Home About us Contact
|
Home About us Contact | ||
|
|
||
pH Pretreatment (ph + pretreatment)
Selected AbstractsEffect of enzyme supplementation at moderate cellulase loadings on initial glucose and xylose release from corn stover solids pretreated by leading technologiesBIOTECHNOLOGY & BIOENGINEERING, Issue 2 2009Rajeev Kumar Abstract Moderate loadings of cellulase enzyme supplemented with ,-glucosidase were applied to solids produced by ammonia fiber expansion (AFEX), ammonia recycle (ARP), controlled pH, dilute sulfuric acid, lime, and sulfur dioxide pretreatments to better understand factors that control glucose and xylose release following 24, 48, and 72 h of hydrolysis and define promising routes to reducing enzyme demands. Glucose removal was higher from all pretreatments than from Avicel cellulose at lower enzyme loadings, but sugar release was a bit lower for solids prepared by dilute sulfuric acid in the Sunds system and by controlled pH pretreatment than from Avicel at higher protein loadings. Inhibition by cellobiose was observed to depend on the type of substrate and pretreatment and hydrolysis times, with a corresponding impact of ,-glucosidase supplementation. Furthermore, for the first time, xylobiose and higher xylooligomers were shown to inhibit enzymatic hydrolysis of pure glucan, pure xylan, and pretreated corn stover, and xylose, xylobiose, and xylotriose were shown to have progressively greater effects on hydrolysis rates. Consistent with this, addition of xylanase and ,-xylosidase improved performance significantly. For a combined mass loading of cellulase and ,-glucosidase of 16.1 mg/g original glucan (about 7.5 FPU/g), glucose release from pretreated solids ranged from 50% to75% of the theoretical maximum and was greater for all pretreatments at all protein loadings compared to pure Avicel cellulose except for solids from controlled pH pretreatment and from dilute acid pretreatment by the Sunds pilot unit. The fraction of xylose released from pretreated solids was always less than for glucose, with the upper limit being about 60% of the maximum for ARP and the Sunds dilute acid pretreatments at a very high protein mass loading of 116 mg/g glucan (about 60 FPU). Biotechnol. Bioeng. 2009;102: 457,467. © 2008 Wiley Periodicals, Inc. [source] Effects of cellulase and xylanase enzymes on the deconstruction of solids from pretreatment of poplar by leading technologiesBIOTECHNOLOGY PROGRESS, Issue 2 2009Rajeev Kumar Abstract Comparative data is presented on glucose and xylose release for enzymatic hydrolysis of solids produced by pretreatment of poplar wood by ammonia fiber expansion (AFEX), ammonia recycled percolation (ARP), controlled pH, dilute acid, flowthrough (FT), lime, and sulfur dioxide (SO2) technologies. Sugar solubilization was measured for times of up to 72 h using cellulase supplemented with ,-glucosidase at an activity ratio of 1:2, respectively, at combined protein mass loadings of 5.8,116 mg/g of glucan in poplar wood prior to pretreatment. In addition, the enzyme cocktail was augmented with up to 11.0 g of xylanase protein per gram of cellulase protein at combined cellulase and ,-glucosidase mass loadings of 14.5 and 29.0 mg protein (about 7.5 and 15 FPU, respectively)/g of original potential glucose to evaluate cellulase,xylanase interactions. All pretreated poplar solids required high protein loadings to realize good sugar yields via enzymatic hydrolysis, and performance tended to be better for low pH pretreatments by dilute sulfuric acid and sulfur dioxide, possibly due to higher xylose removal. Glucose release increased nearly linearly with residual xylose removal by enzymes for all pretreatments, xylanase leverage on glucan removal decreased at high cellulase loadings. Washing the solids improved digestion for all pretreatments and was particularly beneficial for controlled pH pretreatment. Furthermore, incubation of pretreated solids with BSA, Tween 20, or PEG6000 prior to adding enzymes enhanced yields, but the effectiveness of these additives varied with the type of pretreatment. © 2009 American Institute of Chemical Engineers Biotechnol. Prog., 2009 [source] Access of cellulase to cellulose and lignin for poplar solids produced