Home About us Contact
|
Home About us Contact | ||
|
|
||
Satisfactory Quality (satisfactory + quality)
Selected AbstractsEffect of previous chilled storage on rancidity development in frozen horse mackerel (Trachurus trachurus)JOURNAL OF THE SCIENCE OF FOOD AND AGRICULTURE, Issue 15 2002Santiago P Aubourg Abstract Rancidity development during frozen storage (,20,°C) of an underutilised medium-fat-content fish species, horse mackerel (Trachurus trachurus), was studied. Special attention was given to the effect of previous chilled storage (0, 1, 3 and 5 days) on the quality of the frozen fish. For this, chemical (free fatty acid and conjugated diene contents; peroxide value, PV; thiobarbituric acid index, TBA-i; fluorescent compound formation) and sensory (rancid odour and taste) analyses were carried out. Hydrolytic rancidity showed an increase with frozen storage time; however, no effect of previous chilling time was observed on the frozen product. Oxidative rancidity measured by chemical (PV, TBA-i and fluorescence) and sensory (odour and taste) indices increased with frozen storage time and also with previous chilling time. Satisfactory quality was maintained up to 7 months of frozen storage of horse mackerel provided that a short chilling time (not longer than 3 days) was employed. © 2002 Society of Chemical Industry [source] Physical-chemical characteristics and oxidative stability of oil obtained from lyophilized raspberry seedEUROPEAN JOURNAL OF LIPID SCIENCE AND TECHNOLOGY, Issue 11 2009Aleksandra, urovi Abstract Fresh raspberry (Rubus idaeus), cultivar Willamette, was freeze-dried (lyophilization). A byproduct of lyophilization is "fine dust" of raspberry consisting of finely ground raspberry fruit body and seed. The seeds were separated. The seed oil was isolated and its physical and chemical characteristics were determined. Parameters that characterize the seed and quality of the oil were examined, including fatty acid composition, oxidative stability under different storage conditions, and radical-scavenging activity. The fatty acid composition was determined by GC/FID and the contents of the dominant fatty acids were found as: oleic 16.92%, linoleic 54.95%, and ,-linolenic acid 23.97%. The oxidative stability of the oil was poor. The induction period by Rancimat test at 100,°C was 5.2,h. The radical-scavenging activity is similar to that of resveratrol [1,3-benzenediol 5-(1E -2-4-hydroxy-phenyl-ethyl)]. Although this product is used in the candy industry, it would be far more useful if raspberry oil of satisfactory quality could be extracted. This paper demonstrates that sifted lyophilized seeds can be used for the extraction of oils. This process allows for maximal usage of the byproducts, reduces losses and it increases the development of new products. [source] Experimental modelling and intelligent control of a wood-drying kilnINTERNATIONAL JOURNAL OF ADAPTIVE CONTROL AND SIGNAL PROCESSING, Issue 8 2001Givon Chuen Kee Yan Abstract Proper control of the wood-drying kiln is crucial in ensuring satisfactory quality of dried wood and in minimizing drying time. This paper presents the development, implementation, and evaluation of a control system for a lumber drying kiln process incorporating sensory feedback from in-wood moisture content sensors and intelligent control such that the moisture content of lumber will reach and stabilize at the desired set point without operator interference. The drying process is difficult to model and control due to complex dynamic nonlinearities, coupling effects among key variables, and process disturbances caused by the variation of lumber sizes, species, and environmental factors. Through system identification scheme using experimental data and recursive least-squares algorithm for parameter estimation, appropriate models are developed for simulation purpose and controller design. Two different control methodologies are employed and compared: a conventional proportional-integral-derivative (PID) controller and a direct fuzzy logic controller (FLC), and system performance is evaluated through simulations. The developed control system is then implemented in a downscaled industrial kiln located at the Innovation Centre of National Research Council (NRC) of Canada. This experimental set-up is equipped with a variety of sensors, including thermocouples for temperature feedback, an air velocity transmitter for measuring airflow speed in the plenum, relative humidity sensors for measuring the relative humidity inside the kiln, and in-wood moisture content sensors for measuring the moisture content of the wood pieces. For comparison, extensive experimental studies are carried out on-line using the two controllers, and the results are evaluated to tune the controller parameters to achieve good performance in the wood-drying kiln. The combination of conventional control with the intelligent control promises improved performance. The control system developed in this study may be applied in industrial wood-drying kilns, with a clear potential for improved quality and increased speed of drying. Copyright © 2001 John Wiley & Sons, Ltd. [source] Computational modeling of tetrahydroimidazo-[4,5,1-jk][1,4]-benzodiazepinone derivatives: An atomistic drug design approach using Kier-Hall electrotopological state (E-state) indicesJOURNAL OF COMPUTATIONAL CHEMISTRY, Issue 11 2008Nitin S. Sapre Abstract Quantitative structure-activity relationships (QSAR), based on E-state indices have been developed for a series of tetrahydroimidazo-[4,5,1-jk]-benzodiazepinone derivatives against HIV-1 reverse transcriptase (HIV-1 RT). Statistical modeling using multiple linear regression technique in predicting the anti-HIV activity yielded a good correlation for the training set (R2 = 0.913, R = 0.897, Q2 = 0.849, MSE = 0.190, F -ratio = 59.97, PRESS = 18.05, SSE = 