Home About us Contact
|
Home About us Contact | ||
|
|
||
Gas Production Rate (gas + production_rate)
Selected AbstractsEffect of ,-amylases on dough properties during Turkish hearth bread productionINTERNATIONAL JOURNAL OF FOOD SCIENCE & TECHNOLOGY, Issue 2 2003smail S. Do Summary The effect of ,-amylases from cereal and fungal sources on dough rheological properties was studied. Increasing the enzyme addition level to 160 SKB units (c. 1.1%, fwb) decreased dough stability and increased mixing tolerance indexes. Gas production rates with cereal ,-amylase were higher than that with fungal ,-amylases, indicating more activity during fermentation. A higher adsorption rate occurred with cereal ,-amylase. Dough stability is very important for Turkish hearth bread production, as it is for other hearth breads. Spread ratio tests on fermented doughs showed significant changes in dough rheological properties as a function of ,-amylases. The spread test is a reliable tool for observing rheological changes during fermentation. As a guide, the dough spread ratio should not be more than 2 for desirable bread. [source] Microbial Community Dynamics of a Continuous Mesophilic Anaerobic Biogas Digester Fed with Sugar Beet SilageENGINEERING IN LIFE SCIENCES (ELECTRONIC), Issue 4 2008B. Demirel Abstract The aim of the study was to investigate the long-term fermentation of an extremely sour substrate without any addition of manure. In the future, the limitation of manure and therefore the anaerobic digestion of silage with a very low buffering capacity will be an increasing general bottleneck for energy production from renewable biomass. During the mesophilic anaerobic digestion of sugar beet silage (without top and leaves) as the sole substrate (without any addition of manure), which had an extreme low pH of around 3.3, the highest specific gas production rate (spec. GPR) of 0.72,L/g volatile solids (VS),d was achieved at a hydraulic retention time (HRT) of 25,days compared to an organic loading rate (OLR) of 3.97,g VS/L,d at a pH of around 6.80. The methane (CH4) content of the digester ranged between 58 and 67,%, with an average of 63,%. The use of a new charge of substrate (a new harvest of the same substrate) with higher phosphate content improved the performance of the biogas digester significantly. The change of the substrate charge also seemed to affect the methanogenic population dynamics positively, thus improving the reactor performance. Using a new substrate charge, a further decrease in the HRT from 25 to 15,days did not influence the digester performance and did not seem to affect the structure of the methanogenic population significantly. However, a decrease in the HRT affected the size of the methanogenic population adversely. The lower spec. GPR of 0.54,L/g,VS,d attained on day,15 of the HRT could be attributed to a lower size of methanogenic population present in the anaerobic digester during this stage of the process. Furthermore, since sugar beet silage is a relatively poor substrate, in terms of the buffering capacity and the availability of nutrients, an external supply of buffering agents and nutrients is a prerequisite for a safe and stable digester operation. [source] Modelling and economic analysis of gas production from hydrates by depressurization methodTHE CANADIAN JOURNAL OF CHEMICAL ENGINEERING, Issue 1 2002Santanu Khataniar Abstract Gas production from a hydrate reservoir involves decomposition of the solid hydrate. An analytical model is developed to predict reservoir performance for gas production by the depressurization method from a hydrate reservoir containing associated free gas. The model is developed by combining the intrinsic kinetics of hydrate decomposition, which is of interest to chemical engineers, with gas inflow performance relationship and material balance equations. An economic analysis model is also developed and incorporated with the reservoir performance model. These models are used in a case study of gas production from a hydrate reservoir in the Alaskan North Slope. The results show that gas transportation cost is the main factor controlling feasibility of commercial gas production. The hydrate zone contributes significantly to overall reservoir performance by arresting pressure decline and maintaining gas production rate. La production de gaz à partir d'un réservoir d'hydrates fait intervenir la décomposition d'hydrates solides. On a mis au point un modèle analytique afin de prédire la performance du réservoir pour la production de gaz par la méthode de la dépressurisation à partir d'un réservoir d'hydrates contenant un gaz libre associé. Dans ce modèle, on combine les cinétiques intrinsèques de la décomposition des hydrates, ce qui est intéressant pour les ingénieurs chimistes, avec la relation de performance du débit de gaz et les équations de bilans de matière. Un modèle d'analyse économique a également été élaboré et incorporé au modèle de performance du réservoir. Ces modèles sont utilisés dans une étude de cas sur la production de gaz à partir d'un réservoir d'hydrates du North Slope d'Alaska. Les résultats montrent que le couCt du transport de gaz est le principal facteur qui conditionne la faisabilité de la production commerciale de gaz. La région des hydrates contribue considérablement à la performance globale du réservoir en stoppant la chute de pression et en maintenant la vitesse de production de gaz. [source] Application of a fuzzy logic control system for continuous anaerobic digestion of low buffered, acidic energy crops as mono-substrateBIOTECHNOLOGY & BIOENGINEERING, Issue 3 2009P. Scherer Abstract A fuzzy logic control (FLC) system was developed at the Hamburg University of Applied Sciences (HAW Hamburg) for operation of biogas reactors running on energy crops. Three commercially available measuring parameters, namely pH, the methane (CH4) content, and the specific gas production rate (spec. GPR,=,m3/kg VS/day) were included. The objective was to avoid stabilization of pH with use of buffering supplements, like lime or manure. The developed FLC system can cover most of all applications, such as a careful start-up process and a gentle recovery strategy after a severe reactor failure, also enabling a process with a high organic loading rate (OLR) and a low hydraulic retention time (HRT), that is, a high throughput anaerobic digestion process with a stable pH and CH4 content. A precondition for a high load process was the concept of interval feeding, for example, with 8 h of interval. The FLC system was proved to be reliable during the long term fermentation studies over 3 years in one-stage, completely stirred tank reactors (CSTR) with acidic beet silage as mono-input (pH 3.3,3.4). During fermentation of the fodder beet silage (FBS), a stable HRT of 6.0 days with an OLR of up to 15 kg,VS/m3/day and a volumetric GPR of 9 m3/m3/day could be reached. The FLC enabled an automatic recovery of the digester after two induced severe reactor failures. In another attempt to prove the feasibility of the FLC, substrate FBS was changed to sugar beet silage (SBS), which had a substantially lower buffering capacity than that of the FBS. With SBS, the FLC accomplished a stable fermentation at a pH level between 6.5 and 6.6, and a volatile fatty acid level (VFA) below 500 mg/L, but the FLC had to interact and to change the substrate dosage permanently. In a further experiment, the reactor temperature was increased from 41 to 50°C. Concomitantly, the specific GPR, pH and CH4 dropped down. Finally, the FLC automatically enabled a complete recovery in 16 days. Biotechnol. Bioeng. 2009; 102: 736,748. © 2008 Wiley Periodicals, Inc. [source] | |||||||||||||