Home About us Contact
|
Home About us Contact | ||
|
|
||
Polymer Species (polymer + species)
Selected AbstractsLiquid Chromatography of Synthetic Polymers under Limiting Conditions of Insolubility IIIMACROMOLECULAR SYMPOSIA, Issue 1 2007Application of Monolithic Columns Abstract Summary Performance was evaluated of silica based commercial monolithic rod-like columns in liquid chromatography of synthetic polymers under limiting conditions of enthalpic interactions (LC LC). LC LC employs the barrier effect of the pore permeating and therefore slowly eluting small molecules toward the pore excluded, fast eluting macromolecules. Phase separation (precipitation) barrier action was applied in present study. The barrier was created either by the narrow pulse of an appropriate nonsolvent injected into the column just before the sample solution (LC LC of insolubility , LC LCI) or by the eluent itself. In the latter case, the polymer sample was dissolved and injected in a good solvent (LC LC of solubility , LC LCS). In LC LCI, polymer species cannot break thru the nonsolvent zone while in LC LCS they cannot enter eluent, which is their precipitant. Therefore, polymer species keep moving in the zone of their original solvent. Macromolecules eluting under the LC LC mechanism leave the column in the retention volume (VR) roughly corresponding to VR of the low molar mass substances and can be efficiently separated from the polymer species non-hindered by the barrier action. The known advantages of monoliths were confirmed. From the point of view of LC LCI and LC LCS the most important quality of monolithic columns represents their excellent permeability, which allows both working at high flow rates and injecting very high (in the range of 5%) sample concentrations. Monolithic column tolerate also extremely high molar mass samples (M>10,000 kg,·,mol,1). On the other hand, the mesopores (separation pores) of the tested monoliths exhibited rather small volume and wide size distribution. These shortcomings partially impair the permeability advantage of monoliths because in order to obtain high LC LC separation selectivity a tandem of several monolithic columns must be applied. Presence of large mesopores also reduces applicability of monolithic columns for molar masses below about 50 kg,·,mol,1 because VRs of polymers eluted behind the barrier are similar to that of freely eluting species. The non- negligible break-thru phenomenon was observed for the very high polymer molar masses largely eluting behind the barrier. It is assumed that the fraction of very large mesopores present in the monoliths or association/microphase separation of macromolecules may be responsible for this phenomenon. This is why the presently marketed SiO2 monolithic columns are mainly suitable for the fast purification of the LC LC eluting macromolecules from the polymeric admixtures non-hindered by the barrier-forming liquid. Still, monolithic columns have large potential in the LC LCI and LC LCS procedures provided size (effective diameter) of the mesopores can be reduced and their volume increased. [source] Percolation model of hyperbranched polymerizationMACROMOLECULAR SYMPOSIA, Issue 1 2003Henryk Galina Abstract Computer simulations of the step-growth homopolymerization of an AB2 monomer have been carried out on a square lattice. No rearrangements of units were made between reaction events. Instead, the capture radius, i.e., the maximum distance between the randomly selected unit and its reaction partner was changed. The reaction was considered as controlled either by diffusion and local concentration fluctuations or by the law of mass action (classical limit). The size distribution of polymer species and the extent of cyclization reactions in the polymerization are discussed. [source] Matrix Representation of Polymer Chain Size Distributions, 2,MACROMOLECULAR THEORY AND SIMULATIONS, Issue 2 2007Fundamental Analysis of Linear Polymerization Mechanisms at Transient Conditions Abstract Analysis of the mass balance equations that describe a reaction system may be useful to provide information about its dynamics, such as the restricted set of compositions that can be achieved from a given set of initial compositions and the effect of feeding reactants to the reaction environment along the reaction course. Since these results may be important for the formulation of reaction policies, this work presents the properties of a matrix polymerization model previously developed and extended to describe transient conditions. This model is based on the definitions of two matrices: the consumption matrix (A,,,Kt), which contains information about chemical transformations among the many active polymer species in the system, and the propagation matrix Kp, which contains information about chain growth. It is shown that the set of mass balance equations that describes the dynamics of active chemical species in polymerization reactions has a stable and unique solution, which is bounded if feed rates are also bounded. It is also shown that the set of compositions that may be reached through manipulation of the feed rates is restricted and may not include all possible chemical compositions. Finally, it is shown that the obtained molecular weight distributions are special multiple time convolutions of the initiation rates. [source] Photoresponsive Self-Assembly and Self-Organization of Hydrogen-Bonded Supramolecular TapesCHEMISTRY - A EUROPEAN JOURNAL, Issue 15 2006Shiki Yagai Dr. Abstract Self-assembling building blocks that are readily functionalizable and capable of achieving programmed hierarchical organization have enabled us to create various functional nanomaterials. We have previously demonstrated that N,N, -disubstituted 4,6-diaminopyrimidin-2(1,H)-one (DAP), a guanine,cytosine hybridized molecule, is a versatile building block for the creation of tapelike supramolecular polymer species in solution. In the current study, DAP was functionalized with azobenzene side chains. 1H NMR, UV/Vis, and dynamic light scattering studies confirmed the presence of nanometer-scale tapelike supramolecular polymers in alkane solvents at micromolar regimes. At higher concentrations (millimolar regimes), the supramolecular polymers hierarchically organized into lamellar superstructures to form organogels, as shown by X-ray diffraction and polarized optical microscopy. Remarkably, the azobenzene side chains are photoisomerizable even in the supramolecular polymers, owing to their loosely packed state supported by the rigid hydrogen-bonded scaffold, enabling us to establish photocontrollable supramolecular polymerization and higher order organization of the tapelike supramolecular polymers into lamellar superstructures. [source] | ||||||||||