Home About us Contact
|
Home About us Contact | ||
|
|
||
Low Activation Energy (low + activation_energy)
Selected AbstractsVariable Temperature Mobility Analysis of n-Channel, p-Channel, and Ambipolar Organic Field-Effect TransistorsADVANCED FUNCTIONAL MATERIALS, Issue 1 2010Joseph A. Letizia Abstract The temperature dependence of field-effect transistor (FET) mobility is analyzed for a series of n-channel, p-channel, and ambipolar organic semiconductor-based FETs selected for varied semiconductor structural and device characteristics. The materials (and dominant carrier type) studied are 5,5,,,-bis(perfluorophenacyl)-2,2,:5,,2,:5,,2,,,-quaterthiophene (1, n-channel), 5,5,,,-bis(perfluorohexyl carbonyl)-2,2,:5,,2,:5,,2,,,-quaterthiophene (2, n-channel), pentacene (3, p-channel); 5,5,,,-bis(hexylcarbonyl)-2,2,:5,,2,:5,,2,,,-quaterthiophene (4, ambipolar), 5,5,,,-bis-(phenacyl)-2,2,: 5,,2,:5,,2,,,-quaterthiophene (5, p-channel), 2,7-bis((5-perfluorophenacyl)thiophen-2-yl)-9,10-phenanthrenequinone (6, n-channel), and poly(N -(2-octyldodecyl)-2,2,-bithiophene-3,3,-dicarboximide) (7, n-channel). Fits of the effective field-effect mobility (µeff) data assuming a discrete trap energy within a multiple trapping and release (MTR) model reveal low activation energies (EAs) for high-mobility semiconductors 1,3 of 21, 22, and 30,meV, respectively. Higher EA values of 40,70,meV are exhibited by 4,7 -derived FETs having lower mobilities (µeff). Analysis of these data reveals little correlation between the conduction state energy level and EA, while there is an inverse relationship between EA and µeff. The first variable-temperature study of an ambipolar organic FET reveals that although n-channel behavior exhibits EA,=,27,meV, the p-channel regime exhibits significantly more trapping with EA,=,250,meV. Interestingly, calculated free carrier mobilities (µ0) are in the range of ,0.2,0.8,cm2,V,1 s,1 in this materials set, largely independent of µeff. This indicates that in the absence of charge traps, the inherent magnitude of carrier mobility is comparable for each of these materials. Finally, the effect of temperature on threshold voltage (VT) reveals two distinct trapping regimes, with the change in trapped charge exhibiting a striking correlation with room temperature µeff. The observation that EA is independent of conduction state energy, and that changes in trapped charge with temperature correlate with room temperature µeff, support the applicability of trap-limited mobility models such as a MTR mechanism to this materials set. [source] Addressing chemical diversity by employing the energy landscape conceptACTA CRYSTALLOGRAPHICA SECTION A, Issue 5 2010Martin Jansen Exploring the structural diversity of a chemical system rests on three pillars. First, there is the global exploration of its energy landscape that allows one to predict which crystalline modifications can exist in a chemical system at a given temperature and pressure. Next, there is the development of new synthesis methods in solid-state chemistry, which require only very low activation energies such that even metastable modifications corresponding, for example, to minima on the landscape surrounded by low barriers can be realized. Finally, there is the theoretical design of optimal synthesis routes, again based on the study of the system's energy landscape. In this paper the energy landscape approach to the prediction of stable and metastable compounds as a function of temperature and pressure is presented, with a particular focus on possible phase transitions. Furthermore, several examples are presented, where such predicted compounds were subsequently successfully synthesized, often employing a newly developed synthesis method, low-temperature atom-beam deposition. [source] Synthesis and Characterization of Semiconductive Dichloridobis(thianthrene)gold(1+) Tetrachloridoaurate(1,)EUROPEAN JOURNAL OF INORGANIC CHEMISTRY, Issue 17 2009Rachmat Triandi Tjahjanto Abstract A new (thianthrene)gold(III) complex has been synthesized in liquid SO2 as the solvent from thianthrene (TA) andAuCl3. [AuCl2(TA)2][AuCl4] [triclinic, P, a = 9.9832(2) Å, b = 10.3404(2) Å, c = 15.0798(4) Å, , = 75.038(1)°, , = 