects induced, in the case of actin filament-mediated processes. [source] Wide area illumination Raman scheme for simple and nondestructive discrimination of seawater cultured pearlsJOURNAL OF RAMAN SPECTROSCOPY, Issue 12 2009Seok Chan Park Abstract Raman spectroscopy, along with discriminant partial least squares (PLS), was successfully used to discriminate among three different groups of cultured pearls (fresh water, Akoya and South seawater). The discrimination between Akoya and South seawater pearls using XRF (X-ray fluorescence), one of the most frequently adopted analytical methods in pearl analysis, has been especially difficult owing to their similar mineral compositions. The selective Raman features helped in effectively discriminating between these two pearl groups. The difference in the intensities of the CaCO3 bands of Akoya and South seawater pearls provided a valuable clue. Along with the selective Raman feature, a reproducible Raman spectral collection achieved using a wide area illumination (WAI) scheme played an important role in the determination of the pearl groups, although the pearls were hard-surfaced, round, solid samples of different sizes and surface shapes. Unwanted spectral variation originating from sensitivity to sample placement relative to the focal plane and from unsuccessful sample representation due to the probing of a localized area, factors that could possibly deteriorate Raman reproducibility, were substantially lessened using the WAI scheme. ATR (attenuated total reflection) IR spectroscopy requiring direct contact with the pearl could be inadequate for discrimination or classification where large numbers of repeating and reproducible measurements are required. Copyright © 2009 John Wiley & Sons, Ltd. [source] Zernike-type phase-contrast hard X-ray microscope with a zone plate at the Photon FactoryJOURNAL OF SYNCHROTRON RADIATION, Issue 3 2002Hiroki Yokosuka A Zernike-type phase-contrast X-ray microscope with a zone plate and a phase plate was constructed at the Photon Factory BL3C2. Parallel monochromatic X-rays of 8.97,keV were incident on a specimen and a direct beam transmitted through the specimen was focused on the back focal plane of the zone plate, where an aluminium phase plate was placed. Tantalum line patterns as fine as 0.3,µm could be imaged. Phase-contrast images of polypropylene wires and polystyrene latex beads were obtained, which showed better contrast than that of their bright field images. [source] Coherent nano-area electron diffractionMICROSCOPY RESEARCH AND TECHNIQUE, Issue 5-6 2004J.M. Zuo We describe the new coherent nano-area electron diffraction (NED) and its application for structure determination of individual nanostructures. The study is motivated by the challenge and the general lack of analytical techniques for characterizing nanometer-sized, heterogeneous phases. We show that by focusing electrons on the focal plane of the pre-objective lens using a 3rd condenser lens and a small condense aperture, it is possible to achieve a nanometer-sized highly parallel illumination or probe. The high angular resolution of diffraction pattern from the parallel illumination allows over-sampling and consequently the solution of phase problem based on the recently developed ab initio phase retrieval technique. From this, a high-contrast and high-resolution image can be reconstructed at resolution beyond the performance limit of the image-forming objective lens. The significance of NED for nanostructure characterization will be exemplified by single-wall carbon nanotubes and small metallic clusters. Imaging from diffraction patterns, or diffractive imaging, will be demonstrated using double-wall carbon nanotubes. Microsc. Res. Tech. 64:347,355, 2004. © 2004 Wiley-Liss, Inc. [source] Progress in the Development of a High Performance Airborne Digital SensorTHE PHOTOGRAMMETRIC RECORD, Issue 96 2000P. Fricker Joint development work by LH Systems and Deutsches Zentrum für Luft- und Raumfahrt (German Aerospace Center) has produced encouraging results using forward, nadir and backward looking linear arrays on the focal plane to provide panchromatic imagery and geometric information, supplemented by further arrays to acquire multispectral imagery suitable for both high precision photogrammetric mapping and image processing for interpretative purposes. The geometric characteristics of line scanner imagery necessitate line-by-line rectification for aircraft tilts and shifts. Satisfactory execution of this process is enhanced by using supplementary data from high performance, on-board GPS and inertial measurement systems. Similarly, high demands are placed on other sub-systems, such as the camera mount, lens, electronics and storage technology. In addition to rectification for aircraft tilts and shifts, rectification for terrain characteristics is also required in order to generate colour and false colour composite images, since the various multispectral arrays are in different places on the focal plane. The special geometry affects triangulation. Thereafter, the imagery can be processed using existing software packages from both photogrammetry and remote sensing. The concept has been demonstrated in several successful test flights and the production model is scheduled for market introduction at the ISPRS Congress in July 2000. The imagery from the new sensor will fulfil many market requirements between the highest resolution film imagery (<0.1 m) and high resolution space imagery (1m to 10 m). The sensor's unique blend of multispectral information with high quality geometric information will give rise to numerous new applications. [source] Estimation of Centres and Radial Intensity Profiles of Spherical Nano-Particles in Digital MicroscopyBIOMETRICAL JOURNAL, Issue 2 2007Mats Kvarnström Abstract Control of the microscopic characteristics of colloidal systems is critical in a wealth of application areas, ranging from food to pharmaceuticals. To assist in estimating these characteristics, we present a method for estimating the positions of spherical nano-particles in digital microscopy images. The radial intensity profiles of particles, which depend on the distances of the particles from the focal plane of the light microscope and have no closed functional form, are modelled using a local quadratic kernel estimate. We also allow for the case where pixel values are censored at an upper limit of 255. Standard errors of centre estimates are obtained using a sandwich estimator which takes into account spatial autocorrelation in the errors. The approach is validated by a simulation study. (© 2007 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim) [source] Detection of pollen grains in multifocal optical microscopy images of air samplesMICROSCOPY RESEARCH AND TECHNIQUE, Issue 6 2009Sander H. Landsmeer Abstract Pollen is a major cause of allergy and monitoring pollen in the air is relevant for diagnostic purposes, development of pollen forecasts, and for biomedical and biological researches. Since counting airborne pollen is a time-consuming task and requires specialized personnel, an automated pollen counting system is desirable. In this article, we present a method for detecting pollen in multifocal optical microscopy images of air samples collected by a Burkard pollen sampler, as a first step in an automated pollen counting procedure. Both color and shape information was used to discriminate pollen grains from other airborne material in the images, such as fungal spores and dirt. A training set of 44 images from successive focal planes (stacks) was used to train the system in recognizing pollen color and for optimization. The performance of the system has been evaluated using a separate set of 17 image stacks containing 65 pollen grains, of which 86% was detected. The obtained precision of 61% can still be increased in the next step of classifying the different pollen in such a counting system. These results show that the detection of pollen is feasible in images from a pollen sampler collecting ambient air. This first step in automated pollen detection may form a reliable basis for an automated pollen counting system. Microsc. Res. Tech., 2009. © 2009 Wiley-Liss, Inc. [source] | |||||||||||||||||||||||||