|
| ||
|
|
||
Binding Cleft (binding + cleft)
Selected AbstractsWater Accessibility to the Binding Cleft as a Major Switching Factor from Entropy-Driven to Enthalpy-Driven Binding of an Alkyl Group by Synthetic ReceptorsCHEMISTRY - AN ASIAN JOURNAL, Issue 5 2010Sayaka Matsumoto Abstract Free energy, enthalpy, and entropy changes in the binding of alkyl pyridines to water-soluble zinc porphyrin receptors with varying accessibility of water to the binding cleft were determined to explain why the driving force of hydrophobic effects is enthalpic in some occasions and entropic in others. Zinc porphyrins bearing four alkyl pillars with terminal solubilizing poly(oxyethylene) (POE) chains of molecular weight of 750 (1), with eight alkyl pillars with terminal solubilizing POE chains of molecular weight of 350 (3), and with eight alkyl pillars with POE of molecular weight of 750 (4) had a binding cleft with decreasing water accessibility in this order as revealed by binding selectivity of imidazole/pyridine. Although all these porphyrins showed that the free energy of binding (,,Go) increases linearly as the alkyl group of the guest is lengthened (,,Go per CH2 was 2.6, 2.8, and 2.6,kJ,mol,1 for 1, 3, and 4, respectively), the origin of the free energy gain was much different. Receptor 1 with the most hydrophilic binding site bound the alkyl group by an enthalpic driving force (4-pentylpyridine favored over 4-methylpyridine by ,,Ho=,16.4,kJ,mol,1), while receptor 4 with the most hydrophobic binding site by an entropic driving force (4-pentylpyridine favored over 4-methylpyridine by ,,So=39.6,J,K,1,mol,1). Receptor 3 showed intermediate behavior: both enthalpic and entropic terms drove the binding of the alkyl group with the enthalpic driving force being dominant. The binding site of the four-pillared receptor (1) is open and accessible to water molecules, and is more hydrophilic than that of the eight-pillared receptor (4). We propose that the alkyl chains of 1 are exposed to water to produce a room to accommodate the guest to result in enthalpy-driven hydrophobic binding, whereas 4 can accommodate the guest without such structural changes to lead to entropy-driven hydrophobic binding. Therefore, accessibility of water or exposure of the binding site to the water phase switches the driving force of hydrophobic effects from an entropic force to an enthalpic force. [source] Molecular determinants of ligand specificity in family 11 carbohydrate binding modules , an NMR, X-ray crystallography and computational chemistry approachFEBS JOURNAL, Issue 10 2008Aldino Viegas The direct conversion of plant cell wall polysaccharides into soluble sugars is one of the most important reactions on earth, and is performed by certain microorganisms such as Clostridium thermocellum (Ct). These organisms produce extracellular multi-subunit complexes (i.e. cellulosomes) comprising a consortium of enzymes, which contain noncatalytic carbohydrate-binding modules (CBM) that increase the activity of the catalytic module. In the present study, we describe a combined approach by X-ray crystallography, NMR and computational chemistry that aimed to gain further insight into the binding mode of different carbohydrates (cellobiose, cellotetraose and cellohexaose) to the binding pocket of the family 11 CBM. The crystal structure of C. thermocellum CBM11 has been resolved to 1.98 Ĺ in the apo form. Since the structure with a bound substrate could not be obtained, computational studies with cellobiose, cellotetraose and cellohexaose were carried out to determine the molecular recognition of glucose polymers by CtCBM11. These studies revealed a specificity area at the CtCBM11 binding cleft, which is lined with several aspartate residues. In addition, a cluster of aromatic residues was found to be important for guiding and packing of the polysaccharide. The binding cleft of CtCBM11 interacts more strongly with the central glucose units of cellotetraose and cellohexaose, mainly through interactions with the sugar units at positions 2 and 6. This model of binding is supported by saturation transfer difference NMR experiments and linebroadening NMR studies. [source] Enzymatic and structural analysis of the I47A mutation contributing to the reduced susceptibility to HIV protease inhibitor lopinavirPROTEIN SCIENCE, Issue 9 2008Klára Grantz, ková Abstract Lopinavir (LPV) is a second-generation HIV protease inhibitor (PI) designed to overcome resistance development in patients undergoing long-term antiviral therapy. The mutation of isoleucine at position 47 of the HIV protease (PR) to alanine is associated with a high level of resistance to LPV. In this study, we show that recombinant PR containing a single I47A substitution has the inhibition constant (Ki) value for lopinavir by two orders of magnitude higher than for the wild-type PR. The addition of the I47A substitution to the background of a multiply mutated PR species from an AIDS patient showed a three-order-of-magnitude increase in Ki in vitro relative to the patient PR without the I47A mutation. The