Home About us Contact
|
Home About us Contact | ||
|
|
||
Deformation Phase (deformation + phase)
Selected AbstractsDeformation during exhumation of medium- and high-grade metamorphic rocks in the Variscan chain in northern Sardinia (Italy)GEOLOGICAL JOURNAL, Issue 3 2009Rodolfo Carosi Abstract The Anglona and SW Gallura regions represent key places to investigate the tectonic evolution of medium- and high-grade metamorphic rocks cropping out in northern Sardinia (Italy). From south to north we distinguish two different metamorphic complexes recording similar deformation histories but different metamorphic evolution: the Medium Grade Metamorphic Complex (MGMC) and the High Grade Metamorphic Complex (HGMC). After the initial collisional stage (D1 deformation phase), both complexes were affected by three contractional deformational phases (D2, D3 and D4) followed by later extensional tectonics. The D2 deformation phase was the most significant event producing an important deformation partitioning that produced localized shearing and folding domains at the boundary between the two metamorphic complexes. We highlight the presence of two previously undocumented systems of shear belts with different kinematics but analogous orientation in the axial zone of Sardinia. They became active at the boundary between the MGMC and HGMC from the beginning of D2. They formed a transpressive regime responsible for the exhumation of the medium- and high-grade metamorphic rocks, and overall represent a change from orthogonal to orogen-parallel tectonic transport. Copyright © 2008 John Wiley & Sons, Ltd. [source] Tectonics and quaternary evolution of the Northern Apennines watershed area (upper course of Arno and Tiber rivers, Italy)GEOLOGICAL JOURNAL, Issue 1 2009Marco Bonini Abstract This work examines the connection between Quaternary tectonics and erosion/incision processes in the primary Tuscan-Romagna watershed of the Northern Apennines, which essentially coincides with the topographic culmination of the Nero Unit structural ridge. Tectonic and geomorphic information were collected in the area where this ridge is crossed by the upper Tiber River course forming a deep gorge. Structural analysis and field mapping have revealed that the region experienced polyphase tectonics with superposed thrust folding events identifiable both at the map and mesoscopic scales. Hinterland-SSW-verging thrusts and thrust-related folds deformed the whole thrust pile during the latest deformation phase. Backthrusts/backfolds controlled the development of intermountain basins nearby the main watershed during the Early Pleistocene and seemingly deformed, in the Tiber gorge, a low-relief landscape developed in the Early Pleistocene (ca. 1.1,Ma). Successively, the upper Tiber River course area and Apennines axial zone underwent a generalized uplift, which is manifested by the deep incision of palaeo-morphologies. This proposed sequence of events correlates well with the major geodynamic change of the Apennines revealed by an acceleration of uplift rates in the Middle,Late Pleistocene. This latter event may also correlate with increased rates of river incision recorded in Europe as a consequence of uplift and/or climate change. Copyright © 2008 John Wiley & Sons, Ltd. [source] Orogenic Gold Mineralization in the Qolqoleh Deposit, Northwestern IranRESOURCE GEOLOGY, Issue 3 2007Farhang Aliyari Abstract The Qolqoleh gold deposit is located in the northwestern part of the Sanandai-Sirjan Zone, northwest of Iran. Gold mineralization in the Qolqoleh deposit is almost entirely confined to a series of steeply dipping ductile,brittle shear zones generated during Late Cretaceous,Tertiary continental collision between the Afro-Arabian and the Iranian microcontinent. The host rocks are Mesozoic volcano-sedimentary sequences consisting of felsic to mafic metavolcanics, which are metamorphosed to greenschist facies, sericite and chlorite schists. The gold orebodies were found within strong ductile deformation to late brittle deformation. Ore-controlling structure is NE,SW-trending oblique thrust with vergence toward south ductile,brittle shear zone. The highly strained host rocks show a combination of mylonitic and cataclastic microstructures, including crystal,plastic deformation and grain size reduction by recrystalization of quartz and mica. The gold orebodies are composed of Au-bearing highly deformed and altered mylonitic host rocks and cross-cutting Au- and sulfide-bearing quartz veins. Approximately half of the mineralization is in the form of dissemination in the mylonite and the remainder was clearly emplaced as a result of brittle deformation in quartz,sulfide microfractures, microveins and veins. Only low volumes of gold concentration was introduced during ductile deformation, whereas, during the evident brittle deformation phase, competence contrasts