Home About us Contact
|
Home About us Contact | ||
|
|
||
Variety Of Scenarios (variety + of_scenario)
Selected AbstractsA Framework for Facilitating Sourcing and Allocation Decisions for Make-to-Order ItemsDECISION SCIENCES, Issue 4 2004Nagesh N. Murthy ABSTRACT This paper provides a fundamental building block to facilitate sourcing and allocation decisions for make-to-order items. We specifically address the buyer's vendor selection problem for make-to-order items where the goal is to minimize sourcing and purchasing costs in the presence of fixed costs, shared capacity constraints, and volume-based discounts for bundles of items. The potential suppliers for make-to-order items provide quotes in the form of single sealed bids or participate in a dynamic auction involving open bids. A solution to our problem can be used to determine winning bids amongst the single sealed bids or winners at each stage of a dynamic auction. Due to the computational complexity of this problem, we develop a heuristic procedure based on Lagrangian relaxation technique to solve the problem. The computational results show that the procedure is effective under a variety of scenarios. The average gap across 2,250 problem instances is 4.65%. [source] An investigation into time domain Doppler modelling using the TLM numerical methodINTERNATIONAL JOURNAL OF NUMERICAL MODELLING: ELECTRONIC NETWORKS, DEVICES AND FIELDS, Issue 5 2007I. J. G. Scott Abstract The effects observed by a moving source and stationary receiver, or conversely stationary source and moving receiver are well known to physicists. The Doppler effect as it is commonly known is recognized as a perceived change in frequency of the incident signal upon the receiver, caused by the motion of either the source or receiver with respect to the stationary component, occurring in both electromagnetic (transverse) and acoustic (longitudinal) waves. This paper will primarily focus on the acoustic Doppler effect in the time domain, simulating a variety of scenarios using transmission line matrix (TLM) modelling in which the effect can be observed, proceeding to compare the accuracy of the various models generated. A new technique to allow arbitrary placement of boundaries of a TLM mesh will also be introduced and analysed allowing accurate placement of the moving walls within the simulation. Copyright © 2007 John Wiley & Sons, Ltd. [source] Is Defibrillation Testing Still Necessary?JOURNAL OF CARDIOVASCULAR ELECTROPHYSIOLOGY, Issue 4 2008A Decision Analysis, Markov Model Objective: To assess the impact of defibrillation threshold (DFT) testing of implanted cardioverter-defibrillators (ICDs) on survival. Background: DFT testing is generally performed during implantation of ICDs to assess sensing and termination of ventricular fibrillation. It is common clinical practice to defibrillate ventricular fibrillation twice at an output at least 10 J below the maximum output of the device, providing a 10 J safety margin. However, there are few data regarding impact of DFT testing on outcomes. Methods: Decision analysis and Monte Carlo simulation were used to assess expected outcomes of DFT testing. Survival of a hypothetical cohort of patients was assessed according to two strategies,routine DFT testing at time of ICD implant versus no DFT testing. Assumptions in the model were varied over a range of reasonable values to assess outcomes under a variety of scenarios. Results: Five-year survival with DFT and no-DFT strategies were similar at 59.72% and 59.36%, respectively. The results were not sensitive to changing risk estimates for arrhythmia incidence and safety margin. Results of the Monte Carlo simulation were qualitatively similar to the base case scenario and consistent with a small and nonsignificant survival advantage with routine DFT testing. Conclusions: The impact of DFT testing on 5-year survival in ICD patients, if it exists, is small. Survival appears higher with DFT testing as long as annual risk of lethal arrhythmia or the risk of a narrow safety margin is at least 5%, although the incremental benefit is marginal and 95% confidence intervals cross zero. A prospective randomized study of DFT testing in modern devices is warranted. [source] Communication and documentation of preliminary and final radiology reportsJOURNAL OF HEALTHCARE RISK MANAGEMENT, Issue 1 2010Edward Monico MD, FACEP The "wet-read" consultation has been defined as a rapid response to a clinical question posed by a physician to a radiologist. These preliminary interpretations are often not well documented, have poor fidelity, and are subject to modifications and revisions. Moreover, preliminary interpretations may be subject to reinterpretation through a variety of scenarios. Recent technological advances in radiology have further hindered the ability to harmonize differences between preliminary and final interpretations and communicate these differences to treating physicians. High-fidelity simulation may represent a risk management strategy aimed at bridging the gap between radiology and communication technology. [source] Optimal empty vehicle redistribution for hub-and-spoke transportation systemsNAVAL RESEARCH LOGISTICS: AN INTERNATIONAL JOURNAL, Issue 2 2008Dong-Ping Song Abstract This article considers the empty vehicle redistribution problem in a hub-and-spoke transportation system, with random demands and stochastic transportation times. An event-driven model is formulated, which yields the implicit optimal control policy. Based on the analytical results for two-depot systems, a dynamic decomposition procedure is presented which produces a near-optimal policy with linear computational complexity in terms of the number of spokes. The resulting policy has the same asymptotic behavior as that of the optimal policy. It is found that the threshold-type control policy is not usually optimal in such systems. The results are illustrated through small-scale numerical examples. Through simulation the robustness of the dynamic decomposition policy is tested using a variety of scenarios: more spokes, more vehicles, different combinations of distribution types for the empty vehicle travel times and loaded vehicle arrivals. This shows that the dynamic decomposition policy is significantly better than a heuristics policy in all scenarios and appears to be robust to the assumptions of the distribution types. © 2008 Wiley Periodicals, Inc. Naval Research Logistics, 2008 [source] GM crop technology and trade restraints: economic implications for Australia and New Zealand,AUSTRALIAN JOURNAL OF AGRICULTURAL & RESOURCE ECONOMICS, Issue 3 2005Kym Anderson How much might the potential economic benefit from enhanced farm productivity associated with crop biotechnology adoption by Australia and New Zealand (ANZ) be offset by a loss of market access abroad for crops that may contain genetically modified (GM) organisms? This paper uses the Global Trade Analysis Project (GTAP) model to estimate effects of other countries' GM policies without and with ANZ farmers adopting GM varieties of various grains and oilseeds. The gross economic benefits to ANZ from adopting GM crops under a variety of scenarios could be positive even if the strict controls on imports from GM-adopting countries by the European Union are maintained, but not if North-East Asia also applied such trade restaints. From those gross economic effects would need to be subtracted society's evaluation of any new food safety concerns and negative environmental externalities (net of any new environmental and occupational health benefits), as well as any extra costs of segregation, identity preservation and consumer search. [source] | |||||||||||||