Home About us Contact
|
Home About us Contact | ||
|
|
||
Dyract AP (dyract + ap)
Selected AbstractsColor stability of resin matrix restorative materials as a function of the method of light activationEUROPEAN JOURNAL OF ORAL SCIENCES, Issue 3 2004Ralf Janda The purpose was to investigate the influence of curing devices and curing times on the yellow value (b-value) of composites, ormocers and compomers after performing a suntest (EN ISO 7491). Eight samples of Charisma (CH), Durafill (DU), Definite (DE), and Dyract AP (DY) each were light cured with Translux Energy (tungsten halogen light) for 20, 40 or 60 s and with Apollo 95-E (plasma light) for 3, 10 or 20 s. All samples were subjected to a suntest. Before and after the suntest the yellow values (b-values) were determined and the change (,b) was calculated. When cured with Translux Energy for 20 and 40 s DU, CH, and DY revealed significantly negative ,b-values. The b-value of DE remained nearly constant. When cured for 60 s, DU and DE shifted to more yellow while CH and DY still bleached a little. When cured with Apollo 95-E, a dramatic bleaching process of all materials investigated occurred after the suntest (significant negative ,b). It may be concluded that the bleaching of composites, ormocers and compomers depends on (i) the used light curing device and (ii) the chosen curing times. The tungsten halogen light provided highly significantly superior results. [source] Influence of storage regime prior to abrasion on surface topography of restorative materialsJOURNAL OF BIOMEDICAL MATERIALS RESEARCH, Issue 2 2003Cecilia Pedroso Turssi Abstract This investigation was carried out to evaluate the effect of storage conditions prior to brushing simulation on surface texture of restorative materials. One resin-modified glass ionomer (Fuji II LC Improved/GC Corp.), one polyacid-modified composite resin (Dyract AP/Denstply), one microfill composite (Durafill VS/Kulzer), and one hybrid (Filtek,Z250/3M) composite were tested. Forty-five standardized cylindrical specimens of each material were made and randomly divided into three groups according to their subsequent storage conditions: distilled deionized water, artificial saliva, or pH-cycling regime. After 24 h, the experimental units were finished and polished and the surface roughness was measured to obtain Ra baseline values (Bv). Samples were subjected to their assigned storage regime and brushed afterwards. By the end of 10 repetitions of this protocol, final surface roughness readings (Fv) were taken. The analysis of covariance (, = 0.05), considering the covariate Bv showed a significant interaction between restorative material and storage condition (pvalue = 0.0002). Tukey's test revealed that the pH-cycling model provided a significantly lower surface roughness for Fuji II LC and Dyract AP than did the other media. For both composites no significant difference among storage regimes was detected. Under a condition simulating dynamic variation in pH prior to abrasion, the resultant surface texture may be either smoothed down or unchanged, depending on the restorative material, when compared to the effect provided by artificial saliva and distilled deionized water. © 2003 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater 65B: 227,232, 2003 [source] The effect of Coca-Cola and fruit juices on the surface hardness of glass,ionomers and ,compomers'JOURNAL OF ORAL REHABILITATION, Issue 11 2004M. Aliping-McKenzie summary, The interaction of tooth-coloured dental restorative materials (a conventional glass,ionomer, two resin-modified glass,ionomers and two compomers) with acidic beverages has been studied with the aim of investigating how long-term contact affects solution pH and specimen surface hardness. For each material (ChemFil Superior, ChemFlex, Vitremer Core Build-Up/Restorative, Fuji II LC, Dyract AP and F2000) disc-shaped specimens were prepared and stored in sets of six in the following storage media: 0·9% NaCl (control), Coca-Cola, apple juice and orange juice. After time intervals of 1 day, 1 week, 1 month, 3 months, 4 months, 6 months and 1 year, solution pH and Vickers Hardness Number were determined for each individual specimen. Differences were analysed by anova followed by Student,Newman,Keuls post hoc analysis. All materials were found to reduce the pH of the 0·9% NaCl, but to increase the pH of the acidic beverages. The conventional glass,ionomers dissolved completely in apple juice and orange juice, but survived in Coca-Cola, albeit with a significantly reduced hardness after 1 year. The other materials survived in apple juice and orange juice, but showed greater reductions in surface hardness in these beverages than in Coca-Cola. Fruit