			Home About us Contact

Adsorption Chromatography (adsorption + chromatography)

Distribution by Scientific Domains

Chemistry	75%

Selected Abstracts

Volatile oils from leaves and stem barks of Cedrela ,ssilis (Meliaceae): chemical composition and antibacterial activities

FLAVOUR AND FRAGRANCE JOURNAL, Issue 5 2004
João Henrique G. Lago
Abstract The volatile oils from the leaves and stem barks of Cedrela ,ssilis were submitted to GC,MS analysis and separation by adsorption chromatography. The fractions were analysed by GC, 1H- and 13C-NMR as well as GC,MS. The major components found in the leaf oil were , -caryophyllene (26.3%) and bicyclogermacrene (34.6%), while in the stem bark oil the major compounds were , -bisabolene (10.9%) and globulol (10.9%). In an antibacterial assay, only the leaf oil was able to inhibit growth of Staphylococcus aureus and Eschorichia coli. Copyright © 2004 John Wiley & Sons, Ltd. [source]

Analytical, Risk Assessment, and Remedial Implications Due to the Co-Presence of Polychlorinated Biphenyls and Terphenyls at Inactive Hazardous Waste Sites

REMEDIATION, Issue 1 2000
James J. Pagano
Investigations conducted at three inactive hazardous waste sites in New York State have confirmed the co-presence of polychlorinated hiphenyls (PCBs) and polychlorinated terphenyls (PCTs) in soils, sediments, and biota. The PCTs at all three sites were positively identified as Aroclor 5432, with the most probable source being the hydraulic fluid Pydraul 312A utilized for high-temperature applications. The identification of the lower-chlorinated PCT formulations in environmental samples is problematical, since PCT Aroclors 5432 and 5442 are not chromatographically distinct from the higher-chlorinated (PCB) Aroclors 1254, 1260, 1262, and 1268 using conventional gas chromatography,electron capture detection. Results from this study indicate that U.S. Environmental Protection Agency (USEPA) approved PCB methods routinely utilized by most commercial laboratories based on Florisil adsorption column chromatography cleanup are inadequate to produce valid chromatographic separation and quantitative results with soils, sediment, and biota samples containing both PCBs and PCTs. The presence of co-eluting PCBs and PCTs precludes accurate quantitation due to significant differences in PCB/PCT electron capture detector response factors, and the potential for misidentification of PCT Aroclors as higher chlorinated PCB Aroclors. A method based on alumina column adsorption chromatography was used, allowing for the accurate identification and quantitation of PCB and PCT Aroclors. The results of this study suggest that the utilization of alumina adsorption column separation may have applicability and regulatory significance to other industrially contaminated sites which historically used Pydraul 312A. Inferences. [source]

Separation of oil and carotenes from palm oil mill effluent by adsorption chromatography with silica based adsorbent

ASIA-PACIFIC JOURNAL OF CHEMICAL ENGINEERING, Issue 5 2009
A. L. Ahmad
Abstract Malaysia is an agricultural country and the major polluting industrial effluents have been from palm oil industry. Palm oil mill effluent (POME) is a liquid waste which causes a significant impact on the environment if it is not dealt properly. POME contains oil and carotenes that need to be treated before discharge. Owing to the readily available source of POME and growing demand of carotenes, the objective of this paper is to recover the carotenes from POME whilst tackling the environmental problem. In this study, solvent extraction is used to retrieve oil from POME and adsorption chromatography is further adopted to recover the carotenes contained in the oil. Residual oil extracted from POME in this study was about 5000 mg/L in a single stage solvent extraction. The carotenes content in recovered oil was about 450 ppm. Synthetic adsorbent with silica based material was used in the adsorption chromatography. Carotenes was concentrated to about 25 times of the concentration in the recovered oil by adsorption chromatography. Carotenes recovery was found to be depended on the process conditions. Different types of solvent, column temperatures and initial loading volumes were evaluated to determine the effects on the percentage of carotenes extracted and carotenes concentration. The suitable temperature for adsorption process was 40 °C. Carotenes was successfully concentrated from the recovered oil by adsorption chromatography process. Copyright © 2009 Curtin University of Technology and John Wiley & Sons, Ltd. [source]