Home About us Contact | |||
Feeding Technique (feeding + technique)
Selected AbstractsWideband slot antenna using a new feeding technique for wireless applicationsINTERNATIONAL JOURNAL OF RF AND MICROWAVE COMPUTER-AIDED ENGINEERING, Issue 2 2006Mourad Nedil Abstract This article presents a new wideband slot antenna for wireless applications at 5.8 GHz. To improve the antenna bandwidth, a new feeding mechanism based on a capacitively- and inductively-coupled slot is proposed. To demonstrate this approach, an experimental antenna prototype operating at the 5.8-GHz band was designed, fabricated, and measured. The obtained results indicate very good agreement between the numerical and experimental results. The proposed antenna achieves a 28.5% bandwidth, a 5.7-dBi gain, and a ,15-dB front-to-back ratio, which are very sufficient for broadband wireless applications. © 2005 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006. [source] Morphological specializations of baleen whales associated with hydrodynamic performance and ecological nicheJOURNAL OF MORPHOLOGY, Issue 11 2006Becky L. Woodward Abstract Feeding behavior, prey type, and habitat appear to be associated with the morphological design of body, fluke, and flippers in baleen whales. Morphometric data from whaling records and recent stranding events were compiled, and morphometric parameters describing the body length, and fluke and flipper dimensions for an "average" blue whale Balaenoptera musculus, humpback whale Megaptera novaeangliae, gray whale Eschrichtius robustus, and right whale Eubalaena glacialis were determined. Body mass, body volume, body surface area, and fluke and flipper surface areas were estimated. The resultant morphological configurations lent themselves to the following classifications based on hydrodynamic principles: fast cruiser, slow cruiser, fast maneuverer, and slow maneuverer. Blue whales have highly streamlined bodies with small, high aspect ratio flippers and flukes for fast efficient cruising in the open ocean. On the other hand, the rotund right whale has large, high aspect ratio flukes for efficient slow speed cruising that is optimal for their continuous filter feeding technique. Humpbacks have large, high aspect ratio flippers and a large, low aspect ratio tail for quick acceleration and high-speed maneuvering which would help them catch their elusive prey, while gray whales have large, low aspect ratio flippers and flukes for enhanced low-speed maneuvering in complex coastal water habitats. J. Morphol., 2006. © 2006 Wiley-Liss, Inc. [source] A CPW-fed staircase monopole UWB antenna with band-notched frequency in the WLAN bandMICROWAVE AND OPTICAL TECHNOLOGY LETTERS, Issue 10 2007Sang Joong Kim Abstract A coplanar waveguide (CPW)-fed ultra-wideband staircase monopole antenna with a frequency-notch characteristic is presented. The proposed antenna consists of a planar four-step staircase rectangular monopole with a ground short-circuited stub, open stubs at the ground part, and two-step impedance transformer at the CPW-fed line. The impedance bandwidth is increased due to an offset feeding technique and one-side ground notch. The notched frequency band can be accomplished by means of the method that involves adding open stubs at the ground. The measured results are in good agreement with the simulated ones. © 2007 Wiley Periodicals, Inc. Microwave Opt Technol Lett 49: 2545,2547, 2007; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.22775 [source] RFID tag antenna using two-shorted microstrip patches mountable on metallic objectsMICROWAVE AND OPTICAL TECHNOLOGY LETTERS, Issue 2 2007Byunggil Yu Abstract A novel UHF band RFID tag antenna, which can be effectively mounted on metallic objects, is presented. Using the inductively coupled feeding technique, the proposed antenna consists of two symmetric shorted radiating elements and feeding loop. The feeding loop is excited so that the currents on the radiating elements are out of phase with the equal amplitude. The proposed tag antenna gives smaller variation of the antenna performance than that of conventional tag antennas when the tag is mounted on the various sizes of the metallic objects. © 2006 Wiley Periodicals, Inc. Microwave Opt Technol Lett 49: 414,416, 2007; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.22159 [source] |