allowed fracturing to focus on the quartz,sericite domain boundaries of the mylonitic foliation, thus permitting the introduction of auriferous fluid to create disseminated and cross-cutting Au-quartz veins. According to mineral assemblages and alteration intensity, hydrothermal alteration could be divided into three zones: silicification and sulfidation zone (major ore body); sericite and carbonate alteration zone; and sericite,chlorite alteration zone that may be taken to imply wall-rock interaction with near neutral fluids (pH 5,6). Silicified and sulfide alteration zone is observed in the inner parts of alteration zones. High gold grades belong to silicified highly deformed mylonitic and ultramylonitic domains and silicified sulfide-bearing microveins. Based on paragenetic relationships, three main stages of mineralization are recognized in the Qolqoleh gold deposit. Stage I encompasses deposition of large volumes of milky quartz and pyrite. Stage II includes gray and buck quartz, pyrite and minor calcite, sphalerite, subordinate chalcopyrite and gold ores. Stage III consists of comb quartz and calcite, magnetite, sphalerite, chalcopyrite, arsenopyrite, pyrrhotite and gold ores. Studies on regional geology, ore geology and ore-forming stages have proved that the Qolqoleh deposit was formed in the compression,extension stage during the Late Cretaceous,Tertiary continental collision in a ductile,brittle shear zone, and is characterized by orogenic gold deposits. [source] Tectono-metamorphic history of the Tacagua ophiolitic unit (Cordillera de la Costa, northern Venezuela): Insights in the evolution of the southern margin of the Caribbean PlateISLAND ARC, Issue 1 2007Alessandro Ellero Abstract The southern margin of the Caribbean Plate is well exposed in the Cordillera de la Costa of northern Venezuela, where amalgamated terranes consisting of continental and oceanic units occur. In the Cordillera de la Costa, metamorphosed oceanic units crop out along the coast near Caracas. Among them, the Tacagua unit is characterized by metaserpentinites and metabasites showing mid-oceanic ridge basalt geochemical affinity. These lithologies, representative of a disrupted ophiolite sequence, are associated with metasediments consisting of calcschists alternating with pelitic and psammitic schists, whose protoliths were probably represented by deep-sea hemipelagic and turbiditic deposits. In the Tacagua unit, a polyphase deformation history has been reconstructed, consisting of four folding phases from D1 to D4. Geological setting suggests an involvement of the Tacagua unit in the processes connected with a subduction zone. The following deformations (from D2 to D4) observed in the field might be related to the exhumation history of the Tacagua unit. The late deformation history consists of an alternation of deformation phases characterized by displacement parallel (D2 and D4 phases) and normal (D3 phase) to plate boundary between the Caribbean and South America Plates. All lines of geological evidence suggest that the whole evolution of the Tacagua unit was acquired in a setting dominated by oblique convergence, in which alternation of strike-slip and pure compressional or pure extensional tectonics occurred through time. [source] NEOGENE TECTONIC HISTORY OF THE SUB-BIBANIC AND M'SILA BASINS, NORTHERN ALGERIA: IMPLICATIONS FOR HYDROCARBON POTENTIALJOURNAL OF PETROLEUM GEOLOGY, Issue 2 2007H. L. Kheidri The southern Bibans region in northern Algeria is located in the external zone of the Tell fold-and-thrust belt. Field observations in this area together with seismic data integrated with previous studies provide evidence for a number of Tertiary deformation phases. Late Eocene Atlassic deformation was followed by Oligocene (?)-Aquitanian-Burdigalian compression, which was associated with the development of a foreland basin in front of a southerly-propagating thrust system. Gravity-driven emplacement of the Tellian nappes over the basin margin probably occurred during the Langhian-Serravallian-Tortonian. The Hodna Mountains structural culmination developed during the Miocene-Pliocene. Analysis of brittle structures points to continued north-south shortening during the Neogene, consistent with convergence between the African and Eurasian Plates. The unconformably underlying Mesozoic-Cenozoic autochthonous sequence in this area contains two potential source rock intervals: Cenomanian-Turonian and Eocene. Reservoir rocks include Lower Cretaceous siliciclastics and Upper Cretaceous to Palaeogene carbonates. Structural style has controlled trap types. Thus traps in the Tell fold-and-thrust belt are associated with folds, whereas structural traps in the Hodna area are associated with reactivated normal faults. In the latter area, there is also some evidence for base-Miocene stratigraphic traps. [source] | ||||||||||||||||||||||