crystal structure of I47A PR in complex with LPV showed the loss of van der Waals interactions in the S2/S2, subsites. This is caused by the loss of three side-chain methyl groups due to the I47A substitution and by structural changes in the A47 main chain that lead to structural changes in the flap antiparallel ,-strand. Furthermore, we analyzed possible interaction of the I47A mutation with secondary mutations V32I and I54V. We show that both mutations in combination with I47A synergistically increase the relative resistance to LPV in vitro. The crystal structure of the I47A/I54V PR double mutant in complex with LPV shows that the I54V mutation leads to a compaction of the flap, and molecular modeling suggests that the introduction of the I54V mutation indirectly affects the strain of the bound inhibitor in the PR binding cleft. [source] Structure of buffalo lactoferrin at 3.3,Ĺ resolution at 277,KACTA CRYSTALLOGRAPHICA SECTION D, Issue 6 2000S. Karthikeyan The three-dimensional structure of diferric buffalo lactoferrin has been determined at 3.3,Ĺ resolution. The structure was solved by molecular replacement using the coordinates of diferric human lactoferrin as a search model and was refined by simulated annealing (X-PLOR). The final model comprises 5316 protein atoms for all 689 residues, two Fe3+ and two CO ions. The final R factor was 21.8% for 11,711 reflections in the resolution range 17.0,3.3,Ĺ. The folding of buffalo lactoferrin is essentially similar to that of the other members of the transferrin family. The significant differences are found in the dimensions of the binding cleft and the interlobe orientation. The interlobe interactions are predominantly hydrophobic in nature, thus facilitating the sliding of two lobes owing to external forces. The interdomain interactions are comparable in the N and C lobes. [source] Structure of the first PDZ domain of human PSD-93ACTA CRYSTALLOGRAPHICA SECTION F (ELECTRONIC), Issue 12 2009Monica Fiorentini The crystal structure of the PDZ1 domain of human PSD-93 has been determined to 2.0,Ĺ resolution. The PDZ1 domain forms a crystallographic trimer that is also predicted to be stable in solution. The main contributions to the stabilization of the trimer seem to arise from interactions involving the PDZ1,PDZ2 linker region at the extreme C-terminus of PDZ1, implying that the oligomerization that is observed is not of biological significance in full-length PSD-93. Comparison of the structures of the binding cleft of PSD-93 PDZ1 with the previously reported structures of PSD-93 PDZ2 and PDZ3 as well as of the closely related human PSD-95 PDZ1 shows that they are very similar in terms of amino-acid composition. However, the cleft is significantly narrower in PSD-95. This could be part of the basis of peptide selectivity between PSD-93 PDZ1 and PSD-95 PDZ1. [source] Flexibility of the MHC class II peptide binding cleft in the bound, partially filled, and empty states: A molecular dynamics simulation studyBIOPOLYMERS, Issue 1 2009Rakina Yaneva Abstract Major histocompatibility (MHC) Class II cell surface proteins present antigenic peptides to the immune system. Class II structures in complex with peptides but not in the absence of peptide are known. Comparative molecular dynamics (MD) simulations of a Class II protein (HLA-DR3) with and without CLIP (invariant chain-associated protein) peptide were performed starting from the CLIP-bound crystal structure. Depending on the protonation of acidic residues in the P6 peptide-binding pocket the simulations stayed overall close to the start structure. The simulations without CLIP showed larger conformational fluctuations especially of ,-helices flanking the binding cleft. Largest fluctuations without CLIP were observed in a helical segment near the peptide C-terminus binding region matching a segment recognized by antibodies specific for empty Class II proteins. Simulations on a Val86Tyr mutation that fills the peptide N-terminus binding P1 pocket or of a complex with a CLIP fragment (dipeptide) bound to P1 showed an unexpected long range effect. In both simulations the mobility not only of P1 but also of the entire binding cleft was reduced compared to simulations without CLIP. It correlates with the experimental finding that the CLIP fragment binding to P1 is sufficient to prevent antibody recognition specific for the empty form at a site distant from P1. The results suggest a mechanism how a local binding event of small peptides or of an exchange factor near P1 may promote peptide binding and exchange through a long range stabilization of the whole binding cleft in a receptive (near bound) conformation. © 2008 Wiley Periodicals, Inc. Biopolymers 91: 14,27, 2009. This article was originally published online as an accepted preprint. The "Published Online" date corresponds to the preprint version. You can request a copy of the preprint by emailing the Biopolymers editorial office at biopolymers@wiley.com [source] Structural and Biophysical Characterization of XIAP BIR3 G306E Mutant: Insights in Protein Dynamics