Home About us Contact
|
Home About us Contact | ||
|
|
||
Thermal Dissipation (thermal + dissipation)
Selected AbstractsFatigue crack initiation detection by an infrared thermography methodFATIGUE & FRACTURE OF ENGINEERING MATERIALS AND STRUCTURES, Issue 1 2010D. WAGNER ABSTRACT In this paper, the study of the temperature variation during fatigue tests was carried out on different materials (steels and aluminium alloys). Tests were performed at ambient temperature using a piezoelectric fatigue system (20 kHz). The temperature field was measured on the surface of the specimen, by means of an infrared camera. Just at the beginning of the test, it was observed that the temperature increased, followed by a stabilization which corresponds to the balance between dissipated energy associated with microplasticity and the energy lost by convection and radiation at the specimen surface and by conduction inside the specimen. At the crack initiation, the surface temperature suddenly increases (whatever the localization of the initiation), which allows the determination of the number of cycles at the crack initiation and the number of cycles devoted to the fatigue crack propagation. In the gigacycle fatigue domain, more than 92% of the total life is devoted to the initiation of the crack. So, the study of the thermal dissipation during the test appears a promising method to improve the understanding of the damage and failure mechanism in fatigue and to determine the number of cycles at initiation. [source] Can the Earth's dynamo run on heat alone?GEOPHYSICAL JOURNAL INTERNATIONAL, Issue 2 2003David Gubbins SUMMARY The power required to drive the geodynamo places significant constraints on the heat passing across the core,mantle boundary and the Earth's thermal history. Calculations to date have been limited by inaccuracies in the properties of liquid iron mixtures at core pressures and temperatures. Here we re-examine the problem of core energetics in the light of new first-principles calculations for the properties of liquid iron. There is disagreement on the fate of gravitational energy released by contraction on cooling. We show that only a small fraction of this energy, that associated with heating resulting from changes in pressure, is available to drive convection and the dynamo. This leaves two very simple equations in the cooling rate and radioactive heating, one yielding the heat flux out of the core and the other the entropy gain of electrical and thermal dissipation, the two main dissipative processes. This paper is restricted to thermal convection in a pure iron core; compositional convection in a liquid iron mixture is considered in a companion paper. We show that heat sources alone are unlikely to be adequate to power the geodynamo because they require a rapid secular cooling rate, which implies a very young inner core, or a combination of cooling and substantial radioactive heating, which requires a very large heat flux across the core,mantle boundary. A simple calculation with no inner core shows even higher heat fluxes are required in the absence of latent heat before the inner core formed. [source] Thermal performance of aluminium-foam CPU heat exchangersINTERNATIONAL JOURNAL OF ENERGY RESEARCH, Issue 11 2006H. Mahdi Abstract This study investigates the performance of existing central processing unit (CPU) heat exchangers and compares it with aluminium-foam heat exchangers in natural convection using an industrial set-up. Kapton flexible heaters are used to replicate the heat produced by a computer's CPU. A number of thermocouples are connected between the heater and the heat sink being used to measure the component's temperature. The thermocouples are also connected to a data-acquisition card to collect the data using LabVIEW program. The values obtained for traditional heat exchangers are compared to published data to validate experiments and set-up. The validated set-up was then utilized to test the aluminium-foam heat exchangers and compare its performance to that of common heat sinks. It is found that thermal resistance is reduced more than 70% by employing aluminium-foam CPU heat exchangers. The results demonstrate that this material provides an advantage on thermal dissipation under natural convection over most available technologies, as it considerably increases the surface-area-to-volume ratio. Furthermore, the aluminium-foam heat exchangers