0.926, and p value = 0.00). Leave-one-out cross-validation also reaffirmed the predictions (R2 = 0.850, R = 0.824, Q2 = 0.849, MSE = 0.328, and PRESS = 18.05). The predictive ability of the training set was also cross-validated by a test set (R2 = 0.812, R = 0.799, Q2 = 0.765, MSE = 0.347, F -ratio = 64.69, PRESS = 7.37, SSE = 0.975, and p value = 0.00), which ascertained a satisfactory quality of fit. The results reflect the substitution pattern and suggest that the presence of a bulky and electropositive group in the five-member ring and electron withdrawing groups in the seven-member ring will have a positive impact on the antiviral activity of the derivatives. Bulky groups in the six-member ring do not show an activity-enhancing impact. Outlier analysis too reconfirms our findings. The E-state descriptors indicate their importance in quantifying the electronic characteristics of a molecule and thus can be used in chemical interpretation of electronic and steric factors affecting the biological activity of compounds. © 2008 Wiley Periodicals, Inc. J Comput Chem, 2008 [source] Current role of liver transplantation for the treatment of urea cycle disorders: A review of the worldwide English literature and 13 cases at Kyoto UniversityLIVER TRANSPLANTATION, Issue 11 2005Daisuke Morioka To address the current role of liver transplantation (LT) for urea cycle disorders (UCDs), we reviewed the worldwide English literature on the outcomes of LT for UCD as well as 13 of our own cases of living donor liver transplantation (LDLT) for UCD. The total number of cases was 51, including our 13 cases. The overall cumulative patient survival rate is presumed to be more than 90% at 5 years. Most of the surviving patients under consideration are currently doing well with satisfactory quality of life. One advantage of LDLT over deceased donor liver transplantation (DDLT) is the opportunity to schedule surgery, which beneficially affects neurological consequences. Auxiliary partial orthotopic liver transplantation (APOLT) is no longer considered significant for the establishment of gene therapies or hepatocyte transplantation but plays a significant role in improving living liver donor safety; this is achieved by reducing the extent of the hepatectomy, which avoids right liver donation. Employing heterozygous carriers of the UCDs as donors in LDLT was generally acceptable. However, male hemizygotes with ornithine transcarbamylase deficiency (OTCD) must be excluded from donor candidacy because of the potential risk of sudden-onset fatal hyperammonemia. Given this possibility as well as the necessity of identifying heterozygotes for other disorders, enzymatic and/or genetic assays of the liver tissues in cases of UCDs are essential to elucidate the impact of using heterozygous carrier donors on the risk or safety of LDLT donor-recipient pairs. In conclusion, LT should be considered to be the definitive treatment for UCDs at this stage, although some issues remain unresolved. (Liver Transpl 2005;11:1332,1342.) [source] Valve Surgery in Congenital Heart DiseaseARTIFICIAL ORGANS, Issue 11 2009Giovanni Battista Luciani Abstract Congenital valve disease (CVD) occurs in isolated form or as part of complex malformations and presents distinct epidemiology, including: young age at onset; high prevalence of associated pathology; history of prior operations; critical clinical presentation. Therefore, multiple interventions are often needed, highlighting the palliative character of CVD surgery. At the same time, long-term survival and satisfactory quality of life expectations must be satisfied in a young, active patient population. The present study analyzes the unique aspects of surgery for CVD by reviewing clinical experience with 565 consecutive patients operated during a 7-year period. Treatment options and outcome are assessed with reference to the ability of respecting the unique demands of patients with CVD. In addition, future developments of CVD management are discussed. [source] Evaluating oral health promotion: need for quality outcome measuresCOMMUNITY DENTISTRY AND ORAL EPIDEMIOLOGY, Issue 1 2006Richard G. Watt Abstract , Oral health promotion effectiveness reviews have identified the need to improve the quality of the evaluation of interventions. A project was undertaken to identify and assess the quality of available outcome measures. This paper describes the methodology adopted and highlights the need for further development of oral health promotion outcome measures. Initially a thorough and comprehensive search of both the published and unpublished literature was undertaken to identify potential outcome measures. A set of quality criteria was then developed and used to assess the identified measures. The search identified a total of 1202 outcome measures of which 39% (n = 466) were developed for use with schoolchildren. A high proportion of the identified measures were classified as health literacy and healthy lifestyle outcomes, appropriate for the evaluation of oral health education activities. Only 1% (n = 12) of measures identified were classified in the healthy public policy category. When reviewed against the quality criteria, 49% (n = 594) of the measures were considered satisfactory. The poorest performing measures were those classified as healthy lifestyle and health literacy measures in which only 33% (n = 72) and 41% (n = 240), respectively, were deemed to be of satisfactory quality. In conclusion, a significant number of oral health promotion evaluation outcome measures have been identified although their quality is highly variable. Very few high-quality outcome measures exist for use in the evaluation of oral health policy and environmental interventions. The lack of appropriate and high-quality outcome measures is hampering the development of oral health promotion. [source] | |||||||||||||