and Application for Fragment-Based Drug DesignCHEMICAL BIOLOGY & DRUG DESIGN, Issue 3 2009Cathy D. Moore Previous reports describe modulators of X-linked inhibitor of apoptosis (XIAP),caspase interaction designed from the AVPI N-terminal peptide sequence of second mitochondria-derived activator of caspase. A fragment-based drug design strategy was initiated to identify therapeutic non-peptidomimetic antagonists of X-linked inhibitor of apoptosis protein,protein interactions. Fragments that bind to the AVPI binding site of BIR3 (bacculoviral inhibitory repeat) were identified, and to further localize the fragment binding within the AVPI binding site, a point mutation was designed which alters the dynamics of flexible loops and blocks PI region of the binding cleft, thus enabling definition of weakly bound small molecules in the AV portion of the binding cleft. Nuclear magnetic resonance analysis confirmed the G306E mutation stabilizes the AV pocket. Biophysical characterization of the mutant confirms conformation change within the PI sub-pocket as evidenced by a significant diminishment in binding affinity of AVPI mimetics, yet the binding affinity of the smaller AV mimetics is maintained or slightly improved in the mutant compared with wild-type. Additional data from non-covalent mass spectrometry analysis shows enhanced binding of AV mimetics to the G306E mutant over the wild-type. The presented data outline a protein engineering strategy that allowed mapping of AV-replacements with better sensitivity and precision. [source] Bisamides Derived from Azulene-1,3- and -5,7-dicarboxylic Acids as New Building Blocks for Anion ReceptorsCHEMISTRY - A EUROPEAN JOURNAL, Issue 3 2008Tomasz Zieli, ski Dr. Abstract Bisamides based on the azulene moiety were investigated as building blocks for anion receptors. In the course of these studies, derivatives of azulene-1,3- and -5,7-dicarboxylic acid were synthesized and thoroughly characterized. The anion affinities of the derivatives based on functionalization in the five-membered ring and in the seven-membered ring were determined by 1H,NMR titration. The structural analysis of these building blocks was performed by X-ray diffractometry, molecular modelling and 2D NMR spectroscopy. The five-membered ring derivatives are easy to obtain, offer a binding site preorganized in the syn,syn conformation and bind anions with a strength similar to those of pyrrole-based analogues. There is also strong evidence for aromatic CH,,,anion interactions. The ligands substituted at the 5- and 7-positions offer a binding cleft with an uncommon geometry that originates from the seven-membered ring and seems to be complementary to the chloride anion. [source] Water Accessibility to the Binding Cleft as a Major Switching Factor from Entropy-Driven to Enthalpy-Driven Binding of an Alkyl Group by Synthetic ReceptorsCHEMISTRY - AN ASIAN JOURNAL, Issue 5 2010Sayaka Matsumoto Abstract Free energy, enthalpy, and entropy changes in the binding of alkyl pyridines to water-soluble zinc porphyrin receptors with varying accessibility of water to the binding cleft were determined to explain why the driving force of hydrophobic effects is enthalpic in some occasions and entropic in others. Zinc porphyrins bearing four alkyl pillars with terminal solubilizing poly(oxyethylene) (POE) chains of molecular weight of 750 (1), with eight alkyl pillars with terminal solubilizing POE chains of molecular weight of 350 (3), and with eight alkyl pillars with POE of molecular weight of 750 (4) had a binding cleft with decreasing water accessibility in this order as revealed by binding selectivity of imidazole/pyridine. Although all these porphyrins showed that the free energy of binding (,,Go) increases linearly as the alkyl group of the guest is lengthened (,,Go per CH2 was 2.6, 2.8, and 2.6,kJ,mol,1 for 1, 3, and 4, respectively), the origin of the free energy gain was much different. Receptor 1 with the most hydrophilic binding site bound the alkyl group by an enthalpic driving force (4-pentylpyridine favored over 4-methylpyridine by ,,Ho=,16.4,kJ,mol,1), while receptor 4 with the most hydrophobic binding site by an entropic driving force (4-pentylpyridine favored over 4-methylpyridine by ,,So=39.6,J,K,1,mol,1). Receptor 3 showed intermediate behavior: both enthalpic and entropic terms drove the binding of the alkyl group with the enthalpic driving force being dominant. The binding site of the four-pillared receptor (1) is open and accessible to water molecules, and is more hydrophilic than that of the eight-pillared receptor (4). We propose that the alkyl chains of 1 are exposed to water to produce a room to accommodate the guest to result in enthalpy-driven hydrophobic binding, whereas 4 can accommodate the guest without such structural changes to lead to entropy-driven hydrophobic binding. Therefore, accessibility of water or exposure of the binding site to the water phase switches the driving force of hydrophobic effects from an entropic force to an enthalpic force. [source] | |||||||||||||||||||||||||