			Home About us Contact

Increased Resolution (increased + resolution)

Distribution by Scientific Domains

Chemistry	28%

Selected Abstracts

TROSY effects in MAS solid-state NMR

CONCEPTS IN MAGNETIC RESONANCE, Issue 2 2008
Veniamin Chevelkov
Abstract Use of transverse relaxation-optimized spectroscopy (TROSY) type techniques had a dramatic impact on the study of large proteins with a molecular weight >30kDa for solution-state NMR. In the solid-state, such an effect would not be expected a prior, as the investigated molecules are immobilized. However, local motions induce fluctuations of the local fields experienced by the nuclear spins and, this way, are effective for relaxation. We demonstrate that protein dynamics can significantly influence the resonance line width in ultra high resolution MAS (magic angle spinning) solid-state NMR experiments. Averaging of the 15NH,/, multiplet components as a consequence of 1H decoupling induces effective broadening of the 15N resonance. Application of TROSY type techniques that select only the narrow component of the multiplet pattern results in an increased resolution and, thus, will be of benefit for MAS solid-state NMR spectroscopy. © 2008 Wiley Periodicals, Inc. Concepts Magn Reson Part A 32A: 143,156, 2008. [source]

Capillary electrophoresis analysis of glucooligosaccharide regioisomers

ELECTROPHORESIS, Issue 6 2004
Gilles Joucla
Abstract Complex gluco-oligosaccharide mixtures of two regioisomer series were successfully separated by CE. The gluco-oligosaccharide series were synthesized, employing a dextransucrase from Leuconostoc mesenteroides NRRL B-512F, by successive glucopyranosyl transfers from sucrose to the acceptor glucose or maltose. The glucosyl transfer to both acceptors, occurring through the formation of ,1,6 linkages, differed for the two series only in the glucosidic bond to the reducing end namely ,1,6 or ,1,4 bond for glucose or maltose acceptor, respectively. Thus, the combination of the two series results in mixed pairs of gluco-oligosaccharide regioisomers with different degrees of polymerization (DP). These regioisomer series were first derivatized by reductive amination with 9-aminopyrene-1,4,6-trisulfonate (APTS). Under acidic conditions using triethyl ammonium acetate as electrolyte, the APTS-gluco-oligosaccharides of each series were separated enabling unambiguous size determination by coupling CE to electrospray-mass spectrometry. However, neither these acidic conditions nor alkaline buffer systems could be adapted for the separation of the gluco-oligosaccharide regioisomers arising from the two combined series. By contrast, increased resolution was observed in an alkaline borate buffer, using differential complexation of the regioisomers with the borate anions. Such conditions were also successfully applied to the separation of glucodisaccharide regioisomers composed of ,1,2, ,1,3, ,1,4, and ,1,6 linkages commonly synthesized by glucansucrase enzymes. [source]

Capillary zone electrophoresis with a dynamic double coating for analysis of carbohydrate-deficient transferrin in human serum: Impact of resolution between disialo- and trisialotransferrin on reference limits

ELECTROPHORESIS, Issue 24 2003
Christian Lanz
Abstract Capillary electrophoresis with a dynamic double coating formed by charged polymeric reagents represents a very effective tool for the separation of iron-saturated transferrin (Tf) isoforms and thus the determination of carbohydrate-deficient transferrin (CDT) in human serum. The resolution between di- and trisialo-Tf is dependent on the applied voltage and capillary temperature. With a 50 ,m inside diameter (ID) capillary of about 60 cm total length mounted into the P/ACE MDQ, 28 kV and 40°C, the resolution of the two Tf isoforms is shown to be between 1.0 and 1.4, whereas with reduced voltage and/or temperature, increased resolution at the expense of elongated run times is observed. Best data with complete resolution (Rs , 1.4) are obtained at 20 kV and 30°C. For the determination of CDT in serum, incomplete separation of di- and trisialo-Tf is demonstrated to have an impact on the reference limits. Analysis of the sera of 54 healthy individuals with no or moderate alcohol consumption and using valley-to-valley peak integration, the upper (lower) reference limits for CDT in relation to total Tf at the two power levels are 1.33 (0.52) and 1.57 (0.81)%, respectively, representing intervals that are significantly different (P < 0.001). Furthermore, the reference intervals are shown to be strongly dependent on the peak integration approach used. Valley-to-valley peak integration should only be employed for conditions with complete resolution between disialo- and trisialo-Tf. [source]

A simple polyacrylamide gel electrophoresis procedure for separation of polyamidoamine dendrimers

