			Home About us Contact

Soluble Material (soluble + material)

Distribution by Scientific Domains

Life Sciences	50%
Chemistry	50%

Selected Abstracts

Identification of proNeuropeptide FFA peptides processed in neuronal and non-neuronal cells and in nervous tissue

FEBS JOURNAL, Issue 20 2003
Elisabeth Bonnard
Peptides which should be generated from the neuropeptide FF (NPFF) precursor were identified in a neuronal (human neuroblastoma SH-SY5Y) cell line and in COS-7 cells after transient transfection of the human proNPFFA cDNA and were compared with those detected in the mouse spinal cord. After reverse-phase high performance liquid chromatography of soluble material, NPFF-related peptides were immunodetected with antisera raised against NPFF and identified by using on-line capillary liquid chromatography/nanospray ion trap tandem mass spectrometry. Neuronal and non-neuronal cells generated different peptides from the same precursor. In addition to NPFF, SQA-NPFF (Ser-Gln-Ala-Phe-Leu-Phe-Gln-Pro-Gln-Arg-Phe-amide) and NPAF were identified in the human neuroblastoma while only NPFF was clearly identified in COS-7 cells. In mouse, in addition to previously detected NPFF and NPSF, SPA-NPFF (Ser-Pro-Ala-Phe-Leu-Phe-Gln-Pro-Gln-Arg-Phe-amide), the homologous peptide of SQA-NPFF, were characterized. These data on intracellular processing of proNeuropeptide FFA are discussed in regard to the known enzymatic processing mechanisms. [source]

Effects of sand and process water pH on toluene diluted heavy oil in water emulsions in turbulent flow

AICHE JOURNAL, Issue 1 2009
Chandra W. Angle
Abstract The presence of sand in heavy oil production is known to enhance oil recovery. Sand can also be detrimental depending on the properties of the sand,water interface. In this process, the water soluble material interacts with both sand and oil droplets and affects emulsion stability. The formation and stability of heavy oil-in-water emulsions during turbulent flow using batch process stirred-tank mixing of oil, sand, and water were investigated at three pH. Size distributions were measured by laser diffraction. High-speed video photomicrography was used to observe the process during mixing. Results showed that the presence of sand enhanced formation of stable, fine emulsion at basic pH 8.5. When the pH of the water was reduced below 6.5 both sand and droplets surface properties changed, the emulsions became less stable and coalescence was apparent. The sand grains acted as coalescers at low pH and enhanced breakage at high pH. © Her Majesty the Queen in Right of Canada, as represented by the Minister of Natural Resources, 2008 AIChE J, 2009 [source]

Optimization of Reaction Conditions for Enzymatic Viscosity Reduction and Hydrolysis of Wheat Arabinoxylan in an Industrial Ethanol Fermentation Residue

BIOTECHNOLOGY PROGRESS, Issue 2 2006
Hanne R. Sørensen
This study examined enzyme-catalyzed viscosity reduction and evaluated the effects of substrate dry matter concentration on enzymatic degradation of arabinoxylan in a fermentation residue, "vinasse", resulting from industrial ethanol manufacture on wheat. Enzymatic catalysis was accomplished with a 50:50 mixture of an enzyme preparation from Humicola insolens, Ultraflo L, and a cellulolytic enzyme preparation from Trichoderma reesei, Celluclast 1.5 L. This enzyme mixture was previously shown to exhibit a synergistic action on arabinoxylan degradation. The viscosity of vinasse decreased with increased enzyme dosage and treatment time at pH 5, 50 °C, 5 wt % vinasse dry matter. After 24 h of enzymatic treatment, 76,84%, 75,80%, and 43,47%, respectively, of the theoretically maximal arabinose, xylose, and glucose releases were achieved, indicating that the viscosity decrease was a result of enzyme-catalyzed hydrolysis of arabinoxylan, ,-glucan, and cellulose. In designed response surface experiments, the optimal enzyme reaction conditions with respect to pH and temperature of the vinasse, the vinasse supernatant (mainly soluble material), and the vinasse sediment (mainly insoluble substances) varied from pH 5.2,6.4 and 41,49 °C for arabinose release and from pH 4.9,5.3 and 42,46 °C for xylose release. Even though only limited hydrolysis of the arabinoxylan in the vinasse sediment fraction was obtained, the results indicated that the same enzyme activities acted on the arabinoxylan in the different vinasse fractions irrespective of the state of solubility of the substrate material. The levels of liberated arabinose and xylose increased with increased dry matter concentration during enzymatic hydrolysis in the vinasse and the vinasse supernatant, but at the same time, increased substrate dry matter concentrations gave corresponding linear decreases in the hydrolytic efficiency as evaluated from levels of monosaccharide release per weight unit dry matter. The study thus documents that enzymatic arabinoxylan hydrolysis of the vinasse significantly decreases the vinasse viscosity and that a compromise in the dry matter must be found if enzymatic efficiency must be balanced with monosaccharide yields. [source]

Acinetobacter bioreporter assessing heavy metals toxicity

JOURNAL OF BASIC MICROBIOLOGY, Issue 5 2006
Desouky Abd-El-Haleem Dr.
This work was conducted to employ a whole cell-based biosensor to monitor toxicity of heavy metals in water and wastewater. An isolate of industrial wastewater bacterium, Acinetobacter sp. DF4, was genetically modified with lux reporter gene to create a novel bioluminescent bacterial strain, designated as DF4/PUTK2. This bioreporter can investigate the toxicity through light inhibition due to cell death or metabolic burden and the specific stress effects of the tested soluble materials simultaneously. The use of Acinetobacter DF4/PUTK2 as a bioluminescent reporter for heavy metal toxicity testing and for the application of wastewater treatment influent toxicity screening is presented in this study. Among eight heavy metals tested, the bioluminescence of DF4/PUTK2 was most sensitive to Zn, Cd, Fe, Co, Cr followed by Cu in order of decreasing sensitivity. The same pattern of sensitivity was observed when several contaminated water and wastewater effluents were assayed. This work suggested that luxCDABE -marked Acinetobacter bacterium DF4/PUTK2 can be used to bioassay the ecotoxicity of wastewater and effluent samples contaminated with heavy metals. Using this assay, it is possible to pre-select the more toxic samples for further chemical analysis and to discard wastewater samples with low or no inhibition because they are not toxic to the environment. (© 2006 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim) [source]