Home About us Contact
|
Home About us Contact | ||
|
|
||
Chinese Loess Plateau (chinese + loess_plateau)
Selected AbstractsConsequences of hyperconcentrated flow for process-based soil erosion modelling on the Chinese Loess PlateauEARTH SURFACE PROCESSES AND LANDFORMS, Issue 9 2006Rudi Hessel Abstract High sediment concentrations in runoff are a characteristic feature of the Chinese Loess Plateau, and are probably caused by factors such as the occurrence of erodible materials on steep slopes, the characteristics of the loess and the harsh climate that results in low plant cover. When sediment concentration increases, fluid density increases, viscosity increases and settling velocity decreases. These effects become increasingly important with increasing concentration and can result in flow behaviour that is quite different from that of clear water flow. Although the net effect of these changes on the flow is not always apparent, erosion models that deal with high sediment concentrations should consider such effects and could include corrections for some of these effects. A case study in a small catchment on the Loess Plateau indicated that sediment concentrations were considerable, and literature data suggested that for such sediment concentrations, corrections for settling velocity, fluid density and viscosity are needed. Furthermore, a number of corrections are necessary to be able to compare field measurements with results of soil erosion models: sediment volume should be subtracted from runoff volume and a density correction is needed to use data from a pressure transducer. For flumes that were used to measure discharge from smaller areas inside the catchment, the measured water level should be corrected by subtracting the sediment level in the flume from the water level, while the sediment volume should also be subtracted from the discharge. Finally, measured concentration should be corrected to give concentration expressed as grams per litre of clear water, since soil erosion models express sediment concentration in this way. Copyright © 2006 John Wiley & Sons, Ltd. [source] A lock-in model for the complex Matuyama-Brunhes boundary record of the loess/palaeosol sequence at Lingtai (Central Chinese Loess Plateau)GEOPHYSICAL JOURNAL INTERNATIONAL, Issue 2 2003S. Spassov SUMMARY In most marine sedimentary records, the Matuyama-Brunhes boundary (MBB) has been found in interglacial oxygen isotope stage 19. In the magnetostratigraphic records of most Chinese loess/palaeosol profiles the MBB is located in loess layer L8, which was deposited during a glacial period. The MBB at Lingtai (central Chinese Loess Plateau) also occurs in L8 and is characterized by multiple polarity flips. The natural remanent magnetization is mainly carried by two coexisting components. The higher coercivity (harder) component dominates in loess layers and is thought to be of detrital origin. The lower coercivity (softer) component prevails in palaeosols and was most probably formed in situ by (bio-)chemical processes. A lock-in model for the Lingtai MBB record has been developed by extending the lithologically controlled PDRM model of Bleil & von Dobeneck (1999). It assumes two lock-in zones. The NRM of the magnetically harder component is physically locked by consolidation shortly after loess deposition, whereas the softer component is formed at greater depth by pedogenesis and acquires a chemical remanent magnetization of younger age. At polarity boundaries, grains carrying reversed and normal directions may therefore occur together within a single horizon. The model uses ARM coercivity spectra to estimate the relative contributions of the two components. It is able to explain the observed rapid multiple polarity flips and low magnetization intensities as well as the stratigraphic shift of the Lingtai MBB with respect to the marine records. [source] Environmental change and cultural response between 8000 and 4000 cal. yr BP in the western Loess Plateau, northwest ChinaJOURNAL OF QUATERNARY SCIENCE, Issue 6 2004ChengBang An Abstract Two ancient swamps in the western Loess Plateau, northwest China record the climate history between 8000 and 4000 cal. yr BP. Grain size, CaCO3, organic matter, mollusc fauna and pollen assemblages show that climate was wet between 8300 and 7400 cal. yr BP, distinctly humid and warm between 7400 and 6700 cal. yr BP, semi-humid from 6700 to 6300 cal. yr BP, and semi-arid between 6300 and 4000 cal. yr BP. The temporal and spatial distribution of archaeological sites shows that the prosperity of the neolithic cultures in the western part of the Chinese Loess Plateau did not appear until the climate changed to semi-arid, implying that the semi-arid climate was more favourable than wet and humid climate to neolithic peoples, whose subsistence was based on cereals adapted to arid environments. Copyright © 2004 John Wiley & Sons, Ltd. [source] | ||||||||||