Home About us Contact
|
Home About us Contact | ||
|
|
||
Adequate Results (adequate + result)
Selected AbstractsResponse: Surgical Resection for Intractable Epilepsy in "Double Cortex" Syndrome Can Yield Adequate ResultsEPILEPSIA, Issue 5 2004Frederick Andermann No abstract is available for this article. [source] A Hertz contact model with non-linear damping for pounding simulationEARTHQUAKE ENGINEERING AND STRUCTURAL DYNAMICS, Issue 7 2006Susendar Muthukumar Abstract This paper investigates the cogency of various impact models in capturing the seismic pounding response of adjacent structures. The analytical models considered include the contact force-based linear spring, Kelvin and Hertz models, and the restitution-based stereomechanical approach. In addition, a contact model based on the Hertz law and using a non-linear hysteresis damper (Hertzdamp model) is also introduced for pounding simulation. Simple analytical approaches are presented to determine the impact stiffness parameters of the various contact models. Parameter studies are performed using two degree-of-freedom linear oscillators to determine the effects of impact modelling strategy, system period ratio, peak ground acceleration (PGA) and energy loss during impact on the system responses. A suite of 27 ground motion records from 13 different earthquakes is used in the analysis. The results indicate that the system displacements from the stereomechanical, Kelvin and Hertzdamp models are similar for a given coefficient of restitution, despite using different impact methodologies. Pounding increases the responses of the stiffer system, especially for highly out-of-phase systems. Energy loss during impact is more significant at higher levels of PGA. Based on the findings, the Hertz model provides adequate results at low PGA levels, and the Hertzdamp model is recommended at moderate and high PGA levels. Copyright © 2006 John Wiley & Sons, Ltd. [source] Limitations of asymmetric parallel-beam geometryJOURNAL OF APPLIED CRYSTALLOGRAPHY, Issue 3 2004N. A. Raftery Bragg diffraction peak profiles and intensities in asymmetric (,,2,) diffraction using a mirror-based parallel-beam geometry were compared with symmetric parallel-beam (,,2,) and conventional Bragg,Brentano (,,2,) diffraction for a powdered quartz sample and the NIST standard reference material (SRM) 660a (LaB6, lanthanum hexaboride). A comparison of the intensities and line widths (full width at half-maximum, FWHM) of these techniques demonstrated that low incident angles (,,<,5°) are preferable for the parallel-beam setup. For higher , values, if 2,,<,2,, mass absorption reduces the intensities significantly compared with the Bragg,Brentano setup. The diffraction peak shapes for the mirror geometry are more asymmetric and have larger FWHM values than corresponding peaks recorded with a Bragg,Brentano geometry. An asymmetric mirror-based parallel-beam geometry offers some advantages in respect of intensity when compared with symmetric geometries, and hence may be well suited to quantitative studies, such as those involving Rietveld analysis. A trial Rietveld refinement of a 50% quartz,50% corundum mixture was performed and produced adequate results. [source] A new method to calculate end-member thermodynamic properties of minerals from their constituent polyhedra I: enthalpy, entropy and molar volumeJOURNAL OF METAMORPHIC GEOLOGY, Issue 3 2005V. J. VAN HINSBERG Abstract The thermodynamic properties of silicate minerals can be described as a linear combination of the fractional properties of their constituent polyhedra. In contrast, given the thermodynamic properties of these polyhedra, the thermodynamic properties of minerals can be estimated, where only the crystallography of the mineral needs to be known. Such estimates are especially powerful for hypothetical mineral end-members or for minerals where experimental determination of their thermodynamic properties is difficult. In this contribution the fractional enthalpy, entropy and molar volume for 35 polyhedra have been determined using weighted multiple linear regression analysis on a data set of published mineral thermodynamic properties. The large number of polyhedra determined, allows calculation of a much larger variety of phases than was previously possible and the larger set of minerals used provides more confident fractional properties. The OH-bearing minerals have been described by partial and total hydroxide coordinated components, which gives better results than previous models and precludes the need of a S,V term to improve estimates of entropy. However, the fractional thermodynamic properties only give adequate results for silicate minerals and double oxides, and should therefore not be used to estimate the properties of other minerals. The thermodynamic properties of ,new' minerals are calculated from a linear stoichiometric combination of their constituent polyhedra, resulting in estimates generally with associated uncertainty of <5%. The quality of such data appears to be of sufficient accuracy for thermodynamic modelling as shown for meta-bauxites from the Alps and the Aegean, where the effect of Zn on the P,T stability of staurolite can be both qualitatively and quantitatively reproduced. [source] Ensemble data assimilation with the CNMCA regional forecasting systemTHE QUARTERLY JOURNAL OF THE ROYAL METEOROLOGICAL SOCIETY, Issue 646 2010Massimo Bonavita Abstract The Ensemble Kalman Filter (EnKF) is likely to become a viable alternative to variational methods for the next generation of meteorological and oceanographic data assimilation systems. In this work we present results from real-data assimilation experiments using the CNMCA regional numerical weather prediction (NWP) forecasting system and compare them to the currently operational variational-based analysis. The set of observations used is the same as the one ingested in the operational data stream, with the exception of satellite radiances and scatterometer winds. Results show that the EnKF-based assimilation cycle is capable of producing analyses and forecasts of consistently superior skill in the root mean square error metric than CNMCA operational 3D-Var. One of the most important issues in EnKF implementations lies in the filter tendency to become underdispersive for practical ensemble sizes. To combat this problem a number of different parametrizations of the model error unaccounted for in the assimilation cycle have been proposed. In the CNMCA system a combination of adaptive multiplicative and additive background covariance inflations has been found to give adequate results and to be capable of avoiding filter divergence in extended assimilation trials. The additive component of the covariance inflation has been implemented through the use of scaled forecast differences. Following suggestions that ensemble square-root filters can violate the gaussianity assumption when used with nonlinear prognostic models, the statistical distribution of the forecast and analysis ensembles has been studied. No sign of the ensemble collapsing onto one or a few model states has been found, and the forecast and analysis ensembles appear to stay remarkably close to the assumed probability distribution functions. Copyright © 2010 Royal Meteorological Society [source] Assessment of sperm quality, DNA integrity and cryopreservation protocols in men diagnosed with testicular and systemic malignanciesANDROLOGIA, Issue 6 2009T. M. Said Summary Men diagnosed with malignancy are often referred for semen banking to preserve their fertility prior to cancer treatment. The chances of cancer patients for achieving future fecundity will be determined by the sperm quality including the integrity of the genomic material in the frozen samples. The objectives of this study were to compare the sperm quality and DNA integrity in men diagnosed with testicular and systemic malignancies before receiving treatment and to identify the optimum cryopreservation protocol for their samples including a remote semen collection option. In comparison with fertile donors, patients with testicular malignancies had significantly lower sperm concentration, while both testicular and systemic malignancy patients had significantly lower sperm motility and cryosurvival rates. In addition, the SCSA defined DNA fragmentation index was significantly higher in patients with testicular and systemic malignancies compared with fertile donors. It was noted that the extent of deterioration in sperm quality and DNA integrity seen in cancer patients did not reach the previously defined statistical threshold for impaired fertility. Freezing spermatozoa with the seminal plasma offers the highest protection against cryo-injury. Nevertheless, remote semen collection can still be used as it yields adequate results. [source] | |||||||||||||