Home About us Contact
|
Home About us Contact | ||
|
|
||
Various Pollutants (various + pollutant)
Selected AbstractsSimultaneous determination of low-molecular-weight organic acids and chlorinated acid herbicides in environmental water by a portable CE system with contactless conductivity detectionELECTROPHORESIS, Issue 10 2007Yan Xu Abstract This report describes a method to simultaneously determine 11 low-molecular-weight (LMW) organic acids and 16 chlorinated acid herbicides within a single run by a portable CE system with contactless conductivity detection (CCD) in a poly(vinyl alcohol) (PVA)-coated capillary. Under the optimized condition, the LODs of CE-CCD ranged from 0.056 to 0.270,ppm, which were better than for indirect UV (IUV) detection of the 11 LMW organic acids or UV detection of the 16 chlorinated acid herbicides. Combined with an on-line field-amplified sample stacking (FASS) procedure, sensitivity enhancement of 632- to 1078-fold was achieved, with satisfactory reproducibility (RSDs of migration times less than 2.2%, and RSDs of peak areas less than 5.1%). The FASS-CE-CCD method was successfully applied to determine the two groups of acidic pollutants in two kinds of environmental water samples. The portable CE-CCD system shows advantages such as simplicity, cost effectiveness, and miniaturization. Therefore, the method presented in this report has great potential for onsite analysis of various pollutants at the trace level. [source] Genetic indicators of herbicide stress in the pacific oyster Crassostrea gigas under experimental conditionsENVIRONMENTAL TOXICOLOGY & CHEMISTRY, Issue 3 2000Dario Moraga Abstract This study examined use of the oyster Crassostrea gigas as a bioindicator of experimental pollution caused by two concentrations of five pesticides (atrazine, isoproturon, alachlore, metolachlore, and diuron) used in agricultural and urban activities. The effect of these pesticides on the genetic structure of the marine bivalve was studied as part of an environmental biomonitoring project. This research was performed on two natural estuarine populations sampled along the French Atlantic coast as part of an ongoing monitoring program to survey the ecosystem of Brittany using two approaches: identifying the genetic markers based on the alleles and genotypes associated with pollution effects, and searching for a correlation between these markers and the sensitivity or tolerance of individuals under stress conditions. Results indicate a differential survival of individuals subjected to the various pollutants examined. The sensitivity of alleles and genotypes to environmental stress can be assessed based on the significant differences in allele and genotype frequencies observed between resistant and sensitive individuals when subjected to the pesticides. This genetic study included examination of five enzyme systems (Ak, Pgi, Cap, Pgm, and Mdh) involved in physiologic processes. A total of six alleles and five genotypes at three loci (Ak, Pgi, and Pgm) were identified as being markers of resistance or sensitivity. It is hypothesized that these markers could be used as potential genetic markers in estuarine ecosystem monitoring. [source] Effect of xylanase on ozone bleaching kinetics and properties of Eucalyptus kraft pulpJOURNAL OF CHEMICAL TECHNOLOGY & BIOTECHNOLOGY, Issue 10 2003M Blanca Roncero Abstract Environmental pressure has led the pulp and paper industry to develop new technologies in order to reduce or suppress the presence of various pollutants in effluents from bleaching plants. One of the choices for this purpose is enzyme-based biotechnology. This study deals with the effect of using a xylanase-based enzymatic pretreatment, in a TCF (Totally Chlorine Free) sequence, on the properties of the resulting paper pulps. The hexenuronic acid content in the pulp and the physical properties of the paper were also studied. The performance of the xylanase was analysed through kinetic studies on ozone bleaching. The enzymatic pretreatment results in easier bleaching and delignification of the pulp, causing a bleach-boosting effect. The decreased consumption of reagent is related to a decreased content of hexenuronic groups. The physical properties of the treated pulp are similar to those of untreated pulps. Cellulose degradation, delignification and chromophores' removal show first-order kinetics. Enzyme pretreatment leads to differences between the kinetic constants of cellulose degradation and chromophores' removal, due to an increased accessibility to bleaching agents. The xylanase treatment leads to a lower floor kappa number (IK,) during the ozone stage. Copyright © 2003 Society of Chemical Industry [source] Analysis of 51 persistent organic pollutants in soil by means of ultrasonic solvent extraction and stir bar sorptive extraction GC-MSJOURNAL OF SEPARATION SCIENCE, JSS, Issue 20 2008Marta Martínez-Parreño Abstract A novel method based on ultrasonic solvent extraction and stir bar sorptive extraction (SBSE) for the analysis of 51 persistent organic pollutants including organochlorine pesticides (OCPs), polychlorinated biphenyls (PCBs), polycyclic aromatic hydrocarbons (PAHs), and polybrominated diphenylethers (PBDEs) in soil samples was developed. The different parameters that affect both the extraction of analytes from the soil samples, such as solvent selection, solvent volume, mass of soil, and extraction time, and the partitioning from the solvent/water mixture to the PDMS were studied. The final selected conditions consisted of the extraction of 1 g of soil with 15 mL methanol by sonication for 30 min. The methanol extract was mixed with 85 mL of Milli-Q water and extracted by means of SBSE for 14 h at 900 rpm. The stir bars were analyzed by thermal desorption-GC-mass spectometry (TD-GC-MS). The effects of the matrix on the recovery of the various pollutants under the developed method were studied using two soils with very different physicochemical properties. Method sensitivity, linearity, repeatability, and reproducibility were also studied. Validation and accuracy of the method were conducted by analyzing two commercial certified reference materials (CRMs). The main advantage of this method resides in the fact that a small amount of a nontoxic solvent (methanol) is needed for the extraction of only 1 g of solid sample allowing LODs ranging from 0.01 to 2.0 ,g/kg. Repeatability and reproducibility variations were lower than 20% for all investigated compounds. Results of the CRMs verify the high accuracy of this method. [source] | |||||||||||||