reduce the overall weight. Copyright © 2005 John wiley & Sons, Ltd. [source] PHOTOSYNTHETIC PERFORMANCE, LIGHT ABSORPTION, AND PIGMENT COMPOSITION OF MACROCYSTIS PYRIFERA (LAMINARIALES, PHAEOPHYCEAE) BLADES FROM DIFFERENT DEPTHS,JOURNAL OF PHYCOLOGY, Issue 6 2006Marķa Florencia Colombo-Pallotta Macrocystis pyrifera (L.) C. Agardh is a canopy-forming species that occupies the entire water column. The photosynthetic tissue of this alga is exposed to a broad range of environmental factors, particularly related to light quantity and quality. In the present work, photosynthetic performance, light absorption, pigment composition, and thermal dissipation were measured in blades collected from different depths to characterize the photoacclimation and photoprotection responses of M. pyrifera according to the position of its photosynthetic tissue in the water column. The most important response of M. pyrifera was the enhancement of photoprotection in surface and near-surface blades. The size of the xanthophyll cycle pigment pool (XC) was correlated to the nonphotochemical quenching (NPQ) of chl a fluorescence capacity of the blades. In surface blades, we detected the highest accumulation of UV-absorbing compounds, photoprotective carotenoids, ,XC, and NPQ. These characteristics were important responses that allowed surface blades to present the highest maximum photosynthetic rate and the highest PSII electron transport rate. Therefore, surface blades made the highest contribution to algae production. In contrast, basal blades presented the opposite trend. These blades do not to contribute significantly to photosynthetate production of the whole organism, but they might be important for other functions, like nutrient uptake. [source] Energy Dissipation and Photoinhibition in Douglas-Fir Needles with a Fungal-Mediated Reduction in Photosynthetic RatesJOURNAL OF PHYTOPATHOLOGY, Issue 11-12 2002Daniel K. Manter Abstract The dissipation of absorbed light and potential for photooxidative damage was explored in Douglas-fir (Pseudotsuga menziesii ) seedlings with and without Phaeocryptopus gaeumannii infection. The presence of P. gaeumannii significantly reduced net CO2 assimilation rates from ca. 6 ,mol/m2/s to 1.5 ,mol/m2/s, without any significant impact on chloroplast pigments. The partitioning of absorbed light-energy to photochemistry or thermal dissipation was determined from chlorophyll fluorescence measurements. Maximum thermal dissipation for both control and infected needles was ca. 80%, consistent with the similar xanthophyll pool sizes in the two treatments. At high photosynthetic photon flux density (PPFD), when thermal dissipation was maximized, the lower photochemical utilization in infected needles resulted in greater amounts of excess absorbed light (ca. 20 and 10% for the infected and control needles, respectively). A second experiment, monitoring changes in photosystem II (PSII) efficiency (Fv/Fm) in response to a 1 h high light treatment (PPFD=2000 ,mol/m2/s) also suggests that infected needles absorb greater amounts of excess light. In this experiment, declines in Fv/Fm were 1.5 times greater in infected needles, despite the similar xanthophyll pool sizes. Furthermore, increases in minimum fluorescence (178 and 122% of initial values for the infected and control needles, respectively) suggest that the reduction in PSII efficiency is largely attributable to photooxidative damage. Finally, reductions in PSII efficiency under high light conditions provide a plausible explanation for the greater pathogenicity (e.g. premature needle abscission) of P. gaeumannii in sun-exposed foliage. [source] Laser plasma EUV sources for Lithography , Diode pump technology offers new applicationsLASER TECHNIK JOURNAL, Issue 2 2005Martin Richardson The study of high-temperature plasmas produced by pulsed laser systems has for a long time been associated with esoteric applications such as laser fusion, x-ray lasers, space propulsion and the like. There are several reasons for this, but one practical reason was simply that the lasers required to produce these plasmas were large, unwieldy and generally singleshot devices (at least minutes between shots). This technology did not lend itself towards applications that were compact, reproducible and potentially automated. However, this is now no longer the case. High-power diode pump technology has transformed the architecture