Home About us Contact
|
Home About us Contact | ||
|
|
||
Electric Signals (electric + signal)
Selected AbstractsIonic polymer-metal composites as multifunctional materialsPOLYMER COMPOSITES, Issue 1 2003Mohsen Shahinpoor This paper presents a description and a set of experimental results on Ionic Polymer-Metal Composites (IPMC's) as dynamic sensors, transducers, and actuators. Strips of IPMC can exhibit large dynamic deformation if placed in a time-varying electric field of the order of 10's of volts/mm. Conversely, dynamic deformation and flexing of such ionic polymers produces dynamic electric fields that closely follow the form of the electric signal. The underlying principle of such a mechanoelectric effect in IPMC's can be explained by the linear irreversible thermodynamics in which ion and solvent transport are the fluxes and electric field and solvent pressure gradient are the forces. Important parameters include the material conductance and the solvent permeability. The dynamic sensing, transduction, and actuation responses of a strip of IPMC under an impact-type loading is also discussed. When a cantilever strip of IPMC is flipped, a damped oscillatory electric response is produced across a pair of electrodes placed at the cantilever of the strip, which is highly repeatable with a broad frequency range above 104 Hz. Such direct mechanoelectric responses of IMPC's are related to the endo-ionic mobility due to stresses imposed. Imposition of a finite solvent flux without allowing a current flux causes the material to create a certain conjugate electric field that can be dynamically monitored and measured. IPMC's are shown to be highly capacitive at low frequencies while they are highly resistive under high frequency excitations. IN a sending mode, IPMC strips can also sense chemical environments and humidity. These types of sensors/transducers/actuators conceivably can replace piezoresistive and piezoelectric sensors with just one sensor for broad ranges of frequencies. [source] Electric-Field Triggered Controlled Release of Bioactive Volatiles from Imine-Based Liquid Crystalline PhasesCHEMISTRY - A EUROPEAN JOURNAL, Issue 1 2009Andreas Herrmann Dr. Abstract Application of an electric field to liquid crystalline film forming imines with negative dielectric anisotropy, such as N -(4-methoxybenzylidene)-4-butylaniline (MBBA, 1), results in the expulsion of compounds that do not participate in the formation of the liquid crystalline phase. Furthermore, amines and aromatic aldehydes undergo component exchange with the imine by generating constitutional dynamic libraries. The strength of the electric field and the duration of its application to the liquid crystalline film influence the release rate of the expelled compounds and, at the same time, modulate the equilibration of the dynamic libraries. The controlled release of volatile organic molecules with different chemical functionalities from the film was quantified by dynamic headspace analysis. In all cases, higher headspace concentrations were detected in the presence of an electric field. These results point to the possibility of using imine-based liquid crystalline films to build devices for the controlled release of a broad variety of bioactive volatiles as a direct response to an external electric signal. [source] Diamond Transistor Array for Extracellular Recording From Electrogenic CellsADVANCED FUNCTIONAL MATERIALS, Issue 18 2009Markus Dankerl Abstract The transduction of electric signals from cells to electronic devices is mandatory for medical applications such as neuroprostheses and fundamental research on communication in neuronal networks. Here, the use of diamond with its advantages for biological applications as a new material for biohybrid devices for the detection of cell signals is investigated. Using the surface conductivity of hydrogen-terminated single-crystalline diamond substrates, arrays of solution-gate field-effect transistors were fabricated. The characterization of the transistors reveals a good stability in electrolyte solutions for at least 7 days. On these devices, cardiomyocyte-like HL-1 cells as well as human embryonic kidney cells (HEK293), which were stably transfected with potassium channels, are cultured. Both types of cells show healthy growth and good adhesion to the substrate. The diamond transistors are used to detect electrical signals from both types of cells by recording the extracellular potential. For the HL-1 cells, the shape of action potentials can be resolved and the propagation of the signal across the cell layer is visible. Potassium currents of HEK293 cells are activated with the patch-clamp technique in voltage-clamp mode and simultaneously measured with the field-effect transistors. The ion sensitivity of the diamond surface enables the detection of released potassium ions accumulated in the cleft between transistor and cell. [source] A transmission line model for metallic carbon nanotube interconnectsINTERNATIONAL JOURNAL OF CIRCUIT THEORY AND APPLICATIONS, Issue 1 2008A. Maffucci Abstract A transmission line (TL) model describing the propagation of electric signals along metallic single wall carbon nanotube (CNT) interconnects is derived in a simple and self-consistent way within the framework of the classical electrodynamics. The conduction electrons of metallic CNTs are modelled as an infinitesimally thin cylindrical layer of a compressible charged fluid with friction, moving in a uniform neutralizing background. The dynamic of the electron fluid is studied by means of the linearized hydrodynamic equations with the pressure assumed to be that of a degenerate spin-½ ideal Fermi gas. Transport effects due to the electron inertia, quantum fluid pressure and electron scattering with the ion lattice significantly influence the propagation features of the TL. The simplicity and robustness of the fluid model make the derivation of the TL equations more straightforward than other derivations recently proposed in the literature and provide simple and clear definitions of the per unit length (p.u.l.) TL parameters. In particular, this approach has provided a new circuit model that can be used effectively in the analysis of networks composed of CNT transmission lines and lumped elements. The differences and similarities between the proposed model and those given in the literature are highlighted. Copyright © 2006 John Wiley & Sons, Ltd. [source] Differentiation of morphology, genetics and electric signals in a region of sympatry between sister species of African electric fish (Mormyridae)JOURNAL OF EVOLUTIONARY BIOLOGY, Issue 4 2008S. LAVOUÉ Abstract Mormyrid fishes produce and sense weak electric organ discharges (EODs) for object detection and communication, and they have been increasingly recognized as useful model organisms for studying signal evolution and speciation. EOD waveform variation can provide important clues to sympatric species boundaries between otherwise similar or morphologically cryptic forms. Endemic to the watersheds of Gabon (Central Africa), Ivindomyrus marchei and Ivindomyrus opdenboschi are morphologically similar to one another. Using morphometric, electrophysiological and molecular characters [cytochrome b sequences and amplified fragment length polymorphism (AFLP) genotypes], we investigated to what extent these nominal mormyrid species have diverged into biological species. Our sampling covered the known distribution of each species with a focus on the Ivindo River, where the two taxa co-occur. An overall pattern of congruence among datasets suggests that I. opdenboschi and I. marchei are mostly distinct. Electric signal analysis showed that EODs of I. opdenboschi tend to have a smaller initial head-positive peak than those of I. marchei, and they often possess a small third waveform peak that is typically absent in EODs of I. marchei. Analysis of sympatric I. opdenboschi and I. marchei populations revealed slight, but significant, genetic partitioning between populations based on AFLP data (FST , 0.04). Taken separately, however, none of the characters we evaluated allowed us to discriminate two completely distinct or monophyletic groups. Lack of robust separation on the basis of any single character set may be a consequence of incomplete lineage sorting due to recent ancestry and/or introgressive hybridization. Incongruence between genetic datasets in one individual, which exhibited a mitochondrial haplotype characteristic of I. marchei but nevertheless fell within a genetic cluster of I. opdenboschi based on AFLP genotypes, suggests that a low level of recent hybridization may also be contributing to patterns of character variation in sympatry. Nevertheless, despite less than perfect separability based on any one dataset and inconclusive evidence for complete reproductive isolation between them in the Ivindo River, we find sufficient evidence to support the existence of two distinctive species, I. opdenboschi and I. marchei, even if not ,biological species' in the Mayrian sense. [source] | ||||||||||