Home About us Contact
|
Home About us Contact | ||
|
|
||
Parallel Channels (parallel + channel)
Selected AbstractsHarvesting Excitons Via Two Parallel Channels for Efficient White Organic LEDs with Nearly 100% Internal Quantum Efficiency: Fabrication and Emission-Mechanism AnalysisADVANCED FUNCTIONAL MATERIALS, Issue 1 2009Qi Wang Abstract By incorporating two phosphorescent dyes, namely, iridium(III)[bis(4,6-difluorophenyl)-pyridinato-N,C2,]picolinate (FIrpic) for blue emission and bis(2-(9,9-diethyl-9H -fluoren-2-yl)-1-phenyl-1H -benzoimidazol-N,C3)iridium(acetylacetonate) ((fbi)2Ir(acac)) for orange emission, into a single-energy well-like emissive layer, an extremely high-efficiency white organic light-emitting diode (WOLED) with excellent color stability is demonstrated. This device can achieve a peak forward-viewing power efficiency of 42.5,lm,W,1, corresponding to an external quantum efficiency (EQE) of 19.3% and a current efficiency of 52.8,cd,A,1. Systematic studies of the dopants, host and dopant-doped host films in terms of photophysical properties (including absorption, photoluminescence, and excitation spectra), transient photoluminescence, current density,voltage characteristics, and temperature-dependent electroluminescence spectra are subsequently performed, from which it is concluded that the emission natures of FIrpic and (fbi)2Ir(acac) are, respectively, host,guest energy transfer and a direct exciton formation process. These two parallel pathways serve to channel the overall excitons to both dopants, greatly reducing unfavorable energy losses. It is noteworthy that the introduction of the multifunctional orange dopant (fbi)2Ir(acac) (serving as either hole-trapping site or electron-transporting channel) is essential to this concept as it can make an improved charge balance and broaden the recombination zone. Based on this unique working model, detailed studies of the slight color-shift in this WOLED are performed. It is quantitatively proven that the competition between hole trapping on orange-dopant sites and undisturbed hole transport across the emissive layer is the actual reason. Furthermore, a calculation of the fraction of trapped holes on (fbi)2Ir(acac) sites with voltage shows that the hole-trapping effect of the orange dopant is decreased with increasing drive voltage, leading to a reduction of orange emission. [source] Fluid flow and heat transfer of natural convection around array of vertical heated platesHEAT TRANSFER - ASIAN RESEARCH (FORMERLY HEAT TRANSFER-JAPANESE RESEARCH), Issue 2 2009Kenzo Kitamura Abstract Natural convective flows around an array of vertical heated plates were investigated experimentally. Main concerns were directed to the influences of plate numbers on the heat transfer characteristics of the plates. Both surfaces of the test plates were heated with constant and equal heat fluxes and their local heat transfer coefficients were measured. The results showed that the coefficients of the surfaces of the array facing outward became higher than those facing inward. The flow fields around the bottom of the plate array were visualized with smoke. The result showed that the ambient flow is directed from the sides to the center of the array and enters the parallel channel obliquely. These flows cause the above difference in the coefficients. While the difference gradually diminished in between the plates placed in the central section of the array, their coefficients asymptotically approach those of the analytical correlation that assumed a uniform velocity at the channel inlet. © 2008 Wiley Periodicals, Inc. Heat Trans Asian Res; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/htj.20232 [source] How the parallel channels of the retina contribute to depth processingEUROPEAN JOURNAL OF NEUROSCIENCE, Issue 5 2007Peter H. Schiller Abstract Reconstructing the third dimension in the visual scene from the two dimensional images that impinge on the retinal surface is one of the major tasks of the visual system. We have devised a visual display that makes it possible to study stereoscopic depth cues and motion parallax cues separately or in concert using rhesus macaques. By varying the spatial frequency of the display and its luminance and chrominance, it is possible to selectively activate channels that originate in the primate retina. Our results show that (i) the parasol system plays a central role in processing motion parallax cues; (ii) the midget system plays a central role in stereoscopic depth perception at high spatial frequencies, and (iii) red/green colour selective neurons can effectively process both cues but blue/yellow neurons cannot do so. [source] Structural analysis of photosystem II in far-red-light-adapted thylakoid membranesFEBS JOURNAL, Issue 1 2000New crystal forms provide evidence for a dynamic reorganization of light-harvesting antennae subunits We studied two-dimensional crystals of the major pigment,protein complex, photosystem II, in far-red-light-adapted thylakoid membranes of the viridis-zb63 mutant of barley. Significantly larger grana membranes were produced with an increased synthesis of the entire photosystem II complex. These red-light-adapted membranes also contained two-dimensional crystals with a high frequency. Three different crystal forms of photosystem II were observed, providing the following data which further our understanding of the architecture of the native complex. (a) The oligomeric form of photosystem II in the membrane was monomeric in all crystal forms, but with a clear non-crystallographic pseudo-twofold symmetry. This was more apparent on the lumenal face of the complex. (b) The variability of unit cell contacts in different crystal forms implied that the peripheral light-harvesting antenna complex and the core of the complex were loosely connected. These peripheral subunits were predicted to rearrange so that they can either encircle the core complex or associate in parallel channels separated by lines of core complexes. (c) Grana membranes were found to retain a double-layered inside-out character, with a stromal face-to-stromal face packing. However, the presence of a crystal in one membrane did not necessarily impose crystallinity on its pair. [source] Investigation of nonuniformity in a liquid,solid fluidized bed with identical parallel channelsAICHE JOURNAL, Issue 1 2010Long Fan Abstract Previous work has demonstrated that multiphase flow through identical parallel channels and multiple cyclones can give rise to significant nonuniformity among the flow