			Home About us Contact

Coated Particles (coated + particle)

Distribution by Scientific Domains

Polymers and Materials Science	40%

Selected Abstracts

Sol,Gel Coatings as Active Barriers to Protect Ceramic Reinforcement in Aluminum Matrix Composites,

ADVANCED ENGINEERING MATERIALS, Issue 1-2 2004
J. Rams
Silica obtained through a sol,gel process is used as a coating for ceramic reinforcements (SiC) in aluminium matrix composite materials. The interaction between molten aluminium and the coated particles during material casting can be controlled by means of the thermal treatment given to the coating. Wettability is increased because the coating reacts with molten aluminium, and the formation of the degrading aluminium carbide is inhibited. [source]

Eolian Transport of Geogenic Hexavalent Chromium to Ground Water

GROUND WATER, Issue 1 2010
Warren W. Wood
A conceptual model of eolian transport is proposed to address the widely distributed, high concentrations of hexavalent chromium (Cr+6) observed in ground water in the Emirate of Abu Dhabi, United Arab Emirates. Concentrations (30 to more than 1000 ,g/L Cr+6) extend over thousands of square kilometers of ground water systems. It is hypothesized that the Cr is derived from weathering of chromium-rich pyroxenes and olivines present in ophiolite sequence of the adjacent Oman (Hajar) Mountains. Cr+3 in the minerals is oxidized to Cr+6 by reduction of manganese and is subsequently sorbed on iron and manganese oxide coatings of particles. When the surfaces of these particles are abraded in this arid environment, they release fine, micrometer-sized, coated particles that are easily transported over large distances by wind and subsequently deposited on the surface. During ground water recharge events, the readily soluble Cr+6 is mobilized by rain water and transported by advective flow into the underlying aquifer. Chromium analyses of ground water, rain, dust, and surface (soil) deposits are consistent with this model, as are electron probe analyses of clasts derived from the eroding Oman ophiolite sequence. Ground water recharge flux is proposed to exercise some control over Cr+6 concentration in the aquifer. [source]

Nanoparticle Coating for Advanced Optical, Mechanical and Rheological Properties,

ADVANCED FUNCTIONAL MATERIALS, Issue 16 2007
F. Hakim
Abstract Primary titania nanoparticles were coated with ultrathin alumina films using Atomic Layer Deposition (ALD). The deposited films were highly uniform and conformal with an average growth rate of 0.2,nm per coating cycle. The alumina films eliminated the surface photocatalytic activity of titania nanoparticles, while maintained their original extinction efficiency of ultraviolet light. Deposited films provided a physical barrier that effectively prevented the titania surface from oxidizing organic material whereas conserving its bulk optical properties. Parts fabricated from coated powders by pressureless sintering had a 13,% increase in surface hardness over parts similarly fabricated from uncoated particles. Owing to its homogeneous distribution, the secondary alumina phase suppressed excessive grain growth. Alumina films completely reacted during sintering to form aluminum titanate composites, as verified by XRD. Coated particles showed a pseudoplastic behavior at low shear rates due to modified colloidal forces. This behavior became similar to the Newtonian flow of uncoated nanoparticle slurries as the shear rate increased. Suspensions of coated particles also showed a decreased viscosity relative to the viscosity of uncoated particle suspensions. [source]

Drug release properties of polymer coated ion-exchange resin complexes: Experimental and theoretical evaluation

JOURNAL OF PHARMACEUTICAL SCIENCES, Issue 3 2007
Seong Hoon Jeong
Abstract Although ion-exchange resins have been used widely as drug delivery systems, their exact release kinetics has not been reported yet. Usually only the rate-limiting step has been taken into account and the rest of the steps have been ignored as instantaneous processes. To investigate the exact release kinetics of polymer-coated drug/ion-exchange resin complexes for sustained drug delivery, the results of new mathematical modeling were compared with experimental results. Drug/resin complexes with a model drug, dextromethorphan, were prepared and used as cores for fluid-bed coating. An aqueous colloidal dispersion of poly(vinyl acetate) was applied for the coating. A comprehensive mathematical model was developed using a mechanistic approach by considering diffusion, swelling, and ion-exchange processes solved by numerical techniques. The rate-limiting factor of the uncoated resin particles was diffusion through the core matrix. Similarly, in the coated particles the rate-limiting factor was diffusion through the coating membrane. The mathematical model has captured the phenomena observed during experimental evaluations and the release dynamics from uncoated and coated (at different coat levels) particles were predicted accurately (maximum RMSE 2.4%). The mathematical model is a useful tool to theoretically evaluate the drug release properties from coated ion-exchange complexes thus can be used for design purposes. © 2006 Wiley-Liss, Inc. and the American Pharmacists Association J Pharm Sci [source]

EPR studies on Na-oleate coated Fe3O4 nanoparticles

PHYSICA STATUS SOLIDI (C) - CURRENT TOPICS IN SOLID STATE PHYSICS, Issue 12 2004
Y. Köseo
Abstract Superparamagnetic iron oxide nanoparticles were prepared by the co-precipitation technique. Then, fine iron oxide nanoparticles were coated by Na-oleate. Magnetic properties of Na-oleate coated and uncoated iron oxide nanoparticles were investigated by Electron Paramagnetic Resonance (EPR) technique. At room temperature, a single, strong and broad EPR signal was observed for both samples with effective g-values of 2,0839 and 2,18838 for coated and uncoated samples, respectively. The intensity, line width and the resonance field for both coated and uncoated samples are strongly temperature dependent. When the sample is coated with Na-oleate, the line width and the resonance field values of the EPR signal increase due to the decrease in the magnetic interaction between the particles. The total effective magnetic moment of such coated particles is found to decrease, which is most likely due to a non-collinear spin structure originated from the pinning of the surface spins and coated surfactant at the interface of nanoparticles. [source]