Home About us Contact
|
Home About us Contact | ||
|
|
||
Various Organic Compounds (various + organic_compound)
Selected AbstractsApplication of supercritical fluid extraction to regenerate spent Pd-active carbon catalystENVIRONMENTAL PROGRESS & SUSTAINABLE ENERGY, Issue 4 2007Lidia D Abstract Pd-active carbon-type catalysts are used in a wide variety of processes, typical examples of which are liquid-phase hydrogenation reactions. In the case of these catalysts, a loss of their catalytic activity is observed. The aim of the present work was to assess the possibility of regenerating spent Pd/AC catalysts using supercritical fluid extraction. The following Pd/AC catalyst samples were investigated and compared: a commercial 10 wt % Pd catalyst (Aldrich) (denoted by CC), a spent catalyst (SC), SC subjected to supercritical fluid,CO2 extraction (SC/SFE/C), SC subjected to supercritical fluid,CO2,ethanol extraction (SC/SFE/C-Et), and SC subjected to supercritical fluid,ethane,propane extraction (SC/SFE/E-P). The last three catalysts were additionally subjected to heating in a hydrogen atmosphere at 410 K for 3 h. These were denoted by SC/SFE/C/H, SC/SFE/C-Et/H, and SC/SFE/E-P/H, respectively. The spent Pd/AC catalyst (SC) consists of mixed CC samples used in the reduction with hydrogen of various organic compounds. The catalysts CC, SC/SFE/C, SC/SFE/C/H, SC/SFE/C-Et/H, and SC/SFE/E-P/H were tested in the reduction of octanoylbenzene with hydrogen. The activity of the catalysts was estimated by measuring the reaction time and also the amount of hydrogen used in relation to the theoretical quantity required for the reaction. XPS and XRD methods were used to evaluate the changes occurring in the form of the palladium present on the Pd/AC catalyst surface during the regeneration processes. It was found that supercritical fluid-CO2 extraction followed by heating in a hydrogen atmosphere is the most effective method for regenerating that catalyst. The results of our investigations indicate that regeneration of a spent Pd/AC catalyst, irrespective of the reaction in which it has been used, should be based on the complete removal of byproducts, the purification of the catalyst surface, and the restoration of the original form of the palladium. The procedure proposed in this paper, i.e. SFE (CO2) and heating in H2, fulfils both the conditions mentioned above. © 2007 American Institute of Chemical Engineers Environ Prog, 2007 [source] Kinetic simulation studies on the transient formation of the oxo-iron(IV) porphyrin radical cation during the reaction of iron(III) tetrakis-5,10,15,20-(N-methyl-4-pyridyl)-porphyrin with hydrogen peroxide in aqueous solutionLUMINESCENCE: THE JOURNAL OF BIOLOGICAL AND CHEMICAL LUMINESCENCE, Issue 5 2003Tapan Kumar Saha Abstract High-valent oxo-iron(IV) species are commonly proposed as the key intermediates in the catalytic mechanisms of iron enzymes. Water-soluble iron(III) tetrakis-5,10,15,20-(N-methyl-4-pyridyl)porphyrin (Fe(III)TMPyP) has been used as a model of heme-enzyme to catalyse the hydrogen peroxide (H2O2) oxidation of various organic compounds. However, the mechanism of the reaction of Fe(III)TMPyP with H2O2 has not been fully established. In this study, we have explored the kinetic simulation of the reaction of Fe(III)TMPyP with H2O2 and of the catalytic reactivity of FeTMPyP in the luminescent peroxidation of luminol. According to the mechanism that has been established in this work, Fe(III)TMPyP is oxidized by H2O2 to produce (TMPyP)·+Fe(IV)=O (k1 = 4.5 × 104/mol/L/s) as a precursor of TMPyPFe(IV)=O. The intermediate, (TMPyP)·+Fe(IV)=O, represented nearly 2% of Fe(III)TMPyP but it does not accumulate in suf,cient concentration to be detected because its decay rate is too fast. Kinetic simulations showed that the proposed scheme is capable of reproducing the observed time courses of FeTMPyP in various oxidation states and the decay pro,les of the luminol chemiluminescence. It also shows that (TMPyP)·+Fe(IV)=O is 100 times more reactive than TMPyPFe(IV)=O in most of the reactions. These two species are responsible for the initial sharp and the sustained luminol emissions, respectively. Copyright © 2003 John Wiley & Sons, Ltd. [source] Guest-Dependent Flexible Coordination Networks with Fluorinated LigandsCHEMISTRY - A EUROPEAN JOURNAL, Issue 11 2007Kayoko Kasai Dr. Abstract Guest-dependent flexible coordination networks are formed from 1,4-bis(4-pyridylmethyl)tetrafluorobenzene (bpf), 4,4,-bis(4-pyridylmethyl)octafluorobiphenyl (bpfb), 2,6-bis(4-pyridylmethyl)hexafluoronaphthalene (2,6-bpfn), and 2,7-bis(4-pyridylmethyl)hexafluoronaphthalene (2,7-bpfn) with Cd(NO3)2 in the presence of various organic compounds. The reaction of bpf affords one-dimensional cyclic chains, two-dimensional rhombus grid sheets, and three-dimensional diamond frameworks with threefold interpenetration. The reaction of bpfb mainly affords two-dimensional rhombus grid sheets with twofold parallel interpenetration. The reaction of 2,6-bpfn affords a one-dimensional ladder and two-dimensional rhombus grid, twisted grid, and herringbone sheets. The reaction of 2,7-bpfn affords two-dimensional rhombus grid sheets and grid sheets with dumbbell-shaped cavities. This diversity of network topologies is induced by interactions between the guest molecules and the flexible ligand frameworks. [source] Studies on Chromatographic Properties of Perhydroxycucurbit[6]uril as a New Type of Gas Chromatographic Column Packing MaterialCHINESE JOURNAL OF CHEMISTRY, Issue 2 2008Lai-Sheng LI Abstract Perhydroxycucurbit[6]uril {(HO)12CB[6]} has been used successfully as a stationary phase for packed column gas chromatography for the first time. Perhydroxycucurbit[6]uril stationary phase (PSP) exhibited wide operational temperature, outstanding thermostability and good selectivities to various organic compounds, such as alkanes, aromatic hydrocarbons, alcohols, esters, ketones, amines, etc. It was also found that some positional isomers, such as disubstituted benzenes could be well separated on this column. PSP has excel1ent separation abilities to some complicate samples, for example, commercial toilet water. Some mechanism of the new packing for GC-separation was preliminarily discussed. It was observed that the partial inclusion complexation of PSP with analytes could improve separation selectivity and column efficiency, instead of complete inclusion. Moreover, PSP exhibited low baseline shift even at dramatically programmed temperature for complicate samples covering a wide boiling point range so as to fast assay. [source] | ||||||||||