paths. This article presents results from a study where the distribution of voidage and flux through parallel channels in liquid,solid fluidized beds is investigated. Experiments and computational fluid dynamics simulations were performed with 1.2 mm glass beads fluidized by water where a cross baffle divided a 191 mm diameter column into four identical parallel channels. Voidages were measured by optical fiber probes. Simulations from a three-dimensional unsteady-state Eulerian,Eulerian model based on FLUENT software showed good agreement with the experimental results. Despite the symmetrical geometry of the system, the average voidage and particle velocities in one channel differed somewhat from those in the others. Increasing the superficial liquid velocity could increase voidage greatly and affect the degree of nonuniformity in the four channels. © 2009 American Institute of Chemical Engineers AIChE J, 2009 [source] A Power Efficient Electronic Implant for a Visual Cortical NeuroprosthesisARTIFICIAL ORGANS, Issue 3 2005Jonathan Coulombe Abstract:, An integrated microstimulator designed for a cortical visual prosthesis is presented, along with a pixel reordering algorithm, together minimizing the peak total current and voltage required for stimulation of large numbers of electrodes at a high rate. In order to maximize the available voltage for stimulation at a given supply voltage for generating biphasic pulses, the device uses monopolar stimulation, where the return electrode voltage is dynamically varied. Thus, the voltage available for stimulation is maximized, as opposed to the conventional fixed return voltage monopolar approach, and impedance is significantly lower than can be achieved using bipolar stimulation with microelectrodes. This enables the use of a low voltage power supply, minimizing power consumption of the device. An important constraint resulting from this stimulation strategy, however, is that current generation needs to be simultaneous and in-phase for all active parallel channels, imposing heavy stress on the wireless power recovery and regulation circuitry in large electrode count systems such as a visual prosthesis. An ordering algorithm to be implemented in the external controller of the prosthesis is then proposed. Based on the data for each frame of the video signal to be transmitted to the implant, the algorithm minimizes the total generated current standard deviation between time multiplexed stimulations by determining the most appropriate combination of parallel stimulation channels to be activated simultaneously. A stimulator prototype has been implemented in CMOS technology and successfully tested. Execution of the external controller reordering algorithm on an application specific hardware architecture has been verified using a System-On-Chip development platform. A near 75% decrease in the total stimulation current standard deviation was observed with a one-pass algorithm, whereas a recursive variation of the algorithm resulted in a greater than 95% decrease of the same variable. [source] Perfusion seeding of channeled elastomeric scaffolds with myocytes and endothelial cells for cardiac tissue engineeringBIOTECHNOLOGY PROGRESS, Issue 2 2010Robert Maidhof Abstract The requirements for engineering clinically sized cardiac constructs include medium perfusion (to maintain cell viability throughout the construct volume) and the protection of cardiac myocytes from hydrodynamic shear. To reconcile these conflicting requirements, we proposed the use of porous elastomeric scaffolds with an array of channels providing conduits for medium perfusion, and sized to provide efficient transport of oxygen to the cells, by a combination of convective flow and molecular diffusion over short distances between the channels. In this study, we investigate the conditions for perfusion seeding of channeled constructs with myocytes and endothelial cells without the gel carrier we previously used to lock the cells within the scaffold pores. We first established the flow parameters for perfusion seeding of porous elastomer scaffolds using the C2C12 myoblast line, and determined that a linear perfusion velocity of 1.0 mm/s resulted in seeding efficiency of 87% ± 26% within 2 hours. When applied to seeding of channeled scaffolds with neonatal rat cardiac myocytes, these conditions also resulted in high efficiency (77.2% ± 23.7%) of cell seeding. Uniform spatial cell distributions were obtained when scaffolds were stacked on top of one another in perfusion cartridges, effectively closing off the channels during perfusion seeding. Perfusion seeding of single scaffolds resulted in preferential cell attachment at the channel surfaces, and was employed for seeding scaffolds with rat aortic endothelial cells. We thus propose that these techniques can be utilized to engineer thick and compact cardiac constructs with parallel channels lined with endothelial cells. © 2010 American Institute of Chemical Engineers Biotechnol. Prog., 2010 [source] The Influence of Differences Between Microchannels on Micro Reactor PerformanceCHEMICAL ENGINEERING & TECHNOLOGY (CET), Issue 3 2005E. R. Delsman Abstract Microstructured reactors most often contain a large number of micrometer-sized, parallel channels, instead of a large undivided reaction volume. Individual microchannels behave as plug-flow reactors without significant axial dispersion and with excellent heat and mass transfer properties. However, since the reaction takes place in a large number of parallel channels, it is important that all channels provide equal residence time and amount of catalyst volume. These issues depend not only on the flow distributor design, but also, for example, on the manufacturing tolerances. Correlations are derived to express the conversion of a multichannel microreactor explicitly as a function of the variance of a number of reactor parameters, viz. the channel flow rate, the channel diameter, the amount of catalyst in a channel, and the channel temperature. It is shown that the influence of flow maldistribution on the overall reactor conversion is relatively small, while the influences of variations in the channel diameter and the amount of catalyst coating are more pronounced. The model outcomes are also compared to experimental results of two microreactors with different catalyst distributions, which show that the presented method is able to provide a quick, though rough estimation of the influence of differences between channels on microreactor performance. [source] | |||||||||||||