81.610(1)°, , = 68.409(1)°, V = 1396.15(5) Å3, Z = 2] has a salt-like structure consisting of [AuCl2(TA)2]+ and [AuCl4], ions, both with square-planar coordinated gold atoms of oxidation state +3. In the cation, two bent TA molecules are coordinated to Au each through one sulfur atom. The title compound is thermally stable up to 425 K and is semiconducting with a conductivity reaching 25 mSm,1 at 380 K and a low activation energy of 0.43 eV. A model for the charge transport along the stacked cationic complexes is discussed. When dissolved in chloroform [AuCl2(TA)2][AuCl4] is converted into the already known uncharged, mononuclear complex [AuCl3(TA)], which shows that a polymerization isomerism exists between the two forms.(© Wiley-VCH Verlag GmbH & Co. KGaA, 69451 Weinheim, Germany, 2009) [source] Microstructure and Microfabrication Considerations for Self-Supported On-Chip Ultra-Thin Micro-Solid Oxide Fuel Cell MembranesFUEL CELLS, Issue 5 2009B.-K. Lai Abstract La0.6Sr0.4Co0.8Fe0.2O3,,,, (LSCF) has been sputtered on bare Si and Si3N4 and yttria-stabilised zirconia (YSZ) thin films to investigate annealing temperature- and thickness-dependent microstructure and functional properties, as well as their implications for designing failure-resistant micro-solid oxide fuel cell (,SOFC) membranes. The LSCF thin films crystallise in the 400,450,°C range; however, after annealing in the 600,700,°C range, cracks are observed. The formation of cracks is also thickness-dependent. High electrical conductivity, ,520,Scm,1 at 600,°C, and low activation energy, ,0.13,eV, in the 400,600,°C range, are still maintained for LSCF films as thin as 27,nm. Based on these studies, a strong correlation between microstructure and electrical conductivity has been observed and an annealing temperature-thickness design space that is complementary to temperature-stress design space has been proposed for designing reliable membranes using sputtered LSCF thin films. Microfabrication approaches that maintain the highest possible surface and interface quality of heterostructured membranes have been carefully examined. By taking advantage of the microstructure, microfabrication and geometrical structural considerations, we were able to successfully fabricate large-area, self-supported membranes. These results are also relevant to conventional or grid-supported SOFC membranes using ultrathin nanocrystalline cathodes and ,SOFCs using cathode thin films other than LSCF. [source] Formation and decay of the ABTS derived radical cation: A comparison of different preparation proceduresINTERNATIONAL JOURNAL OF CHEMICAL KINETICS, Issue 12 2002Carola Henriquez Bleaching of a preformed solution of the blue-green radical cation 2,2,-azinobis (3-ethylbenzothizoline-6-sulfonic acid) (ABTS+·) has been extensively used to evaluate the antioxidant capacity of complex mixtures and individual compounds. The reaction of the preformed radical with free-radical scavengers can be easily monitored by following the decay of the sample absorbance at 734 nm. The ABTS radical cation can be prepared employing different oxidants. Results obtained using MnO2 as oxidant show that the presence of manganese ions increases the rate of [ABTS]+· autobleaching in a concentration-dependent manner. The radicals can also be obtained by oxidizing ABTS with 2,2, -azobis(2-amidinopropane)hydrochloride (AAPH) or peroxodisulfate (PDS). The oxidation by AAPH takes place with a large activation energy and a low reaction order in ABTS. The data support a mechanism in which the homolysis of AAPH is the rate-limiting step, followed by the reaction of ABTS with the peroxyl radicals produced after the azocompound thermolysis. On the other hand, the low activation energy measured employing PDS, as well as the kinetic law, are compatible with the occurrence of a bimolecular reaction between the oxidant and ABTS. Regarding the use of ABTS-based methodologies for the evaluation of free radical scavengers, radical cations obtained employing AAPH as oxidant can be used only at low temperatures, conditions where further decomposition of the remaining AAPH is minimized. The best results are obtained with ABTS derived radicals generated