of solid state lasers, reducing by many factors the required thermal dissipation, and therefore allowing higher repetition rates. Coupled with more compact designs and reduced costs, commercial applications of high-power pulsed lasers, and even laserproduced plasmas are now emerging. Chief among the applications of laser plasmas is now its potential as a light source for what is now called Extreme UV Lithography, or EUVL. [source] Asymptotic behaviour for a non-monotone fluid in one dimension: the positive temperature caseMATHEMATICAL METHODS IN THE APPLIED SCIENCES, Issue 8 2001B. Ducomet We consider a one-dimensional continuous model of neutron star, described by a compressible Navier,Stokes system with a non-monotone equation of state, due to the effective Skyrme nuclear interaction between particles. We study the asymptotic behaviour of globally defined solutions of a mixed free boundary problem for our model, for large time, assuming that a sufficient thermal dissipation is present. Copyright © 2001 John Wiley & Sons, Ltd. [source] Mutations of genes in synthesis of the carotenoid precursors of ABA lead to pre-harvest sprouting and photo-oxidation in riceTHE PLANT JOURNAL, Issue 2 2008Jun Fang Summary Pre-harvest sprouting (PHS) or vivipary in cereals is an important agronomic trait that results in significant economic loss. A considerable number of mutations that cause PHS have been identified in several species. However, relatively few viviparous mutants in rice (Oryza sativa L.) have been reported. To explore the mechanism of PHS in rice, we carried out an extensive genetic screening and identified 12 PHS mutants (phs). Based on their phenotypes, these phs mutants were classified into three groups. Here we characterize in detail one of these groups, which contains mutations in genes encoding major enzymes of the carotenoid biosynthesis pathway, including phytoene desaturase (OsPDS), ,-carotene desaturase (OsZDS), carotenoid isomerase (OsCRTISO) and lycopene , -cyclase (,-OsLCY), which are essential for the biosynthesis of carotenoid precursors of ABA. As expected, the amount of ABA was reduced in all four phs mutants compared with that in the wild type. Chlorophyll fluorescence analysis revealed the occurrence of photoinhibition in the photosystem and decreased capacity for eliminating excess energy by thermal dissipation. The greatly increased activities of reactive oxygen species (ROS) scavenging enzymes, and reduced photosystem (PS) II core proteins CP43, CP47 and D1 in leaves of the Oscrtiso/phs3-1mutant and OsLCY RNAi transgenic rice indicated that photo-oxidative damage occurred in PS II, consistent with the accumulation of ROS in these plants. These results suggest that the impairment of carotenoid biosynthesis causes photo-oxidation and ABA-deficiency phenotypes, of which the latter is a major factor controlling the PHS trait in rice. [source] Cytochrome b6f mutation specifically affects thermal dissipation of absorbed light energy in ArabidopsisTHE PLANT JOURNAL, Issue 3 2001Yuri Munekage Summary Light-induced lumenal acidification controls the efficiency of light harvesting by inducing thermal dissipation of excess absorbed light energy in photosystem II. We isolated an Arabidopsis mutant, pgr1 (proton gradient regulation), entirely lacking thermal dissipation, which was observed as little non-photochemical quenching of chlorophyll fluorescence. Map-based cloning showed that pgr1 had a point mutation in petC encoding the Rieske subunit of the cytochrome b6f complex. Although the electron transport rate was not affected at low light intensity, it was significantly restricted at high light intensity in pgr1, indicating that the lumenal acidification was not sufficient to induce thermal dissipation. This view was supported by (i) slow de-epoxidation of violaXanthin, which is closely related to lumenal acidification, and (ii) reduced 9-aminoacridine fluorescence quenching. Although lumenal acidification was insufficient to induce thermal dissipation, growth rate was not affected under low light growth conditions in pgr1. These results suggest that thermal dissipation is precisely regulated by lumenal pH to maintain maximum photosynthetic activity. We showed that pgr1 was sensitive to changes in light conditions, demonstrating that maximum activity of the cytochrome b6f complex is indispensable for short-term acclimation. [source] | ||||||||||