|
| ||
|
|
||
Acetylacetonate Complexes (acetylacetonate + complex)
Selected AbstractsSilica-Supported Zirconium Complexes and their Polyoligosilsesquioxane Analogues in the Transesterification of Acrylates: Part 2.ADVANCED SYNTHESIS & CATALYSIS (PREVIOUSLY: JOURNAL FUER PRAKTISCHE CHEMIE), Issue 13 2009Activity, Recycling, Regeneration Abstract The catalytic activity of both supported and soluble molecular zirconium complexes was studied in the transesterification reaction of ethyl acrylate by butanol. Two series of catalysts were employed: three well defined silica-supported acetylacetonate and n -butoxy zirconium(IV) complexes linked to the surface by one or three siloxane bonds, (SiO)Zr(acac)3 (1) (SiO)3Zr(acac) (2) and (SiO)3Zr(O- n -Bu) (3), and their soluble polyoligosilsesquioxy analogues (c -C5H9)7Si8O12(CH3)2Zr(acac)3 (1,), (c -C5H9)7Si7O12Zr(acac) (2,), and (c -C5H9)7Si7O12Zr(O- n -Bu) (3,). The reactivity of these complexes were compared to relevant molecular catalysts [zirconium tetraacetylacetonate, Zr(acac)4 and zirconium tetra- n -butoxide, Zr(O- n- Bu)4]. Strong activity relationships between the silica-supported complexes and their polyoligosilsesquioxane analogues were established. Acetylacetonate complexes were found to be far superior to alkoxide complexes. The monopodal complexes 1 and 1, were found to be the most active in their respective series. Studies on the recycling of the heterogeneous catalysts showed significant degradation of activity for the acetylacetonate complexes (1 and 2) but not for the less active tripodal alkoxide catalyst, 3. Two factors are thought to contribute to the deactivation of catalyst: the lixivation of zirconium by cleavage of surface siloxide bonds and exchange reactions between acetylacetonate ligands and alcohols in the substrate/product solution. It was shown that the addition of acetylacetone to the low activity catalyst Zr(O- n- Bu)4 produced a system that was as active as Zr(acac)4. The applicability of ligand addition to heterogeneous systems was then studied. The addition of acetylacetone to the low activity solid catalyst 3 produced a highly active catalyst and the addition of a stoichiometric quantity of acetylacetone at each successive batch catalytic run greatly reduced catalyst deactivation for the highly active catalyst 1. [source] Fluorinated ,-Diketones for the Extraction of Lanthanide Ions: Photophysical Properties and Hydration Numbers of Their EuIII ComplexesEUROPEAN JOURNAL OF INORGANIC CHEMISTRY, Issue 2 2006Anne-Sophie Chauvin Abstract Tris(,-diketonato)europium(III) with a series of variably fluorinated ligands derived from 3,5-heptanedione were synthesised with the aim of determining their hydration state under extraction conditions. The number of coordinated water molecules was determined by measuring the lifetime of the Eu(5D0) excited level in water and deuterated water. The hydration gain (,q = q , q0) after shaking chloroform solutions during 10 min with 0.1 M NaClO4 aqueous solutions depends on the fluorination extent of the diketonates: fluorination of one methyl group leads to a decrease in ,q of ca. 0.5 unit, while fluorination of one ethyl group results in a decrease of ca. 1.3 units. Highly fluorinated complexes (i.e with hexafluoroacetylacetonate and related ligands) display a hydration number close to one while poorly fluorinated compounds (or nonfluorinated ones, such as the acetylacetonate complex) have a hydration state close to two. Photophysical properties of the EuIII ,-diketonates are also described and the synthesis of the fluorinated ,-diketones is re-investigated and discussed in details. (© Wiley-VCH Verlag GmbH & Co. KGaA, 69451 Weinheim, Germany, 2006) [source] Silica-Supported Zirconium Complexes and their Polyoligosilsesquioxane Analogues in the Transesterification of Acrylates: Part 2.ADVANCED SYNTHESIS & CATALYSIS (PREVIOUSLY: JOURNAL FUER PRAKTISCHE CHEMIE), Issue 13 2009Activity, Recycling, Regeneration Abstract The catalytic activity of both supported and soluble molecular zirconium complexes was studied in the transesterification reaction of ethyl acrylate by butanol. Two