juices were thus shown to pose a greater erosive threat to tooth coloured materials than Coca-Cola, a finding which is similar to those concerning dentine and enamel towards these drinks. [source] Marginal gap formation of composites in dentine: effect of water storageJOURNAL OF ORAL REHABILITATION, Issue 3 2003A. U. J. Yap summary, This study investigated the effects of water storage on the marginal adaptation of two composite resins (Spectrum TPH and Ariston AT), two polyacid-modified composite resins (Dyract AP and F2000) and a new PRG composite (Reactmer) to dentine over time. Two cylindrical dentine cavities (1·5 mm diameter and 1·5 mm deep) were prepared on the horizontally sectioned surfaces of freshly extracted teeth. In each tooth, one cavity was restored using composites with their respective bonding system and the other without the bonding system. The sample size for each material with/without bonding system was 6. The composites were placed in one increment, bulk-polymerized, immediately finished/polished with the Sof-lex discs system and fine polished on 30 ,m silicon carbide/9 ,m aluminium oxide lapping film discs in a microgrinding system. The specimens were then stored in distilled water at 37 °C and the maximum marginal gap width between the material and the dentine wall was determined at 24 h, 1 week, 2 weeks, 3 weeks and 4 weeks using a measurescope at ×500 magnification. Results were subjected to statistical analysis using monva, anova/Scheffe's post hoc test and independent samples of t -test at significance level 0·05. At all time intervals, no significant difference in marginal gap formation was observed between materials. Where bonding systems were not used, a decrease in gap widths over time was observed with most materials but only Dyract AP exhibited a significant decrease. The latter was observed after 2 weeks storage in water. The use of bonding systems reduced dentine marginal gaps significantly and is therefore mandatory for all composites evaluated. Marginal gaps arising from polymerization contraction of conventional, polyacid-modified and PRG composites cannot be fully compensated by hydroscopic expansion. Clinical relevance Bonding systems are mandatory for all composites when bonding to dentin. In the event of a bond failure at placement, hygroscopic expansion of composites can reduce marginal gaps but not completely. [source] Clinical and SEM evaluations of three compomer systems in Class V carious lesionsJOURNAL OF ORAL REHABILITATION, Issue 8 2002A. I. Abdalla Summary The aim of this study was to evaluate the clinical performance of three compomer systems: Compoglass F, Dyract AP and F2000 in Class V carious lesions. In addition, some restorations were placed in teeth scheduled for extractions in order to evaluate the compomer/dentin interface with the scanning electron microscope (SEM). A total of 175 Class V carious lesions having the gingival margins extending into cementum were restored with the tested materials. Each restoration was clinically evaluated immediately after placement, after 1 year and after 2 years using the USPHS criteria. After 1 year no loss of restoration was recorded. No significant difference between the materials was observed for any evaluation category. After 2 years, one Compoglass and two Dyract restorations were lost. No loss of F2000 was reported. No significant difference was reported between the tested materials and between the 2-year data and baseline ones. A well-defined hybrid layer as well as resin tags was seen at the interface between the tested materials and vital dentin. [source] The interactions of tooth colored dental restorative materials with aqueous lactic acidPOLYMERS FOR ADVANCED TECHNOLOGIES, Issue 6 2003Dr Sevil, ahmal Abstract In this study, the interaction of packable composite and ormocer with aqueous lactic acid solutions were determined and changes compared with those for a polyacid modified resin composite and a glass ionomer. For each material, namely Solitaire, Z-100, Definite, Dyract AP and Vitremer, eight cylindrical specimens of 6,mm diameter and 12,mm height were prepared and weighed. They were stored individually in 20,cm3 0.02 mol,1 lactic acid solution for 1 week, then the pH was determined and the specimens reweighed. This was repeated at 1 week intervals until the specimens were 6 weeks old. The results of this study showed that; polyacid modified resin composites and resin-modified glass-ionomers were capable of increasing the pH of lactic acid solutions. The same groups showed an increase in mass during the first week. Composite resins and ormocer showed less increase in mass than the others. Copyright © 2003 John Wiley & Sons, Ltd. [source] | |||||||||||||