Home About us Contact
|
Home About us Contact | ||
|
|
||
Ionizable Compounds (ionizable + compound)
Selected AbstractsIntegrated microdevice for preconcentration and separation of a wide variety of compounds by electrochromatographyELECTROPHORESIS, Issue 3 2009Gaelle Proczek Abstract An integrated microdevice was developed to couple on-chip SPE to separation by channel electrochromatography. An acrylate-based monolith was synthesized within a glass microdevice by photoinitiated polymerization. It was used for both separation and preconcentration by direct injection on the head of the stationary phase or by confining the preconcentration step in a given zone of the stationary phase. The composition of the polymerization mixture was chosen to achieve a monolithic material containing both hydrophobic and charged moieties to ensure an electroosmotic flow for separation. As a consequence the extraction procedure occurs via hydrophobic and ionic interactions. Neutral, ionizable and charged compounds were successfully preconcentrated and separated within the microdevice through electrochromatographic mechanisms, highlighting the versatility of this device. The performance of the integrated microdevice was demonstrated with the preconcentration and separation of a mixture of PAHs for which a signal enhancement factor (SEF) of 270 was achieved within 120,s of preconcentration. In the case of charged and ionizable compounds, according to the electrolyte composition, contributions of both reverse-phase and ion-exchange mechanisms were used to perform effective electrochromatographic preconcentration. A SEF of 250 was obtained for the model-charged compound within 20,s of preconcentration. Finally, the potentials of on-chip preconcentrate and separate both neutral and ionized compounds have been demonstrated using a mixture of model compounds. [source] The effect of pH and ionic strength on the sorption of sulfachloropyridazine, tylosin, and oxytetracycline to soilENVIRONMENTAL TOXICOLOGY & CHEMISTRY, Issue 4 2006Thomas L. ter Laak Abstract Antimicrobial agents are the most heavily used pharmaceuticals in intensive husbandry. Their usual discharge pathway is application to agricultural land as constituents of animal manure, which is used as fertilizer. Many of these compounds undergo pH-dependent speciation and, therefore, might occur as charged species in the soil environment. Hence, pH and ionic strength of the soil suspension can affect the sorption behavior of these compounds to soil. Consequently, the soil sorption of three antimicrobial agents,sulfachloropyridazine (SCP), tylosin (TYL), and oxytetracycline (OTC),was investigated. Their respective sorption coefficients in two agricultural soils ranged from 1.5 to 1,800 L/kg. Sorption coefficients were greater under acidic conditions. Addition of an electrolyte to the solution led to decreased sorption of TYL and OTC by a factor of 3 to 20, but it did not influence the sorption of SCP. This behavior was analyzed by accounting for the pH-dependent speciation of TYL and OTC and considering the presence of OTC-calcium complexes. It appears that the decreased sorption of TYL and OTC with increasing ionic strength results from competition of the electrolyte cations with the positively charged TYL species and the positively charged OTC complexes. A model linking sorbate speciation with species-specific sorption coefficients can describe the pH dependence of the apparent sorption coefficients. This modeling approach is proposed for implementation in the assessment of sorption of ionizable compounds. [source] Comparison of a miniaturized shake-flask solubility method with automated potentiometric acid/base titrations and calculated solubilitiesJOURNAL OF PHARMACEUTICAL SCIENCES, Issue 1 2005A. Glomme Abstract Solubility is one of the most important parameters for lead selection and optimization during drug discovery. Its determination should therefore take place as early as possible in the process. Because of the large numbers of compounds involved and the very low amounts of each compound available in the early development stage, it is highly desirable to measure the solubility with as little compound as possible and to be able to improve the throughput of the methods used. In this work, a miniaturized shake-flask method was developed and the solubility results were compared with those measured by semiautomated potentiometric acid/base titrations and computational methods for 21 poorly soluble compounds with solubilities mostly in the range 0.03,30 ,g/mL. The potentiometric method is very economical (approximately 100 ,g of a poorly soluble compound is needed) and is able to create a pH/solubility profile with one single determination, but is limited to ionizable compounds. The miniaturized shake-flask method can be used for all compounds and a wide variety of media. Its precision and throughput proved superior to the potentiometric method for very poorly soluble compounds. Up to 20 compounds a week can be studied with one set-up. Calculated solubility data seem to be sufficient for a first estimate of the solubility, but they cannot currently be used as a substitute for experimental measurements at key decision points in the development process. © 2004 Wiley-Liss, Inc. and the American Pharmacists Association J Pharm Sci 94:1,16, 2005 [source] Effect of temperature on the chromatographic retention of ionizable compounds.JOURNAL OF SEPARATION SCIENCE, JSS, Issue 6-7 2008Abstract We propose a general simple equation for accurately predicting the retention factors of ionizable compounds upon simultaneous changes in mobile phase pH and column temperature at a given hydroorganic solvent composition. Only four independent experiments provide the input data: retention factors measured in two pH buffered mobile phases at extreme acidic and basic pH values (e. g., at least ± 2 pH units far from the analyte pKa) and at two column temperatures. The equations, derived from the basic thermodynamics of the acid,base equilibria, additionally require the knowledge of the solute pKa and enthalpies of acid,base dissociation of both the solute and the buffer components in the hydroorganic solvent mixture. The performance of the predictive model is corroborated with the comparison between theoretical and experimental retention factors of several weak acids and bases of important pharmacological activity, in mobile phases containing different buffer solutions prepared in 25% w/w ACN in water and at several temperatures. [source] | |||||||||||||