Home About us Contact
|
Home About us Contact | ||
|
|
||
Units Used (unit + used)
Selected AbstractsOptimum matching parameters of an MPPT unit used for a PVG-powered water pumping system for maximum power transferINTERNATIONAL JOURNAL OF ENERGY RESEARCH, Issue 6 2006Mehmet Akbaba Abstract Photovoltaic generator (PVG)-powered water pumping has the potential to bring potable water to millions of people in developing countries. However, due to the high initial cost of PVG units, sophisticated load matching is required between the water pumping system and PVG, in order to be able to extract maximum available power from an available PVG unit at all solar radiation levels. This requires an intermediate circuitry between the PVG unit and the motor driving the water pump, which is usually termed as maximum power point trackers (MPPT). This present paper therefore investigates the optimum matching parameters of a power conditioning circuit, which is composed of a double step-up dc,dc converter (DSUC). This MPTT circuit is used for interfacing a permanent magnet (PM) motor-driven water pumping system to a PVG for extracting maximum available power from PVG, hence maximizing the energy utilization efficiency and price,performance ratio of the whole system. It is shown that two key parameters of the DSUC, which are the duty cycle and chopping frequency, are dominating the performance of the whole system, and they are interrelated and load dependent. Therefore, optimum values of these parameters need to be determined. An example system is provided in which a complete modelling is presented in time domain and through numerical experiments it is demonstrated how the optimum values of these two key matching parameters can be determined for a given system. The MPPT circuit used in this investigation is suitable for optimum matching of all types of loads to PVG units, provided that an optimum frequency,duty cycle pair is determined for the choppers in DSUC for every 5% bands of solar radiation between 20 and 100%. Copyright © 2005 John Wiley & Sons, Ltd. [source] Factors influencing fish catch levels on Kenya's coral reefsFISHERIES MANAGEMENT & ECOLOGY, Issue 4 2007S. C. Mangi Abstract, The factors influencing fish catches on Kenya's coral reefs were studied. Catch data were collected at the species level by counting the number of fish landed at each landing site of each fishing ground. Live coral cover, topographic complexity, fish and sea urchin density, and the number of fishers and gear units used in each fishing ground were compared with catch data. Fishing grounds included one location where only basket traps were allowed, six locations where all gear types were used except beach seines, and three locations where all types of gear, including beach seines, were used. Catch and effort variables were similar across the fishing grounds whereas live coral cover and sea urchin density differed (P < 0.01). The sites fished by all types of gear including beach seines had the lowest coral cover (8.4 ± 0.9%) and topographic complexity (1.12 ± 0.01). Catch levels were positively correlated with the number of fishers and fish density but not with the number of gear units deployed or sea urchin density. The number of fishers and live coral cover were the strongest factors determining total catch levels. The results suggest that high levels of fishing effort coupled with the use of destructive gear types, exacerbate the effects of overfishing on Kenya's reefs. [source] Analysis of a Distribution of Point Events Using the Network-Based Quadrat MethodGEOGRAPHICAL ANALYSIS, Issue 4 2008Shino Shiode This study proposes a new quadrat method that can be applied to the study of point distributions in a network space. While the conventional planar quadrat method remains one of the most fundamental spatial analytical methods on a two-dimensional plane, its quadrats are usually identified by regular, square grids. However, assuming that they are observed along a network, points in a single quadrat are not necessarily close to each other in terms of their network distance. Using planar quadrats in such cases may distort the representation of the distribution pattern of points on a network. The network-based units used in this article, on the other hand, consist of subsets of the actual network, providing more accurate aggregation of the data points along the network. The performance of the network-based quadrat method is compared with that of the conventional quadrat method through a case study on a point distribution on a network. The ,2 statistic and Moran's I statistic of the two quadrat types indicate that (1) the conventional planar quadrat method tends to overestimate the overall degree of dispersion and (2) the network-based quadrat method derives a more accurate estimate on the local similarity. The article also performs sensitivity analysis on network and planar quadrats across different scales and with different spatial arrangements, in which the abovementioned statistical tendencies are also confirmed. [source] Effective thermal conductivity behavior of filled vulcanized perfluoromethyl vinyl ether rubberJOURNAL OF APPLIED POLYMER SCIENCE, Issue 5 2008Li Wang Abstract The effective thermal conductivity behavior of vulcanized perfluoromethyl vinyl ether (PMVE) rubber filled with various inorganic fillers was investigated and analyzed with thermal conductivity models. Experimental results showed that there was no significant improvement in the thermal conductivity of PMVE rubber if the intrinsic thermal conductivity of the fillers was greater than 100 times that of the rubber matrix, and this agreed with the prediction of Maxwell's equation. The thermal conductivity of PMVE rubber filled with larger size silicon carbide (SiC) particles was greater than that of PMVE filled with smaller size SiC because of the lower interfacial thermal resistance, and there existed a transition filler loading at about 60 vol %. It was also found that flocculent graphite was the most effective thermally conductive filler among the fillers studied. A modified form of Agari's equation with a parameter independent on the units used was proposed. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008 [source] Comments on the IPC Surface Mount Attachment Reliability GuidelinesQUALITY AND RELIABILITY ENGINEERING INTERNATIONAL, Issue 4 2005Olli Salmela Abstract The Institute for Interconnecting and Packaging Electronic Circuits (IPC) has published guidelines and standards related to surface mount solder attachments. The latest standard IPC-9701 was published in 2002. In this paper, the general methodology for creating the aforementioned documents and the related qualification requirements are reviewed and discussed. Also, corrections to the standards and guidelines are proposed. The corrections are related both to the use of formulas and to inaccuracies in the units used. Copyright © 2005 John Wiley & Sons, Ltd. [source] Survey of neonatal respiratory support strategiesACTA PAEDIATRICA, Issue 8 2007Atul Sharma Abstract Aim: To survey current practice regarding neonatal respiratory support strategies to determine whether it reflected evidence from randomised trials. Methods: A questionnaire (in Supplementary Material online) survey of all U.K. neonatal units was undertaken to determine what modes of ventilation, types of endotracheal tube, lung function monitoring and oxygen saturation levels were used. Results: There was an 80% response rate. Most (73%) units used in prematurely born infants (in the first 24 h) the intermittent positive pressure ventilation, and other respiratory modes included: CPAP (2%), triggered ventilation with or without volume guarantee (22%) and high frequency oscillation (2%). Only 15% of units used assist control mode for weaning; the preferred weaning mode was synchronous intermittent mandatory ventilation (73%). Few units used shouldered endotracheal tubes (3%) or lung function measurements (25%) to aid choice of ventilator settings. Oxygen saturation levels from 80% to 98% were used, levels greater or equal to 95% were used by 11% of units for infants with acute respiratory disease but by 34% of units for BPD infants (p < 0.001). Conclusion: Many practitioners do not base their choice of neonatal respiratory support strategies on the results of large randomised trials; more effective methods are required to ensure evidence-based practice. [source] | ||||||||||