Elastic Component (elastic + component)

Distribution by Scientific Domains


Selected Abstracts


The Role of Strain in New Semiconductor Devices

ADVANCED ENGINEERING MATERIALS, Issue 4 2009
Alex Dommann
HRXRD is a very sensitive and non destructive technique to determine the strain in thin layer materials such as electron guides or the strain induces by the second order package of SOCs. In reciprocal space mapping (RSM), it is possible to separate the elastic component of the scattered intensity from the diffuse one. As a consequence, it is possible to study diffuse scattering due to defects of the crystal lattice. As an example we show also RSM's of a high-speed SiGe pMOS structure. [source]


Modulation of Viscoelasticity and HIV Transport as a Function of pH in a Reversibly Crosslinked Hydrogel

ADVANCED FUNCTIONAL MATERIALS, Issue 18 2009
Julie I. Jay
Abstract Materials that respond to physiological stimuli are important in developing advanced biomaterials for modern therapies. The reversibility of covalent crosslinks formed by phenylboronate (PBA) and salicylhydroxamate (SHA) has been exploited to provide a pH-responsive gel for application to the vaginal tract. Dynamic rheology reveals that the gel frequency-dependent viscoelastic properties are modulated by pH. At pH 4.8 the viscous component dominates throughout most of the frequency range. As the pH increases, the characteristic relaxation time continues to increase while the G,Plateau levels off above pH 6. At pH 7.5, the elastic component dominates throughout the frequency sweep and is predominately independent of frequency. Particle tracking assesses the transport of both fluorescently labeled HIV-1 and 100-nm latex particles in the PBA,SHA crosslinked gel as a function of pH. At pH 4.8 the ensemble-averaged mean squared displacement at lag times greater than three seconds reveals that transport of the HIV-1 and 100-nm particles becomes significantly impeded by the matrix, exhibiting diffusion coefficients less than 0.0002,µm2 s,1. This pH-responsive gel thus displays properties that have the potential to significantly reduce the transport of HIV-1 to susceptible tissues and thus prevent the first stage of male-to-female transmission of HIV-1. [source]


Modeling and compensation for angular transmission error in harmonic drive gearings

IEEJ TRANSACTIONS ON ELECTRICAL AND ELECTRONIC ENGINEERING, Issue 2 2009
Masafumi Yamamoto Student Member
Abstract This paper presents a novel modeling and compensation approach for the angular transmission error in harmonic drive gearings. In the modeling, physical phenomena of the transmission error due to nonlinear elastic deformations in micro-displacement region are especially dealt with, as well as the synchronous component which has been discussed in a variety of conventional studies. On the basis of the analyses of the phenomena, the nonlinear elastic component is mathematically modeled by applying a modeling framework for the rolling friction with hysteresis attributes. The proposed transmission error model has been adopted to the positioning system as a model-based feedforward compensation manner. Experimental results using a prototype show the effectiveness of the proposed modeling and compensation. Copyright © 2009 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc. [source]


Comparison of girth materials, girth tensions and their effects on performance in racehorses

AUSTRALIAN VETERINARY JOURNAL, Issue 1-2 2005
J BOWERS
Objective To compare the effect of girth materials and commonly used girth tensions on athletic performance of racehorses and to test the length tension properties of commercially available girths. Procedure Seven horses were exercised at speeds to produce 95% of maximal heart rates on 15 occasions using a randomised block design, and girthed with 5 different girths at 3 nominal tensions of 6, 12 or 18 kg. The girths used were a standard elastic race girth, an ,American' elastic race girth, an elastic race girth twice the normal width, a standard canvas race girth and a canvas race girth at twice the normal width. Tension in the girth was recorded continuously using an in-line load cell connected to a physiograph. Horses ran to fatigue on a treadmill inclined at 10% slope. Tensions were measured at peak inhalation (T/inh) and exhalation (T/exh), recorded at rest (rest) and during exercise (ex). An analysis of variance was used to compare the mean run to fatigue times (RTFT) between girth types and tensions, multiple pair-wise comparisons were then carried out using Tukey's test where significant differences were found. The length-tension relationships of five commercially available girths for training and racing of Thoroughbred racehorses were studied by the application of standardized weights in series to multiple samples of each type of girth. Measurements were taken in a controlled environment and analysis of variance was used to compare the means for length-tension of each girth type. Results The elastic and the ,American' elastic girths produced significantly longer RTFT when compared to the standard canvas girth (P=0.01 and P = 0.001 respectively). Also girths tensioned at Texhrest 6 kg and Texhrest 12 kg produced significantly longer RTFT than when girthed at Texhrest 18 kg (P=0.03 and P = 0.08 respectively). There were significant differences between the commercially available girth types at each tension (P < 0.05), but differences were not significant between girths of the same type. Girths with an elastic component reached their peak for maximum extension at 14.5 kg and thereafter their extension declined. Conclusion The type of girth and the tension at which it is applied affects athletic performance. Lower girth tensions and the use of elastic materials in the girth would appear to optimise performance. However according to this study and our previous study, none of the commercially available girths studied would adequately protect against the potentially detrimental effects of overtightening on athletic performance. [source]


Preservation of Muscular and Elastic Artery Distensibility After an Intercontinental Cryoconserved Exchange: Theoretical Advances in Arterial Homograft Generation and Utilization

ARTIFICIAL ORGANS, Issue 8 2009
Daniel Bia
Abstract While the situation of tissue donation and transplantation differs between Latin American and European countries, a common problem is tissue deficiency. Hence, at present, there is a pressing need to generate alternatives so as to increase the possibilities of obtaining the requested materials. Consequently, it would be of significant interest to establish an intercontinental network for tissue exchange, to improve international cooperation, and to help patients that need tissue transplantation, and to evaluate the feasibility of using an intercontinental network for the exchange of cryopreserved arteries (cryografts), preserving the arterial distensibility and ensuring a reduced native artery,cryograft biomechanical mismatch. Distensibility was studied in ovine arteries divided into three groups: intact (in vivo tests, conscious animals), fresh control (in vitro tests immediately after the artery excision, Uruguay), and cryografts (in vitro tests of cryopreserved-transported-defrosted arteries, Spain). Histological studies were performed so as to analyze changes in the endothelial layer and elastic components. The comparison between fresh control and cryografts showed that neither the cryopreservation nor the exchange network impaired the distensibility, despite the expected histological changes found in the cryografts. The comparison between intact and cryografts showed that the cryografts would be capable of ensuring a reduced biomechanical mismatch. The cryopreservation and the intercontinental network designed for artery exchange preserved the arterial distensibility. It could be possible to transfer cryografts between Latin America and Europe to be used in cardiovascular surgeries and/or for tissue banking reprocessing, with basic biomechanical properties similar to those of the fresh and/or native arteries. [source]