in the reaction of PDS with an ABTS/PDS concentration ratio equal (or higher) to two. However, even with radicals prepared by this procedure, stoichiometric coefficients considerably larger than two are obtained for the consumption of the radical cation employing tryptophane or p -terbutylphenol as reductants. This casts doubts on the use of ABTS-based procedures for the estimation of antioxidant capacities. © 2002 Wiley Periodicals, Inc. Int J Chem Kinet 34: 659,665, 2002 [source] Kinetic Studies of Mullite Synthesis from Alumina Nanoparticles and a Preceramic PolymerJOURNAL OF THE AMERICAN CERAMIC SOCIETY, Issue 8 2008Flavio Griggio The crystallization kinetics of mullite formation in a diphasic precursor consisting of a silicone resin filled with commercial ,-alumina nanoparticles (15 nm mean particle size, specific surface area of 100 m2/g), heated in air from 1250° to 1350°C, was studied by X-ray diffraction. Transitional ,-alumina and amorphous silica from the pyrolysis of the preceramic polymer exhibited a remarkable reactivity, as demonstrated by a very low incubation time (from 500 s at 1250°C to 20 s at 1350°C), a high mullite yield (about 80 vol%, after 100 s at 1350°C), and a low activation energy for nucleation (677±60 kJ/mol). The activation energy values found were lower than those reported previously for other diphasic systems, including sol,gel precursors. Besides the high specific surface of nanosized ,-alumina particles, the low energy barrier could be attributed to the highly reactive silica deriving from the oxidation of Si,CH3 bonds in the silicone and to the homogeneous dispersion of the nanosized filler inside the preceramic polymer. Furthermore, the possibility of applying plastic shaping processing methods to the mixture of a preceramic polymer and nanosized filler makes this approach particularly valuable, in comparison, for instance, with sol,gel based alternatives. [source] Poly(propylene carbonate), old CO2 Copolymer with New AttractivenessMACROMOLECULAR SYMPOSIA, Issue 1 2007Gerrit A. Luinstra Abstract Summary: The catalytic synthesis of poly(propylene carbonate) (PPC) from propylene oxide and CO2 is mediated by zinc glutarate and chromium salen complexes. The determined solid state structure of the zinc glutarate was taken to model the polymerisation of ethylene oxide. It has a low activation energy for a reaction path involving two zinc atoms, where one binds the nucleophilic alkoxy chain end and one activates the epoxide. A similar pathway may operate in the alternating copolymerization PO/CO2 as is shown in the homogeneous chromium salen catalyst system. The material profile was determined of PPC with 93% carbonate linkages. A study of the transparent blend with poly(lactic acid) (PLA) shows that the polymers are not miscible, but rather compatible as they are finely dispersed and show linear behaviour in the mechanic properties. The permeability of oxygen, carbon dioxide and water of the composite PPC/PLA are also reported. [source] Chemistry and Reaction of Singlet Oxygen in FoodsCOMPREHENSIVE REVIEWS IN FOOD SCIENCE AND FOOD SAFETY, Issue 2 2002D. B. Min ABSTRACT Singlet oxygen is a highly reactive, electrophilic, and nonradical molecule. It is different from diradical triplet oxygen in its electron arrangement. Photosensitizers can form singlet oxygen from triplet oxygen in the presence of light. The reaction rate of singlet oxygen with foods is much greater than that of triplet oxygen due to the low activation energy. Singlet oxygen oxidation produces undesirable compounds in foods during processing and storage. However, carotenoids and tocopherols in foods can minimize singlet oxygen oxidation. The in-depth scientific knowledge on the formation, reactions, quenching mechanisms, and kinetics of singlet oxygen can greatly improve the quality of foods by minimizing the oxidation during processing and storage. The single oxygen oxidation of foods has contributed to the explanation of several important chemical reactions in the reversion flavor in soybean oil, sunlight flavor in milk products, and the rapid losses of vitamin D, riboflavin, and ascorbic acid in milk under light storage. [source] | |||||||||||||