series of catalysts were employed: three well defined silica-supported acetylacetonate and n -butoxy zirconium(IV) complexes linked to the surface by one or three siloxane bonds, (SiO)Zr(acac)3 (1) (SiO)3Zr(acac) (2) and (SiO)3Zr(O- n -Bu) (3), and their soluble polyoligosilsesquioxy analogues (c -C5H9)7Si8O12(CH3)2Zr(acac)3 (1,), (c -C5H9)7Si7O12Zr(acac) (2,), and (c -C5H9)7Si7O12Zr(O- n -Bu) (3,). The reactivity of these complexes were compared to relevant molecular catalysts [zirconium tetraacetylacetonate, Zr(acac)4 and zirconium tetra- n -butoxide, Zr(O- n- Bu)4]. Strong activity relationships between the silica-supported complexes and their polyoligosilsesquioxane analogues were established. Acetylacetonate complexes were found to be far superior to alkoxide complexes. The monopodal complexes 1 and 1, were found to be the most active in their respective series. Studies on the recycling of the heterogeneous catalysts showed significant degradation of activity for the acetylacetonate complexes (1 and 2) but not for the less active tripodal alkoxide catalyst, 3. Two factors are thought to contribute to the deactivation of catalyst: the lixivation of zirconium by cleavage of surface siloxide bonds and exchange reactions between acetylacetonate ligands and alcohols in the substrate/product solution. It was shown that the addition of acetylacetone to the low activity catalyst Zr(O- n- Bu)4 produced a system that was as active as Zr(acac)4. The applicability of ligand addition to heterogeneous systems was then studied. The addition of acetylacetone to the low activity solid catalyst 3 produced a highly active catalyst and the addition of a stoichiometric quantity of acetylacetone at each successive batch catalytic run greatly reduced catalyst deactivation for the highly active catalyst 1. [source] Living Radical Polymerization of Acrylates Mediated by 1,3-Bis(2-pyridylimino)isoindolatocobalt(II) Complexes: Monitoring the Chain Growth at the MetalCHEMISTRY - A EUROPEAN JOURNAL, Issue 33 2008Björn Abstract A new type of mediator for cobalt(II)-mediated radical polymerization is reported which is based on 1,3-bis(2-pyridylimino)isoindolate (bpi) as ancillary ligand. The modular synthesis of the bis(pyridylimino)isoindoles (bpiH) employed in this work is based on the condensation of 2-aminopyridines with phthalodinitriles. Reaction of the bpiH protio-ligands with a twofold excess of cobalt(II) acetate or cobalt(II) acetylacetonate in methanol gave [Co(bpi)(OAc)], which crystallize as coordination polymers, and a series of [Co(acac)(bpi)(MeOH)], which are mononuclear octahedral complexes. Upon heating the [Co(acac)(bpi)(MeOH)] compounds to 100,°C under high vacuum, the coordinated methanol was removed to give the five-coordinate complexes [Co(acac)(bpi)]. The polymerization of methyl acrylate at 60,°C was investigated by using one molar equivalent of the relatively short-lived radical source 2,2,-azobis(4-methoxy-2,4-dimethylvaleronitrile) (V-70) as initiator (monomer/catalyst/V-70: 600:1:1). The low solubility of the acetato complexes inhibits their significant activity as mediators in this reaction, whereas the acetylacetonate complexes control the radical polymerization of methyl acrylate more effectively. The radical polymerizations of the hexacoordinate complexes did not show a linear increase in number-average molecular weight (Mn) with conversion; however, the polydispersities were relatively low (PDI=1.12,1.40). By using the pentacoordinate complexes [Co(acac)(bpi)] as mediators, a linear increase in Mn values with conversion, which were very close to the theoretical values for living systems, and very low polydispersities (PDI<1.13) were obtained. This was also achieved in the block copolymerization of methyl acrylate and n -butyl acrylate. The intermediates with the growing acrylate polymer radical (.PA) were identified by liquid injection field desorption/ionization mass spectrometry as following the general formula [Co(acac)(4-methoxy-bpi)-(MA)n -R] (MA: methyl acrylate; R: C(CH3)(CH2C(CH3)2OCH3)CN), a notion also confirmed by NMR end-group analysis. [source] | ||||||||||