by leading pretreatment technologiesBIOTECHNOLOGY PROGRESS, Issue 3 2009Rajeev Kumar Abstract Adsorption of cellulase on solids resulting from pretreatment of poplar wood by ammonia fiber expansion (AFEX), ammonia recycled percolation (ARP), controlled pH, dilute acid (DA), flowthrough (FT), lime, and sulfur dioxide (SO2) and pure Avicel glucan was measured at 4°C, as were adsorption and desorption of cellulase and adsorption of ,-glucosidase for lignin left after enzymatic digestion of the solids from these pretreatments. From this, Langmuir adsorption parameters, cellulose accessibility to cellulase, and the effectiveness of cellulase adsorbed on poplar solids were estimated, and the effect of delignification on cellulase effectiveness was determined. Furthermore, Avicel hydrolysis inhibition by enzymatic and acid lignin of poplar solids was studied. Flowthrough pretreated solids showed the highest maximum cellulase adsorption capacity (,solids = 195 mg/g solid) followed by dilute acid (,solids = 170.0 mg/g solid) and lime pretreated solids (,solids = 150.8 mg/g solid), whereas controlled pH pretreated solids had the lowest (,solids = 56 mg/g solid). Lime pretreated solids also had the highest cellulose accessibility (,cellulose = 241 mg/g cellulose) followed by FT and DA. AFEX lignin had the lowest cellulase adsorption capacity (,lignin = 57 mg/g lignin) followed by dilute acid lignin (,lignin = 74 mg/g lignin). AFEX lignin also had the lowest ,-glucosidase capacity (,lignin = 66.6 mg/g lignin), while lignin from SO2 (,lignin = 320 mg/g lignin) followed by dilute acid had the highest (301 mg/g lignin). Furthermore, SO2 followed by dilute acid pretreated solids gave the highest cellulase effectiveness, but delignification enhanced cellulase effectiveness more for high pH than low pH pretreatments, suggesting that lignin impedes access of enzymes to xylan more than to glucan, which in turn affects glucan accessibility. In addition, lignin from enzymatic digestion of AFEX and dilute acid pretreated solids inhibited Avicel hydrolysis less than ARP and flowthrough lignin, whereas acid lignin from unpretreated poplar inhibited enzymes the most. Irreversible binding of cellulase to lignin varied with pretreatment type and desorption method. © 2009 American Institute of Chemical Engineers Biotechnol. Prog., 2009 [source] Effects of cellulase and xylanase enzymes on the deconstruction of solids from pretreatment of poplar by leading technologiesBIOTECHNOLOGY PROGRESS, Issue 2 2009Rajeev Kumar Abstract Comparative data is presented on glucose and xylose release for enzymatic hydrolysis of solids produced by pretreatment of poplar wood by ammonia fiber expansion (AFEX), ammonia recycled percolation (ARP), controlled pH, dilute acid, flowthrough (FT), lime, and sulfur dioxide (SO2) technologies. Sugar solubilization was measured for times of up to 72 h using cellulase supplemented with ,-glucosidase at an activity ratio of 1:2, respectively, at combined protein mass loadings of 5.8,116 mg/g of glucan in poplar wood prior to pretreatment. In addition, the enzyme cocktail was augmented with up to 11.0 g of xylanase protein per gram of cellulase protein at combined cellulase and ,-glucosidase mass loadings of 14.5 and 29.0 mg protein (about 7.5 and 15 FPU, respectively)/g of original potential glucose to evaluate cellulase,xylanase interactions. All pretreated poplar solids required high protein loadings to realize good sugar yields via enzymatic hydrolysis, and performance tended to be better for low pH pretreatments by dilute sulfuric acid and sulfur dioxide, possibly due to higher xylose removal. Glucose release increased nearly linearly with residual xylose removal by enzymes for all pretreatments, xylanase leverage on glucan removal decreased at high cellulase loadings. Washing the solids improved digestion for all pretreatments and was particularly beneficial for controlled pH pretreatment. Furthermore, incubation of pretreated solids with BSA, Tween 20, or PEG6000 prior to adding enzymes enhanced yields, but the effectiveness of these additives varied with the type of pretreatment. © 2009 American Institute of Chemical Engineers Biotechnol. Prog., 2009 [source] | ||||||||||