ELECTROPHORESIS, Issue 16 2003
Ajit Sharma
Abstract A simple, inexpensive, and rapid electrophoresis technique was developed for use as a routine tool for evaluating purity of polyamidoamine (PAMAM) dendrimers. A variety of factors influencing migration of generations 0,7 dendrimers on nongradient polyacrylamide gels were evaluated. The low generation dendrimers were found to be very sensitive to diffusion during or after electrophoresis. The proposed method incorporates steps that minimize diffusion, in order to obtain improved resolution and sensitivity, especially for the lower-molecular-weight dendrimers. This was accomplished by inclusion of a dendrimer fixation step with glutaraldehyde and performing the electrophoresis separation, fixation, staining, and destaining at 4°C. PAMAM dendrimer separation was studied under basic and acidic conditions. Electrophoresis under acidic conditions gave increased resolution and sensitivity over separation at alkaline pH. Oligomers and trailing generations could be clearly separated and visualized under these conditions. The smallest PAMAM dendrimer, generation 0, was visible at 1.5 ,g under the optimized acidic conditions. With slight modifications, this technique should be applicable to separation of other water-soluble dendrimers. [source]

Low-resolution phase extension using wavelet analysis

ACTA CRYSTALLOGRAPHICA SECTION D, Issue 10 2000
Peter Main
A method to extend low-resolution phases is presented which uses histogram matching not only of the electron density, but also of histograms obtained from the different levels of detail provided by the wavelet transform of the electron density. Statistical values for the wavelet coefficients can be predicted and depend only on the resolution and solvent content. Therefore, new details can be added to an electron-density map by matching the values of the wavelet coefficients to those predicted for an increased resolution. The positions of the new details are also guided by the diffraction pattern. In this way, the resolution can be increased gradually; on a number of trial structures of different size, solvent percentage and space group, it has been possible to extend the phasing from 10,Å to around 6,7,Å. [source]

3D seismic technology: the geological ,Hubble'

BASIN RESEARCH, Issue 1 2005
Joe Cartwright
The proliferation of three-dimensional (3D) seismic technology is one of the most exciting developments in the Earth Sciences over the past century. 3D reflection seismic data provide interpreters with the ability to map structures and stratigraphic features in 3D detail to a resolution of a few tens of metres over thousands of square kilometres. It is a geological ,Hubble', whose resolving power has already yielded some fascinating (and surprising) insights and will continue to provide a major stimulus for research into geological processes and products for many decades to come. Academic and other research institutions have a major role to play in the use of this data by exploiting the enormous volume of geological information contained in 3D seismic surveys. This paper reviews some of the recent advances in basin analysis made using the medium of 3D seismic data, focusing on the fields of structural and sedimentary geology, fluid,rock interactions and igneous geology. It is noted that the increased resolution of the 3D seismic method provided the essential catalyst necessary to stimulate novel observations and discover new geological structures such as mud diapir feeders, km-long gas blow-out pipes, giant pockmarks and sandstone intrusions, and to capture the spatial variability of diagenetic fronts. The UKs first impact crater was also discovered using 3D seismic data. The potential for future developments in this field of geophysical interpretation is considerable, and we anticipate that new discoveries will be made in many years to come. [source]

Magnifying Superlenses and other Applications of Plasmonic Metamaterials in Microscopy and Sensing

CHEMPHYSCHEM, Issue 4 2009
Igor I. Smolyaninov Dr.
Abstract Every last detail: New advances in the construction of metamaterials enable the creation of artificial optical media, whose use in microscopy can provide resolution that is not determined by the conventional diffraction limit. The picture shows a superposition of an AFM image of a plasmonic metamaterial onto the corresponding optical image obtained using a conventional optical microscope. Over the past century, the resolution of conventional optical microscopes, which rely on optical waves that propagate into the far field, has been limited because of diffraction to a value of the order of a half-wavelength (,0/2) of the light used. Although immersion microscopes have slightly improved resolution, of the order of ,0/2n, the increased resolution is limited by the small range of refractive indices n of available transparent materials. However, now we are experiencing a quick demolition of the diffraction limit in optical microscopy. In the last few years, numerous nonlinear optical microscopy techniques based on photoswitching and saturation of fluorescence have demonstrated far-field resolution of 20 to 30 nm. In a parallel development, recent progress in metamaterials has demonstrated that artificial optical media can be created, whose use in microscopy can provide resolution that is not determined by the conventional diffraction limit. The resolution of linear immersion microscopes based on such metamaterials is only limited by losses, which can be minimized by appropriate selection of the constituents of the metamaterials used and by the wavelength(s) used for imaging. It is also feasible to compensate for losses by adding gain to the structure. Thus, optical microscopy is quickly moving towards resolution of around 10 nm, which should bring about numerous revolutionary advances in lithography and imaging. [source]